Download DSL Line Conditioners DSL Test Kits

DSL Line Conditioners
DSL Test Kits
Description
The Suttle DSL Test Unit allows for an active DSL line to be tested
for POTS (voice) verifcation without interfering with the DSL
connection. The hand-held device has an RJ-14 modular jack
for the input connection. The input can be made with a doubleended modular cord or with a universal test cord equipped
with a modular plug on one end and test clips on the other as
used with a typical Butt set. The connection for the testing is
provided with the two RJ-14 modular jacks. The DSL non-filtered
jack is labeled “Non-Filtered”. The POTS port is labeled “Filtered”.
Connections for testing can also be made through the test access
point terminals for use with alligator clips along each side of the
product.
Electrical Specifications
Features
DC Loop Current 0 to 100ma
DC Voltage 0 to -60VDC(tip to ring)
DC Resistance <30 ohms (POTS tip to ring line port shorted)
Tip to Ring Capacitance
(POTS Port) <115nf
ADSL Band Attenuation
30 kHz - 1104 kHz >50 dB
Insertion Loss
At 1 kHz <1 dB
Insertion Loss Distortion <1.5 dB
Delay Distortion < 200usec
Return Loss
ERL >6dB
SRL Lo >5dB
SRL Hi >3dB
Product Information
Suttle
Part Number
Description
DSLTEST-1
DSL test unit
DSLTESTKIT7
DSL test unit with 7ft. test cord
DSLTESTCORD7
7ft. test cord
■■
■■
Provides testing without interfering with the DSL Connection
Available with Test Cords of varying length
DSL Line Conditioners
DSL Test Kits
DSL Test Kit
The Suttle DSL test unit allows an active DSL service line to be tested for POTS (voice)
verification without interfering with the DSL service.
Not Filtered signal.
Connect DSL test set
to the DSL test unit using
alligator clips or RJ-11
modular plug
Network In Wall Jack
Connect this port to the premise
wiring using either the supplied
test cord with alligator clips
or a length of cord with RJ-11
modular plugs
Filtered DSL signal.
Connect butt test set to
the DSL test unit using
alligator clips or RJ-11
modular plug
Simply attach the filter to your existing Butt test set to modernize its capabilities.
Do this by plugging your Butt set into the modular jack that is marked Filtered DSL.
Use your Butt test set as you would normally use it to test telephone equipment.
The second Not Filtered output jack is provided to attach a DSL test set, for network
performance monitoring.
DO NOT plug your Butt set into the Not Filtered jack.
Specifications subject to change without notice. Copyright 2014.
2160414
1001 East Highway 212 • Hector, MN USA 55342 • suttlesolutions.com
Toll Free: 1 (800) 852-8662 • Local: (320) 848-6711 • Fax: (320) 848-6218