Download PowerPoint 演示文稿

Lesson 24
Switchboard
(配电板)
Jimei university
The control and distribution of
the electrical energy generated
by generators are effected by
power distribution equipment,
i.e. switchboards.
Jimei university
Switchboards are either:
(a) Main switchboards(主配电
盘 ), to which the main
generators are connected,
Jimei university
(b) Emergency switchboards(应
急 配 电 盘 ), to which the
emergency
generator
or
emergency battery is connected,
Jimei university
(c) Section boards (or Subboards(区域配电板))or
(d) Distribution boards(分配电
板或箱).
Jimei university
In
small
equipment,
particularly in small cargo
ships, most of the motors can
be fed directly from the main
switchboard,
Jimei university
but
as
the
size
and
multiplicity(多样性) of services
increase, it becomes necessary
to reduce the number of
outgoing( 引 出 的 ) circuits on
the main board.
Jimei university
This is done by grouping some
services on one or more section
boards (sometimes referred to
as sub-boards), supplied by a
feeder(馈线、馈电板) from the
main board.
Jimei university
Still further splitting up(分解)
particularly in the case of
lighting and heating, is usually
necessary and
Jimei university
and this takes the form of
distribution boards of small
capacity which may be fed
either direct from the main
board or from a section board.
Jimei university
Generators
Main switchboard
Motor
Motors
G1
Section/sub board
Lighting
G2
Distribution board
Bar-bus
Transformer
E. Generator
E. Lighting
E. switchboard
Jimei university
Switchboard are divided into
two classes: i.e. those for a.c.
systems and those for d.c.
systems.
Jimei university
Switchboards may be of the
open type in which all the
essential switch gears(开关设备、
交 换 机 ) are exposed on the
front of the panel(仪表盘, 控
制面板),
Jimei university
or of the deadfront type(正面无接
线 式 、 不 带 电 式 、 安 全 式 ) in
which all the live(带电的) parts
are installed behind the panels and
only the operating handles and
instruments are on the front.
Jimei university
The switchboards for a.c.
systems differ from the d. c.
switch gear in that the open
type panels are generally not
permissible.
Jimei university
Deadfront boards can be either
of two patterns,
Jimei university
one having manually-operated
switches
and
circuitbreakers( 断 路 器 ) with the
handles on the front of panels
and all the live(带电的) parts
at the rear;
Jimei university
and
the
other
having
electrically operated circuitbreakers operated by pushbuttons on the front of the
panels.
Jimei university
Usually
the
panels
are
interlocked with isolators(绝缘
子 、 隔 离 开 关 ) so that the
devices can be made dead(不带
电 的 ) before the doors are
opened.
Jimei university
The voltages most commonly
adopted for a.c. systems are
either 440V or 220V threephase.
Jimei university
For d.c. switchboards, there are
ammeters,
voltmeters,
circuitbreakers,
tipping
devices(跳闸装置) and so on,
Jimei university
but a.c. requires additional
equipment as compared with
d.c., such as frequency meters,
synchroscope, wattmeters,
Jimei university
voltage
and
current
transformers(电压互感器和电
流 互 感 器 ), ammeter
switches( 安 培 表 的 转 换 开 关 ),
voltage regulators(稳压器、电
压调节器), etc..
Jimei university
Circuit breakers and switches
will be three-pole as compared
with two-pole for d.c..
Jimei university
However, in spite of the
additional equipment an a.c.
switchboard is usually smaller
and
lighter
than
the
corresponding( 相 应 的 ) d.c.
board
Jimei university
because of the higher voltage
and lower currents and smaller
bus-bars(母排、汇流排), etc.
Jimei university
Electrical supply is always
needed, even if only for lighting.
Jimei university
So after a ship goes into service
it is extremely rare for the main
bus-bars to be made dead,
Jimei university
it therefore follows that the
bus-bars
are
continuously
alive( 带 电 的 ) throughout the
life of the ship.
Jimei university
Even when in a shipyard for
repair, a shore supply will
usually be taken.
Jimei university
Reading Materials
A. Emergency
Generator supply
Jimei university
In the event of a main
generating system failure an
emergency supply of electricity
is required for essential services.
Jimei university
This can be supplied by
batteries, but most merchant
ships have an emergency
generator.
Jimei university
The unit is diesel driven and
located
outside
of
the
machinery space.
Jimei university
The emergency generator must
be rated to provide power for
the driving motors of
Jimei university
of the emergency bilge pump,
fire pumps, steering gear,
watertight doors and possibly
fire fighting equipment.
Jimei university
Emergency
lighting
for
occupied areas( 居 住 区 ),
navigation lights( 航 行 灯 ),
communications systems and
alarm systems must also be
supplied.
Jimei university
Where
electrical
control
devices are used in the
operation of main machinery,
these too may require a supply
from the emergency generator.
Jimei university
Usually only one emergency
switchboard is installed;
Jimei university
however, for safety reasons
large passenger vessels may
have two emergency sources of
power, thus requiring two
emergency switchboards.
Jimei university
Emergency
switchboards
normally consist of a generator
control panel, a bus tie and
distribution panel (汇电板和配
电盘) and
Jimei university
and 24-volt, 120-volt, and 450volt distribution panels in size
and number as required.
Jimei university
Emergency
generator
switchboards include those
devices noted in the foregoing
for
main
switchboard
generator control panel plus
the following:
Jimei university
1. A white light to indicate that
the
normal
supply
is
available.
2. A green light to indicate
that all devices are “set up”
for automatic
operation.
Jimei university
3. A normal supply circuit
breaker, unless the automatic
bus transfer(主送电器) is of the
contactor type.
Jimei university
4. A feed back switch when the
automatic bus transfer is of the
contactor type.
Jimei university
It is not usual for an emergency
generator to require paralleling,
so no equipment is provided for
this purpose.
Jimei university
Automatic start up of the
emergency generator at a low
voltage value is usual on
modern installations.
Jimei university
B. Maintenance of electrical
equipments
Jimei university
With all types of electrical
equipment
cleanliness
is
essential for good operation.
Jimei university
Electrical connections must be
sound( 完 好 的 ， 可 靠 的 ) and
any signs of sparking should be
investigated.
Jimei university
Parts subject to wear must be
examined and replaced when
necessary.
Jimei university
The
danger
from
a.c.
equipment in terms of electric
shocks(触电) is far greater than
for similar d.c. voltages.
Jimei university
Also a.c. equipment often
operates at very high voltages.
Jimei university
Care must therefore be taken to
ensure isolation of equipment
before any inspections or
maintenance is undertaken.
Jimei university
The accumulation of dirt on
electrical equipment will result
in insulation breakdown and
leakage currents, possibly even
an earth fault.
Jimei university
Moisture or oil deposits will
likewise( 同 样 地 ) affect
insulation resistance.
Jimei university
Regular insulation resistance
measurement
and
the
compiling(汇集) of records will
indicate( 预 示 ) the equipment
requiring attention.
Jimei university
Ventilation passages or ducts
may become blocked, with
resultant lack of cooling and
overheating.
Jimei university
Oil deposits from a direct
coupled diesel engine driving an
open generator can damage
windings and should therefore
be removed if found.
Jimei university
Totally
enclosed machines
should be periodically opened
for inspection and cleaning
since carbon dust will remain
inside the machine and deposit
on the surfaces.
Jimei university
Brushgear should be inspected
to ensure adequate brush
pressure and the springs
adjusted if necessary.
Jimei university
New brushes should be ‘bedded
in(研配)’ to the commutator(整
流 子 ， 换 向 器 ) or slipring
shape with fine glass paper(精
细玻璃砂纸).
Jimei university
Sparking at the commutator
will
indicate
poor
commutation(换向、整流).
Jimei university
This may require polishing of a
roughened( 粗 糙 的 )
commutator surface.
Jimei university
The mica( 云 母 ) insulation
between
commutator
segments( 换 向 片 、 整 流 片 )
may require undercutting(剔槽)
if it protrudes(凸出), or simply
cleaning if deposits have built
Jimei university
up.
Control equipment, such as
starters, will require attention
to contacts which may be worn
or pitted(有凹痕的) as a result
of arcing(电弧放电).
Jimei university
Contactors( 接 触 器 ， 触 头 )
usually have a moving or
wiping( 磨 擦 ) action as they
come together.
Jimei university
This helps clean the surfaces to
provide good electrical contact,
and also the arc produced
during closing and opening is
not at the finally closed position.
Jimei university
The contactor contact surfaces
of frequently used equipment
should therefore be subject to
regular inspections.
Jimei university