Survey
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Crossbar switch wikipedia , lookup
Gender of connectors and fasteners wikipedia , lookup
Opto-isolator wikipedia , lookup
Electrical connector wikipedia , lookup
Rectiverter wikipedia , lookup
LCD television wikipedia , lookup
Printed circuit board wikipedia , lookup
ETag board: Back side, towards MICAz. Push buttons. Photo-interrupters. About 1mm over the board edge. • Current limiter resistor for photodiodes. Jonathan suggested 330 Ohm, I made one up from two pieces. Push area: 1.5mm high and 2mm wide. Push distance: tiny (under a mm) • Switch-on transistor DigiKey data: 401-1101-1-ND SWITCH TACT 250GF GULL SMT • Phototransistor load resistors for the two “Right” photo interrupters (installed 470K, adjust as needed) Bypass capacitor for the pulseox sub board Resistor: 0 Ohm. Enables power-on for the Pulseox sub board. Can be removed and a switch transistor installed so that the pulseox sub board power is enabled from software. 51pin connector to MICAz. ETag board: Back side, towards MICAz. Place for LCD contrast potentiometer (not a user control, but just for adjustments) Connectors to the Pulseox sub board Two photo interrupters: TR and BR (top-right and bottom-right) Pulseox sensor / RS232 serial connector LCD (version 1b board does not support LCD, version 1c does). LEDs LED switch components RS232 level conversion circuit, not populated (alternative option to the Pulseox sub board feature) Two photo interrupters: TL and BL (top-left and bottom-left) Photo transistor load resistors for the two “Left” photo interrupters (installed 470K, adjust as needed)