Survey

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Document related concepts

Power factor wikipedia , lookup

Rectifier wikipedia , lookup

Opto-isolator wikipedia , lookup

Memristor wikipedia , lookup

Wireless power transfer wikipedia , lookup

Power inverter wikipedia , lookup

Transistor wikipedia , lookup

Electrification wikipedia , lookup

Ohm's law wikipedia , lookup

Immunity-aware programming wikipedia , lookup

Islanding wikipedia , lookup

Ground (electricity) wikipedia , lookup

Electrical substation wikipedia , lookup

History of electric power transmission wikipedia , lookup

Electrical ballast wikipedia , lookup

Electric power system wikipedia , lookup

Mains electricity wikipedia , lookup

Power over Ethernet wikipedia , lookup

Buck converter wikipedia , lookup

Circuit breaker wikipedia , lookup

Power electronics wikipedia , lookup

Two-port network wikipedia , lookup

TRIAC wikipedia , lookup

Switched-mode power supply wikipedia , lookup

Power engineering wikipedia , lookup

Surge protector wikipedia , lookup

Current source wikipedia , lookup

Current mirror wikipedia , lookup

Residual-current device wikipedia , lookup

RLC circuit wikipedia , lookup

Alternating current wikipedia , lookup

Earthing system wikipedia , lookup

Network analysis (electrical circuits) wikipedia , lookup

Transcript
```Problem ＃1
If the interconnection in the Figure is valid, find the total power developed in the
circuit. If the interconnection is not valid, explain why.
Solution:
Problem #2
A variety of current source values were applied to the device shown in the Figure.
The power absorbed by the device for each value of current is recorded in the
Table. Use the values in the table to construct a circuit model for the device
consisting of a single element.
Problem #3 The voltage and current were measured at the terminals of the device shown in the
Figure. The results are shown in the Table.
a) Construct a circuit model for this device using an ideal current source and a
resistor.
b) Use the model to predict the amount of power the device will deliver to a 20Ω
resistor.
Solution:
Problem #4
The current io in the following circuit is 1 A.
a)
b)
Find the power dissipated in each resistor.
Verify that the total power dissipated in the circuit equals the power
developed by the 150 V source.
Solution:
Problem #5 Find (a) io, (b) i1 and (c) i2 in the following circuit.
Solution:
```
Related documents