Survey
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Lifting a Lightweight Object Introduction: The task of lifting objects is a common physical demand in both the home and the workplace. The action of lifting can include picking up a dropped pencil at the office, taking out the trash, heaving large boxes while moving, etc. Proper lifting techniques stress concepts such as vertical gravity line, base of support, short lever arms, and lordosis. Despite this knowledge, lifting accidents and injuries do occur. Over 60% of all lifting injuries in the workplace result from overexertion, nearly one third are due to accidents in which improper footing or improper weight expectation occurred. Still other injuries are cumulative, in which minor subclinical injuries accumulate damage over time. Most lifting styles focus on minimizing stressors on the lower back; in fact, 400,000 new cases of work-related injuries occur to the lower back each year. However, no style of lifting can minimize the stressors at the hip, patellofemoral joint, and the ankle joints. Research shows that strong, flexible hamstrings and quadriceps can help protect the back while lifting. Maximum joint angles suggested for safe lifting are 125 degrees at the hip, 140 degrees at the knee, and 25 degrees at the ankle. The purpose of our presentation is to analyze one lifting situation involving a lightweight object, in this case, a single branch in the woods. We will focus on the lower extremities—the hip, the knee, and the ankle. However, it is important to mention the general status of the upper body and extremities since they are certainly involved. Pre-lifting Phase : Trunk and Upper Body Motions In our scenario, the subject is jogging through the woods when she encounters a branch in the way and abruptly stops. At this point, the shoulder girdle goes into protraction with the intent to eventually remove the branch. The shoulder joint goes into slight flexion as does the elbow joint, and the forearm goes into pronation as it readies to pick up the object. The hand prepares to lift by using a spherical grip around the rounded shaft of the branch. The trunk does not rotate nor bend; it remains stabilized by the deep transverse muscles which are in a low level of contraction. There is slight lordosis of the spine as the subject keeps her back from arching forward. Phase I: Starting the Lift The Hip (Figure 1.1) In the starting position, the action of the pelvic girdle is a slight anterior tilt, with an increased lumbar lordosis. The motion at the hip joint is hip flexion. The muscles working are the gluteus maximus, semitendinosus, semimembranosus, and the long head of the biceps femoris. These muscles are producing an eccentric contraction. The antagonists are the hip flexors which are rectus femoris, iliopsoas, and pectineus. Because the distal segment is stabilized, this motion is closed chain. The Knee (Figure 1.2) The starting action is knee flexion. The muscles include the rectus femoris, vastus lateralis, vastus intermedialis, and vastus medialis, which are known as the quadriceps group. They are going into an eccentric contraction as they stretch over the patella, preventing gravity from causing the knee to “buckle.” Although one would think that the hamstrings (biceps femoris, semimembranosus, and semitendinosus are involved in knee flexion, they are, in fact, the antagonists in this situation. The popliteus, which initiates knee flexion, is contracting at this phase as well, although it is an assist to knee flexion at best. At the patellofemoral joint, the convex femur is rolling posteriorly, sliding anteriorly, and spinning laterally on the concave tibia. This is because the motion is distal segment stable (closed chain). The Ankle (Figure 1.3) The action of bringing the body down toward the ground causes an eccentric contraction of the soleus, which is the prime mover. The gastrocnemius, normally the much stronger muscle, is put on slack at the knee joint and therefore is an assist at best. Additionally, the plantaris is a weak assist along with the soleus in eccentrically contracting to stabilize the ankle. While the ankle is placed in dorsiflexion, the tibialis anterior is not contracted and acts as the antagonist in this situation. The action is closed chained—the distal segment is stationary. The talocrural joint, which is a hinge joint, is allowing dorsiflexion. The toes of the right foot remain in extension; the toes of the left foot are hyperextending on the way down. This is due to an eccentric contraction of the flexor digitorum longus and the flexor hallucis; again, one would think that the extensors are doing the work, but they are the antagonists. The action of the phalanges is also close- chained. Phase II: Retrieving the Object The Hip (Figure 2.1) The gluteus maximus, semitendinosus, semimembranosus, and biceps femoris (long head) are continuing to contract isometrically, because no movement is occurring. Muscles that are stabilizers include the gluteus medius and gluteus minimus as well as the sartorius. The tensor fascia latae is included as a stabilizer, also. The hip flexors (rectus femoris, iliopsoas, and pectineus) are still the antagonists. The pelvic girdle has a more pronounced anterior pelvic tilt. The Knee (Figure 2.2) When retrieving the object, the knee continues to be in flexion with the primary movers being the rectus femoris, the vastus lateralis, vastus intermedialis, and the vastus medialis. The contraction in this position is isometric since there is no movement, but instead, a “holding down” situation. The hamstrings group, including the biceps femoris, semimembranosus, and semitendinosus are the antagonists. The Ankle (Figure 2.3) As the body remains down and the ankle is in dorsiflexion, the soleus continues to contract in an isometric fashion, keeping the balance and strength steady. The toes are in extension; the flexor hallucis longus and the flexor digitorum longus are also on an isometric contraction as they hold the foot in place. Note that in the left foot, the toes are in hyperextension isometrically. Phase Three: Returning to Starting Position The Hip (Figure 3.1) The hip is now in going into extension, and the hip extensors are still doing the work of contracting. They include the gluteus maximus, semitendinosus, semimembranosus, and biceps femoris (long head). They are concentrically contracting as the body moves against gravity. The antagonist continue to be the hip flexors, which are the rectus femoris, iliopsoas, and pectineus. The pelvic girdle is returning to neutral position. The Knee (Figure 3.2) The knee is going into extension as the object is lifted. The rectus femoris, vastus lateralis, vastus intermedialis, and vastus medialis are contracting concentrically. At the patellofemoral joint, the femur has an anterior roll as it slides posteriorly. Additionally, there is a medial spin of the femur with the last twenty degrees of extension. The Ankle (Figure 3.3) In returning to the starting position, the soleus is now concentrically contracting as the muscle belly shortens. There is less stretch at the calcaneus now since the lower leg is raising. The flexors are also concentrically contracting as the lower leg raises. Conclusions: Although many lifting techniques and work-related training programs focus on preventing injury to the trunk, particularly to the back and spine, our focus was to discover the role of the lower extremities in lifting. As seen, there is much muscle action occurring at these three joints, with potential injury at any one of them. We believe that instruction in lower extremity motions, in addition to trunk, would be helpful to include in overall lifting techniques. Smooth, safe movements of the hip, knee, and ankle can help prevent upper body injuries. There are many ways to approach the action of lifting. The example we used is one way of lifting; other more effective ways could have been utilized. However, lifting is often an unplanned, immediate reaction to something dropped or in the way; we don’t always consciously think about our body motions. Works Cited Jacobs, K., Bettencourt, C: Ergonomics for Therapists. ButterworthHeinemann, 1995, pp. 97-112. Pierson, F., Fairchild, S: Principles and Techniques of Patient Care. Elsevier (USA), 2002 pp., 70-73. Lippert, L.: Clinical Kinesiology and Anatomy. F.A. Davis Co., pp. 231-283.