* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Download Lab3: DC-DC Boost Converter
Solar micro-inverter wikipedia , lookup
Spark-gap transmitter wikipedia , lookup
Stepper motor wikipedia , lookup
Immunity-aware programming wikipedia , lookup
Power engineering wikipedia , lookup
Electrical ballast wikipedia , lookup
Three-phase electric power wikipedia , lookup
Power inverter wikipedia , lookup
Analog-to-digital converter wikipedia , lookup
Current source wikipedia , lookup
History of electric power transmission wikipedia , lookup
Pulse-width modulation wikipedia , lookup
Electrical substation wikipedia , lookup
Resistive opto-isolator wikipedia , lookup
Variable-frequency drive wikipedia , lookup
Amtrak's 25 Hz traction power system wikipedia , lookup
Distribution management system wikipedia , lookup
Power MOSFET wikipedia , lookup
Surge protector wikipedia , lookup
Alternating current wikipedia , lookup
Integrating ADC wikipedia , lookup
Stray voltage wikipedia , lookup
Schmitt trigger wikipedia , lookup
Voltage regulator wikipedia , lookup
Voltage optimisation wikipedia , lookup
Opto-isolator wikipedia , lookup
Mains electricity wikipedia , lookup
San José State University College of Engineering/Electrical Engineering EE174: Analog Peripheral for Embedded Systems Section 01, Spring 2017 LAB3 DC-DC Converter Boost Converter Switched mode supplies can be used for many purposes including DC to DC converters. Often, although a DC supply, such as a battery may be available, its available voltage is not suitable for the system being supplied. For example, the motors used in driving electric automobiles require much higher voltages than could be supplied by a battery alone. The answer to this problem is to use fewer batteries and to boost the available DC voltage to the required level by using a boost converter. The DC input to a boost converter can be from many sources as well as batteries, such as rectified AC from the mains supply, or DC from solar panels, fuel cells, dynamos and DC generators. Fig. 3.2.1 illustrates the basic circuit of a Boost converter. However, in this example the switching transistor is a power MOSFET, both Bipolar power transistors and MOSFETs are used in power switching, the choice being determined by the current, voltage, switching speed and cost considerations. The rest of the components are the same as those used in the buck converter illustrated in Fig 8 below, except that their positions have been rearranged. VOUT = VIN / (1 – D) Boost converter Operation Required Task: Build the Boost converter circuit using Microchip MC34063 as shown above Obtain the Line Regulation: Vary the input voltage from 3.5V to 4.0V and plot the output voltage as the function of the input voltage for a constant output load. Configure the on board evaluation module to generate a regulated output voltage of 5V, observe and capture the waveforms mentioned in Figure 9 above and compare with the simulation results. Vary the input voltage for a regulated output voltage of 5V and observe the change in the duty cycle of the PWM waveform. Use Table below to record the readings. Compare the readings with simulation results and plot the graph between the input voltage and duty cycle. Is the plot linear? Vary the input voltage for a fixed load and observe the output voltage. Use Table below for taking the readings for line regulation Observe the inductor voltage and output voltage. Observe output ripple voltage. Conclusion of the lab. References: http://www.learnabout-electronics.org/PSU/psu32.php http://www.ti.com/lit/an/slva252b/slva252b.pdf http://www.electroschematics.com/12172/uc-li-ion-power-bank-w-mc34063/