• Study Resource
• Explore

Survey

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Document related concepts

Switched-mode power supply wikipedia, lookup

Opto-isolator wikipedia, lookup

Current mirror wikipedia, lookup

Power electronics wikipedia, lookup

Schmitt trigger wikipedia, lookup

Resistive opto-isolator wikipedia, lookup

Immunity-aware programming wikipedia, lookup

Rectiverter wikipedia, lookup

Wien bridge oscillator wikipedia, lookup

Amplifier wikipedia, lookup

Tube sound wikipedia, lookup

Regenerative circuit wikipedia, lookup

Audio power wikipedia, lookup

Power MOSFET wikipedia, lookup

Operational amplifier wikipedia, lookup

CMOS wikipedia, lookup

Valve RF amplifier wikipedia, lookup

Network analysis (electrical circuits) wikipedia, lookup

Two-port network wikipedia, lookup

Standing wave ratio wikipedia, lookup

Test probe wikipedia, lookup

Mathematics of radio engineering wikipedia, lookup

Phase-locked loop wikipedia, lookup

Index of electronics articles wikipedia, lookup

Valve audio amplifier technical specification wikipedia, lookup

Negative-feedback amplifier wikipedia, lookup

Audio crossover wikipedia, lookup

Transistor–transistor logic wikipedia, lookup

Scattering parameters wikipedia, lookup

History of the transistor wikipedia, lookup

Zobel network wikipedia, lookup

Tektronix analog oscilloscopes wikipedia, lookup

Wilson current mirror wikipedia, lookup

Impedance matching wikipedia, lookup

Nominal impedance wikipedia, lookup

Power dividers and directional couplers wikipedia, lookup

HD-MAC wikipedia, lookup

Distributed element filter wikipedia, lookup

Transcript
```To design an amplifier stage, a
source and load impedance combination must be found that gives
the gain desired. Synthesis can be
accomplished in three stages.
Step 1
The vector voltmeter measures
the scattering parameters over the
frequency range desired.
Step 2
Transducer power gain is
plotted versus frequency using
equation 19 and the measured data
from step 1. This determines the
frequency response of the uncompensated transistor network so that
a constant-gain amplifier can be
designed.
Step 3
be selected to provide the proper
compensation of a constant power
gain from 100 to 500 Mhz. Such
a constant-gain amplifier is de-
signed according to the following:
â¢ Plot SnÂ° on the Smith chart.
The magnitude of Sn* is the linear
distance measured from the center
of the Smith chart. Radius from
the center of the chart to any point
on the locus of Sn represents a
reflection coefficient r. The value of
r can therefore be determined at
any frequency by drawing a line
from the origin of the chart to
a value of su* at the frequency of
Step3
-lOOMhz^ONSTANT
â SOOMhz | CIRCLES
J *M
Source impedance is found by inspecting the input plane for realizable source loci that give proper gain. Phase
angle is read on the peripheral scale "angle of reflection coefficient in degrees."
Electronics | September 5, 1966
```
Related documents