Download Physiological Effects of Electricity on Human Body

Document related concepts

Loudspeaker enclosure wikipedia , lookup

Ground loop (electricity) wikipedia , lookup

Electromagnetic compatibility wikipedia , lookup

Telecommunications engineering wikipedia , lookup

Ohm's law wikipedia , lookup

Skin effect wikipedia , lookup

Rectiverter wikipedia , lookup

Stray voltage wikipedia , lookup

Mains electricity wikipedia , lookup

Alternating current wikipedia , lookup

Residual-current device wikipedia , lookup

Portable appliance testing wikipedia , lookup

Electrical wiring in the United Kingdom wikipedia , lookup

Ground (electricity) wikipedia , lookup

Earthing system wikipedia , lookup

Transcript
Physiological Effects of
Electricity on Human Body
by
Mohd Yusof Baharuddin
Objectives
Describe and explain on the
accumulation of data from variety
of sources has established the
effect of alternating electrical
currents (frequency 50-60 Hz).
Discuss the leakage current
Are you aware ???
Introduction
Electrical current which passing
through human body will caused:
Injuries to tissue - burns
Muscle stimulation – uncontrollable
muscle contraction or unconsciousness
Fibrillation of the heart
Effect of 60 Hz electric Shock
(Current) through body
Current Intensity
Effect
1 mA
Threshold of perception
5 mA
Accepted as maximum
harmless current intensity
10 - 20 mA
100 - 300 mA
6A
Pain. Possible fainting,
exhaustion, mechanical injury,
heart & respiratory functions
continue
Ventricular fibrillation will
start but respiratory center
remains intact
Sustained myocardial
contraction followed by
normal heart rhythm.
Temporary respiratory
paralysis. Burns if current
density is high
Larger currents are required to cause
death from macroshock as skin is
relatively good insulator
These currents range from 1mA
(threshold of sensation) to 10 mA (can’t
let go) to 100 mA (respiratory failure
and ventricular fibrillation-death)
In contrast, microshock currents of 10100 uA can cause ventricular fibrillation
& death.
Frequency of the current
For example, an arm to arm shock @
50-60 Hz is particularly potent
compared to higher or lower frequency.
However if the frequency is increased
above 1 kHz, these current levels no
longer produce such sensations or life
threatening phenomena.
High frequency in MHz will caused
serious burn than shock. Relates to
electrosurgical unit.
Class I Equipment
Class I equipment has a protective earth. The
basic means of protection is the insulation
between live parts and exposed conductive parts
such as the metal enclosure.
In the event of a fault that would otherwise cause
an exposed conductive part to become live, the
supplementary protection (i.e. the protective earth)
comes into effect.
A large fault current flows from the mains part to
earth via the protective earth conductor, which
causes a protective device (usually a fuse) in the
mains circuit to disconnect the equipment from the
supply.
Class I Equipment
It is important to realize that not all
equipment having an earth connection is
necessarily Class I.
The earth conductor may be for functional
purposes only such as screening. In this
case the size of the conductor may not be
large enough to safely carry a fault current
that would flow in the event of a mains
short to earth for the length of time required
for the fuse to disconnect the supply.
Class I Equipment
Class I medical electrical equipment should have
fuses at the equipment end of the mains supply
lead in both the live and neutral conductors, so
that the supplementary protection is operative
when the equipment is connected to an incorrectly
wired socket outlet.
Further confusion can arise due to the use of
plastic laminates for finishing equipment. A case
that appears to be plastic does not necessarily
indicate that the equipment is not class I.
There is no agreed symbol in use to indicate that
equipment is class I and it is not mandatory to
state on the equipment itself that it is class I.
Where any doubt exists, reference should be
made to equipment manuals.
Class II Equipment
The method of protection against electric
shock in the case of class II equipment is
either double insulation or reinforced
insulation.
In double insulated equipment the basic
protection is afforded by the first layer of
insulation. If the basic protection fails then
supplementary protection is provided by a
second layer of insulation preventing
contact with live parts.
Class II Equipment
In practice, the basic insulation may be afforded by
physical separation of live conductors from the
equipment enclosure, so that the basic insulation
material is air. The enclosure material then forms
the supplementary insulation.
Reinforced insulation is defined in standards as
being a single layer of insulation offering the same
degree of protection against electric shock as
double insulation.
Class II medical electrical equipment should be
fused at the equipment end of the supply lead in
either mains conductor or in both conductors if the
equipment has a functional earth.
Class III Equipment
Class III equipment is defined in some
equipment standards as that in which
protection against electric shock relies on
the fact that no voltages higher than safety
extra low voltage (SELV) are present.
SELV is defined in turn in the relevant
standard as a voltage not exceeding 25V
ac or 60V dc.
In practice such equipment is either battery
operated or supplied by a SELV
transformer.
Class III Equipment
If battery operated equipment is capable of
being operated when connected to the
mains (for example, for battery charging)
then it must be safety tested as either class
I or class II equipment.
Similarly, equipment powered from a SELV
transformer should be tested in conjunction
with the transformer as class I or class II
equipment as appropriate.
Class III Equipment
It is interesting to note that the current IEC
standards relating to safety of medical
electrical equipment do not recognize
Class III equipment since limitation of
voltage is not deemed sufficient to ensure
safety of the patient.
All medical electrical equipment that is
capable of mains connection must be
classified as class I or class II. Medical
electrical equipment having no mains
connection is simply referred to as
"internally powered".
Causes of leakage current
If any conductor is raised to a potential
above that of earth, some current is bound
to flow from that conductor to earth. This is
true even of conductors that are well
insulated from earth, since there is no such
thing as perfect insulation or infinite
impedance. The amount of current that
flows depends on:
the voltage on the conductor.
the capacitive reactance between the conductor
and earth.
the resistance between the conductor and earth.
Earth Leakage Current
Earth leakage current is the current that normally flows in the
earth conductor of a protectively earthed piece of equipment.
In medical electrical equipment, very often, the mains is
connected to a transformer having an earthed screen.
Most of the earth leakage current finds its way to earth via
the impedance of the insulation between the transformer
primary and the inter-winding screen, since this is the point
at which the insulation impedance is at its lowest
Earth Leakage Current
Under normal conditions, a person who is in
contact with the earthed metal enclosure of the
equipment and with another earthed object would
suffer no adverse effects even if a fairly large earth
leakage current were to flow.
This is because the impedance to earth from the
enclosure is much lower through the protective
earth conductor than it is through the person.
However, if the protective earth conductor
becomes open circuited, then the situation
changes.
Now, if the impedance between the transformer
primary and the enclosure is of the same order of
magnitude as the impedance between the
enclosure and earth through the person, a shock
hazard exists.
Earth Leakage Current
It is a fundamental safety requirement that in
the event of a single fault occurring, such as
the earth becoming open circuit, no hazard
should exist.
It is clear that in order for this to be the case in
the above example, the impedance between
the mains part (the transformer primary and so
on) and the enclosure needs to be high.
This would be evidenced when the equipment
is in the normal condition by a low earth
leakage current. In other words, if the earth
leakage current is low then the risk of electric
shock in the event of a fault is minimized.
Enclosure Leakage Current
The terms "enclosure leakage current" and "touch
current" should be taken to be synonymous.
Enclosure leakage current is defined as the
current that flows from an exposed conductive part
of the enclosure to earth through a conductor
other than the protective earth conductor.
Enclosure Leakage Current
If a protective earth conductor is connected to the
enclosure, there is little point in attempting to
measure the enclosure leakage current from
another protectively earthed point on the
enclosure, since any measuring device used is
effectively shorted out by the low resistance of the
protective earth.
Equally, there is little point in measuring the
enclosure leakage current from a protectively
earthed point on the enclosure with the protective
earth open circuit, since this would give the same
reading as measurement of earth leakage current
as described above.
Enclosure Leakage Current
For these reasons, it is usual when testing
medical electrical equipment to measure
enclosure leakage current from points on
the enclosure that are not intended to be
protectively earthed.
On many pieces of equipment, no such
points exist. This is not a problem. The test
is included in test regimes to cover the
eventuality where such points do exist and
to ensure that no hazardous leakage
currents will flow from them.
Patient Leakage Current
Patient leakage current is the leakage current
that flows through a patient connected to an
applied part or parts. It can either flow from the
applied parts via the patient to earth or from an
external source of high potential via the patient
and the applied parts to earth.
Patient Auxiliary Current
The patient auxiliary current is defined as the
current that normally flows between parts of the
applied part through the patient, which is not
intended to produce a physiological effect
Summary
Currents Intensity
1mA (threshold of sensation) to 10 mA (can’t let
go) to 100 mA (respiratory failure and ventricular
fibrillation-death)
Type of Class – Class I, II & III
Type of equipment – B, BF & CF
Leakage Current
Earth leakage current
Enclosure leakage current
Patient leakage current
Patient auxiliary current