Download Mutation and selection within the individual

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Document related concepts

Polymorphism (biology) wikipedia , lookup

Site-specific recombinase technology wikipedia , lookup

Oncogenomics wikipedia , lookup

Gene therapy of the human retina wikipedia , lookup

Koinophilia wikipedia , lookup

Designer baby wikipedia , lookup

Genetic drift wikipedia , lookup

Epistasis wikipedia , lookup

Frameshift mutation wikipedia , lookup

NEDD9 wikipedia , lookup

Group selection wikipedia , lookup

Mutation wikipedia , lookup

Microevolution wikipedia , lookup

Population genetics wikipedia , lookup

Point mutation wikipedia , lookup

Transcript
515
Figure 3. The probability of fixation of a single mutation that occurs
once during development. In the absence of cell-lineage selection
(1 = 2sI ; c = 2sc = 0), the initial fraction of mutant gametes
in the population is p0 = Pneutral /(2N) with Pneutral given by equation
(A3); the solid curve shows the fixation probability obtained from
equation (3) using this value for p0 . With cell-lineage selection acting
only in the generation in which the mutation appears (c = I =
2sc = 2sI ), p0 becomes P/(2N) with P given by equation (A2);
the probability of fixation is then shown by long dashed curves. If
cell-lineage selection acts in subsequent generations to change k as
well as p0 , the fixation probability is hardly affected unless n1 is
large (short dashed curves). The population size, N, was assumed to
be large relative to selection (Nsc >> 1). Note that the ordinate is
scaled to Pneutral , the proportion of cells within the adult individual
that are expected to carry a new mutation in the absence of celllineage selection.
(iii) Simulation results
We verified the results obtained in Appendices A-C by
simulating the two models explored within this paper,
that of an exponentially growing population of cells
and of a constant-sized population of cells. The first
series of simulations assumed that development occurs
by a series of binary cell divisions, with the rate of cell
division determined by a cell’s genotype. Mutations
and/or mitotic recombination occurred randomly during each cell division. A run was terminated once the
individual had ‘developed’, i.e., after an appropriate
number of cell divisions. This process was repeated
10,000 times (100,000 times for Figure 1B), and the
results are shown as dots in Figures 1, 2. The initial
zygotic cell was wild-type in Figure 1 and heterozygous in Figure 2. The simulations coincide extremely
well with the theoretical predictions.
In the second series of simulations, we tracked a
population of cells that underwent birth and death such
that the total population size remained constant. For
this model, the transmission parameter k can be estimated analytically by assuming an infinite population
of cells as in Appendix C (equation A15). In an individual, however, the number of cells will always be finite.
To assess the importance of this difference, we used
simulations with a total number of cells, , varying
from 100 to 10,000. Each of these cells underwent, on
average, n cell divisions per individual generation. We
ignored events that occurred during the initial expansion of the proto-germline leading to the population of
cells, but followed mutations and conversions that
occurred during the rest of the lifespan. During this
second phase, a single cell was chosen at random to
die and was replaced by the daughter of a randomly
chosen cell (a birth-death model). This was repeated
times every cell generation, for a total of n times
every individual generation. The chance that a cell was
selected to replicate was determined by its frequency
times its relative fitness, divided by the mean fitness of
all cells. Every offspring cell so produced was subjected to mutation and gene conversion at the appropriate
rates.
The results shown in Figure 4 demonstrate that
equation A15 provides an accurate estimate for k
only when the size of the population of cells is large
( 10,000). For smaller numbers of cells, k may
be significantly closer to 1/2 than predicted. Although
expressed in terms of advantageous alleles, the results
also hold for the elimination of deleterious mutations
whose transmission is 1 - k. As can be seen in Figure 4a-d, individuals tend to produce either 100% A
alleles or the normal Mendelian ratio, although this
is due in part to the parameters chosen (i.e., fairly
strong selection with fitnesses of 1, 1.1, and 1.2 for
aa, Aa, and AA cells, respectively). Because selection
is quite strong, the spread of AA cells throughout the
germline population of cells is rapid once an AA cell has
been created. Increasing the number of cells within the
germline (Figure 4) or decreasing the strength of selection results in the AA genotype taking longer to spread
through the germline, and more individuals transmit
A alleles with values between 50% and 100% (Figure 4). The observation of intermediate values of k is
probably more realistic and is more consistent with the
observation of mosaics noted previously (Woodruff &
Thompson, 1992, and refs. therein). If, however, selection is strong as in the simulations, an approximation
for the average transmission ratio, k’, may be found for
a finite population of cells (Appendix D). This enables
us to illustrate the effects of increasing cell lineage
number on k’ and on the fixation probability assuming no selection at the individual level (Figure 4e).
Although this only applies to strongly selected alleles,
it has the advantage of clearly showing the benefits and
gene440.tex; 26/05/1998; 16:16; v.7; p.9