Download Unit 5: Electricity

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Document related concepts

Negative resistance wikipedia , lookup

Integrating ADC wikipedia , lookup

CMOS wikipedia , lookup

Electric battery wikipedia , lookup

Power electronics wikipedia , lookup

Operational amplifier wikipedia , lookup

Josephson voltage standard wikipedia , lookup

Rechargeable battery wikipedia , lookup

Multimeter wikipedia , lookup

Switched-mode power supply wikipedia , lookup

TRIAC wikipedia , lookup

Voltage regulator wikipedia , lookup

Schmitt trigger wikipedia , lookup

Electrical ballast wikipedia , lookup

Two-port network wikipedia , lookup

Power MOSFET wikipedia , lookup

Opto-isolator wikipedia , lookup

Current source wikipedia , lookup

Resistive opto-isolator wikipedia , lookup

Ohm's law wikipedia , lookup

Surge protector wikipedia , lookup

Current mirror wikipedia , lookup

Rectiverter wikipedia , lookup

Network analysis (electrical circuits) wikipedia , lookup

Transcript
7.6 - Series and Parallel Circuits
Batteries in Series
• Positive terminal is connected to the
negative terminal of the next battery and so
on.
• Increases the amount of voltage.
• Typical electrical cell is 1.5 V
• Example: If you connect 3 cells, the
voltage becomes 4.5 V.
• The electrons get three boosts of energy
instead of one.
Batteries in Parallel
• All of the positive terminals of the cells are
connected and all of the negative terminals are
connected.
• Voltage stays the same.
• Amount of electrical charge increases.
• Example: Connecting two cells in parallel
means there will be twice as many electrons
available.
• So, a bulb will glow twice as long.
Kirchhoff’s Rules
• Kirchhoff’s Current Rule (KCR)
• At any junction point:
• the total current into the junction equals the
total current out of the junction.
• Kirchhoff’s Voltage Rule (KVR)
• In any complete path:
• the sum of the voltage rises equals the
sum of the voltage drops.
Sample problem 1
Problem 2
Resistors in Series
• For any number n of resistors
connected in series, the equivalent
resistance is
• Rt = R1 + R2 + ... Rn
• Recall  R=IV
Sample problem 3
Resistors in Parallel
• For any number n of resistors
connected in parallel, the equivalent
resistance is found by using the
equation
Sample problem 4
• Calculate the equivalent resistance of a circuit
with the following resistors in parallel: 5, 10, and
30 ohms.
• *** SAMPLE PROBLEM 5 - For the circuit shown
below, determine both the current through and the
potential drop across each resistor.
HOMEWORK
•
•
•
•
P.337 #1-3
P.339 #4-5
P.340 #7
P.342 #9