* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Download Multiple-output Switched Mode Power Supplies (SMPSs)
Standby power wikipedia , lookup
Resistive opto-isolator wikipedia , lookup
Pulse-width modulation wikipedia , lookup
Electrical substation wikipedia , lookup
Solar micro-inverter wikipedia , lookup
Stray voltage wikipedia , lookup
Power over Ethernet wikipedia , lookup
Electrification wikipedia , lookup
Electric power system wikipedia , lookup
Three-phase electric power wikipedia , lookup
Voltage regulator wikipedia , lookup
Power factor wikipedia , lookup
Integrating ADC wikipedia , lookup
Audio power wikipedia , lookup
History of electric power transmission wikipedia , lookup
Variable-frequency drive wikipedia , lookup
Power inverter wikipedia , lookup
Power engineering wikipedia , lookup
Voltage optimisation wikipedia , lookup
Alternating current wikipedia , lookup
Power supply wikipedia , lookup
Opto-isolator wikipedia , lookup
Mains electricity wikipedia , lookup
POWER FACTOR CORRECTED ZETA CONVERTER BASED IMPROVED POWER QUALITY SWITCHED MODE POWER SUPPLY ABSTRACT: Multiple-output Switched Mode Power Supplies (SMPSs) for personal computers (PCs) normally depict extremely bad power quality indices at the utility interface such as total harmonic distortion of the input current being more than 80%, power factor being lower than 0.5 and output voltage regulation being very poor. They violate the limits of harmonic emissions set by international power quality standards. In this paper, a nonisolated power factor corrected (PFC) converter is being proposed to be used at the front end to improve the power quality of an SMPS for a PC. The front-end converter is able to reduce the 100-Hz ripple in its output that is being fed to the second stage isolated converter. The performance of the front-end Zeta converter is evaluated in three different operating conditions to select the best operating condition for the proposed SMPS system. The performance of the proposed SMPS is simulated and a laboratory prototype is developed to validate its performance. Test results are found to be in line with the simulated performance under varying input voltages and loading conditions and all the results demonstrate its enhanced performance INTRODUCTION: Switched Mode Power Supply (SMPS) is an integral part of the computer that converts ac to multiple numbers of suitable dc voltages to impart power to different parts of the PC. It contains a diode bridge rectifier (DBR) with a capacitor filter followed by an isolated dc-dc converter to achieve multiple dc output voltages of different ratings. The uncontrolled charging and discharging of the capacitor result in a highly distorted, high crest factor, periodically dense input current at the single phase ac mains; this violates the limits of international power quality (PQ) standards such as IEC 61000- 3-2. Further, the neutral current in the distribution system increases if these PCs are used in large numbers which creates serious problems like overloading the neutral conductor, noise, de-rating of the transformer, voltage distortion etc To end these problems, improved PQ SMPSs that are capable of drawing a sinusoidal input current at unity power factor (UPF) and yielding stiffly regulated output voltages, are extensively being researched. Employing various power factor corrected (PFC) single-stage and two-stage onverters effect a perceivable PQ improvement in these SMPSs . PQ improvement is visible in the form of low total harmonic distortion (THD) in the ac mains current and power factor being close to unity at the point of common coupling (PCC). This is achieved even under varying loads and supply voltage conditions. In a single-stage SMPS, ac supply is connected to a DBR whose output is processed by a multioutput PFC isolated dc-dc converter for obtaining dc voltages. The reliability of this single-stage SMPS is good; however, the output capacitors used are of very high value to reduce the 100 Hz ripple content. So, the rating of any single-stage SMPS is limited to about 200 W to avoid prohibitively high capacitance value. EXISTING SYSTEM: An AC-DC Zeta converter topology is used for providing regulated DC voltage to feed the voltage source inverter (VSI) employed in the direct torque controlled PMSM drive. The proposed converter provides improved power quality in terms of low total harmonic distortion (THD), reduced crest factor (CF) of the AC supply current, high power factor of the AC mains and regulated output DC voltage PROPOSED SYSTEM: This paper presents power quality improvement in a multiple output SMPS that yields regulated dc output voltages irrespective of line and load variations. A Zeta PFC converter is still unexplored for the development of computer SMPSs that are capable of drawing a purely sinusoidal current with unity PF, offering low rippled output which is the prime requirement of PCs. ADVANTAGES: Mitigate power quality problems BLOCK DIAGRAM: TOOLS AND SOFTWARE USED: MPLAB – microcontroller programming. ORCAD – circuit layout. MATLAB/Simulink – Simulation APPLICATIONS: Personal computers (PCs) CONCLUSION: A DCM operated front-end PFC converter cascaded with a multiple output isolated converter has been used for the design of an SMPS for PCs. It has been designed, modeled, simulated and developed for input power quality improvement and output voltage regulation. All the dc output voltages are regulated by controlling only one output voltage. Three different modes of operation of the front-end converter have been carried out in simulation to select the best possible operation especially based on device stresses. Finally, the best suited mode of operation for the front-end converter has been implemented in an experimental prototype. Test results obtained from the prototype conform to the ones obtained via simulations. From the recorded test results, it is evident that the proposed power supply is able to mitigate power quality problems that are present in the conventional SMPS systems. Based on these results, it is concluded that the proposed SMPS configuration in PCs is expected to yield improved THD of ac mains current with almost unity PF under wide range of input voltages and loads. REFERENCES: [1] Limits for Harmonic Current Emissions, International Electro Technical Commission Standard, Std. 61000-3-2, 2004. [2] IEEE Recommended Practices and Requirements for Harmonics Control in Electric Power System, IEEE Std. 519, 1992.