Download Dynamic material strength measurement utilizing magnetically

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Document related concepts

Thomas Young (scientist) wikipedia , lookup

Magnetic field wikipedia , lookup

Aharonov–Bohm effect wikipedia , lookup

Lorentz force wikipedia , lookup

Superconductivity wikipedia , lookup

Electromagnet wikipedia , lookup

Transcript
EPJ Web of Conferences 26, 01043 (2012)
DOI: 10.1051/epjconf/20122601043
c Owned by the authors, published by EDP Sciences, 2012
Dynamic material strength measurement utilizing magnetically applied
pressure-shear
C.S. Alexandera
Sandia National Laboratories, Albuquerque, NM 87185-1195, USA
Abstract. Magnetically applied pressure-shear (MAPS) is a recently developed technique used to measure dynamic material
strength developed at Sandia National Laboratories utilizing magneto-hydrodynamic (MHD) drive pulsed power systems. MHD
drive platforms generate high pressures by passing a large current through a pair of parallel plate conductors which, in essence,
form a single turn magnet coil. Lorentz forces resulting from the interaction of the self-generated magnetic field and the drive
current repel the plates and result in a high pressure ramp wave propagating in the conductors. This is the principle by which
the Sandia Z Machine operates for dynamic material testing. MAPS relies on the addition of a second, external magnetic field
applied orthogonally to both the drive current and the self-generated magnetic field. The interaction of the drive current and
this external field results in a shear wave being induced directly in the conductors. Thus both longitudinal and shear stresses are
generated. These stresses are coupled to a sample material of interest where shear strength is probed by determining the maximum
transmissible shear stress in the state defined by the longitudinal compression. Both longitudinal and transverse velocities are
measured via a specialized velocity interferometer system for any reflector (VISAR). Pressure and shear strength of the sample
are calculated directly from the VISAR data. Results of tests on several materials at modest pressures (∼10 GPa) will be presented
and discussed.
a
e-mail: [email protected]
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 2.0, which permits unrestricted use, distribution,
and reproduction in any medium, provided the original work is properly cited.
Article available at http://www.epj-conferences.org or http://dx.doi.org/10.1051/epjconf/20122601043