* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Download chris - Ece.umd.edu
Power engineering wikipedia , lookup
Mathematics of radio engineering wikipedia , lookup
Spark-gap transmitter wikipedia , lookup
Wireless power transfer wikipedia , lookup
Mains electricity wikipedia , lookup
Resistive opto-isolator wikipedia , lookup
Variable-frequency drive wikipedia , lookup
Alternating current wikipedia , lookup
Buck converter wikipedia , lookup
Spectral density wikipedia , lookup
Power inverter wikipedia , lookup
Regenerative circuit wikipedia , lookup
Audio power wikipedia , lookup
Wien bridge oscillator wikipedia , lookup
Pulse-width modulation wikipedia , lookup
Utility frequency wikipedia , lookup
Power electronics wikipedia , lookup
Switched-mode power supply wikipedia , lookup
Immunity-aware programming wikipedia , lookup
Summary: The device will transmit an input signal on a carrier wave on the ISM (~900 MHz) band with a power of at least 1 watt. The device consists of a transmitter (Atmel T5750), an RF power amplifier (LINX BBA-519-A), a 900 MHz splatch antenna and associated matching networks. Transmitter: T5750 Frequency range: 868 – 928 MHz Modulation: FSK, ASK Transmit power output: 5.5 dBm Available through digikey ($2.39) Usage: operating frequency is determined by Crystal oscillator frequency x 64 ASK or FSK modes are enabled Receives input from microcontroller or signal generator output is matched to 50 ohms RF amp: BBA-519-A General purpose broadband amp max power in: 13 dBm max power out: 33 dBm at 1 GHz internally matched to 50 ohm input and output Available through digikey ($15) Antenna: ANT-916-SP Frequency: 916 MHz (ISM) Bandwidth: 10 MHz Input impedance: 50 ohms. Design and Operation The T5705 and BBA-519 are both simple to implement. Minimal external circuitry is needed. Frequency of the transmitter is selected with a 14.2969 MHz Crystal for operation at 916 MHz. The circuit will provide a DC voltage through a jumper to the FSK/ASK enable to determine the output mode. A test input from a function generator will be the input for the transmitter. Since output of the transmitter and input of the power amp are both matched to 50 ohms, no matching network is needed. Since the devices will be placed close together, transmission line parameters are not critical. The maximum output power of the power amp is greater than one watt. The antenna is also matched to 50 ohms but must be placed within .25" of the power amp output. The PCB under the antenna must not contain a ground plane since the antenna is flat and mounted on the circuit board. Block Diagram Alternatives: Transceiver: MC13190 complicated external circuitry Frequency range: 2.4 GHz Modulation: Amplitude modulation Transmit power: 4.8 dBm Available through Digikey ($5.05) AT86RF211 Requires development kit for microcontroller programming, complicated external circuitry Frequency range: 400 – 900 MHz Modulation: Frequency Shift Keying Modes of operation: Transmit and receive Transmit Power output: 10 dBm @ 916 MHz Available through Digikey ($9.89) Usage: Crystal oscillators provide frequency selection Internal microcontroller registers are programmed by a serial interface with desired frequency range (dependant on supporting circuitry) and function. Multiple frequency band usage requires switching of external circuits Receives serial data from external microcontroller (requires clock and enable information). Test data can be provided with a signal generator and DC inputs internal microcontroller modulates data using FSK and broadcasts the signal with no additional processing RF amp: MRFIC0970R2 Package not suitable for prototyping, complicated supporting circuitry 900 MHz ISM, GSM band amplifier max power in: 10 dBm max power out: 35 dBm internally matched to 50 ohm input and output