Download MC33800, Engine Control Integrated Circuit

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Document related concepts

Electrical ballast wikipedia , lookup

Voltage optimisation wikipedia , lookup

Flip-flop (electronics) wikipedia , lookup

Power inverter wikipedia , lookup

Electrical substation wikipedia , lookup

Ohm's law wikipedia , lookup

Ground (electricity) wikipedia , lookup

Islanding wikipedia , lookup

Mains electricity wikipedia , lookup

Stray voltage wikipedia , lookup

Control system wikipedia , lookup

TRIAC wikipedia , lookup

Rectifier wikipedia , lookup

Power MOSFET wikipedia , lookup

Current source wikipedia , lookup

Voltage regulator wikipedia , lookup

Resistive opto-isolator wikipedia , lookup

Variable-frequency drive wikipedia , lookup

Alternating current wikipedia , lookup

Schmitt trigger wikipedia , lookup

Distribution management system wikipedia , lookup

Fault tolerance wikipedia , lookup

Switched-mode power supply wikipedia , lookup

Immunity-aware programming wikipedia , lookup

Earthing system wikipedia , lookup

Buck converter wikipedia , lookup

Pulse-width modulation wikipedia , lookup

Current mirror wikipedia , lookup

Opto-isolator wikipedia , lookup

Transcript
FUNCTIONAL DESCRIPTION
FUNCTIONAL INTERNAL BLOCK DESCRIPTION
FUNCTIONAL INTERNAL BLOCK DESCRIPTION
Figure 5. Functional Block Diagram
ANALOG CONTROL CIRCUITRY
The 33800 is designed to operate from 5.0 to 36V on the
VPWR pin. The VPWR pin supplies power to all internal
regulators, analog and logic circuit blocks. The VDD supply is
used for setting communication threshold levels and
supplying power to the SO driver. This IC architecture
provides low quiescent current Sleep Modes. Applying
VPWR to the device will cause a Power On Reset (POR). The
on-chip oscillator supports the selectable PWM frequency
and duty cycle. The on-chip voltage regulator and bandgap
supply the required voltages to the internal circuitry.
current limits to accommodate lamp inrush current. The
device allows for parallel control of the outputs or SPI control
through the use of several input command words.
CONSTANT CURRENT LOW SIDE DRIVERS: CCD1
AND CCD2
The CCD1/CCD2 constant current controllers are
switching hysteretic current controllers with a superimposed
dither. The controllers are designed to provide a
programmable constant current through a solenoid valve.
Fluid flow is controlled by the amount of current run through
the driven solenoid valve.
MCU INTERFACE AND OUTPUT CONTROL
The device is designed with six flexible PWM gate driver
outputs. Each driver may be controlled directly from the MCU
and may be programmed through the SPI for a specific
frequency and duty cycle.
LOW–SIDE DRIVERS: OUT1 – OUT8
GATE PRE-DRIVERS: GD1 – GD6
The GD1 – GD6 pins are the gate drive outputs for external
MOSFETS. They can be PWM’ed with speed and duty cycle
choices per the SPI command registers. Internal to the device
is a Gate to Source resistor designed to hold the external
MOSFET in the OFF state while the device is in POR.
The 33800 provides flexible control of 8 low side driver
outputs. Outputs 1 and 2 are specifically designed with higher
33800
18
Analog Integrated Circuit Device Data
Freescale Semiconductor