* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Download Metathesis Problems (and Some Solutions) Identified Through
Gas chromatography wikipedia , lookup
Acid dissociation constant wikipedia , lookup
Properties of water wikipedia , lookup
Spinodal decomposition wikipedia , lookup
History of electrochemistry wikipedia , lookup
Debye–Hückel equation wikipedia , lookup
Depletion force wikipedia , lookup
Distillation wikipedia , lookup
Particle-size distribution wikipedia , lookup
Diamond anvil cell wikipedia , lookup
Vapor-compression refrigeration wikipedia , lookup
Reverse osmosis wikipedia , lookup
Chemical equilibrium wikipedia , lookup
Continuous distillation wikipedia , lookup
Atomic theory wikipedia , lookup
Microfiltration wikipedia , lookup
Membrane distillation wikipedia , lookup
Freeze-casting wikipedia , lookup
Electrolysis of water wikipedia , lookup
Size-exclusion chromatography wikipedia , lookup
Colloidal crystal wikipedia , lookup
Liquid–liquid extraction wikipedia , lookup
Equilibrium chemistry wikipedia , lookup
Solvent models wikipedia , lookup
Nanofluidic circuitry wikipedia , lookup
Ionic liquid wikipedia , lookup
State of matter wikipedia , lookup
Sol–gel process wikipedia , lookup
Chapter 12: Solutions Chemistry 1062: Principles of Chemistry II Andy Aspaas, Instructor Solutions • Solution: homogeneous mixture of two or more substances (atoms, molecules, or ions) • Can exist in any state of matter Solute Gaseous solution Component in smaller amount Liquid component in Liquid solution smaller amount, or solid or gas Component in Solid solution smaller amount Solvent Component in larger amount Liquid component in larger amount Component in larger amount States of solutions • Miscible fluids: fluids that dissolve with each other in all proportions • All nonreactive gases are generally miscible – Air is a gaseous solution (N2, O2, CO2, etc.) • Liquid solutions: dissolving a solid, liquid, or gas into a liquid – Ethanol and water are miscible, and when mixed make a liquid solution – Brine is solid sodium chloride dissolved in water • Solid solutions are called alloys when metals are mixed – Dental fillings, brass, steel, etc. Solubility and saturation • If 40.0 g of NaCl were stirred in 100 mL of 20 °C water, most of the salt would dissolve but some would remain on the bottom – Ions dissolve by leaving the surface of the crystal and entering the liquid solution – Some crystals may re-deposit on the crystal • Equilibrium is reached at point where particles dissolve at same rate as they return to the crystal – The solution has become saturated Solubility and saturation • The point at which the solution becomes saturated can be expressed as solubility (at a given temperature) – The solubility of NaCl in 20 °C water is 36.0 g NaCl / 100 mL H2O • The solution is unsaturated when not enough solid has been added for the equilibrium to be reached – Unsaturated solutions can support addition of more solid to be dissolved Supersaturation • Supersaturated solution: solution which contains more dissolved substance than a saturated solution does • Sodium acetate and many other ionic compounds more soluble in hot water than in cold water – If a saturated solution is prepared at high temperature, and then the temperature is slowly lowered, the solution may become supersaturated – Introduction of any solid to a supersaturated solution will cause the whole solution to quickly crystallize Factors behind solubility • “Like dissolves like” - similar substances tend to dissolve in each other • The natural tendency of substances to mix through the random motion of their particles can be overridden if one component has strong intermolecular forces, and the other does not – Oil and water: water’s intermolecular forces are maintained if nonpolar oil molecules do not interrupt the water molecules – Alcohol and water: similar hydrogen bonds can be formed, so 3-carbon alcohols and smaller are miscible in water (larger alcohols are too dissimilar to water) Solubility of ionic compounds • Partial charges of water molecules orient themselves towards oppositely charged ions in solutions (ion-dipole force) • Hydration: water molecules surrounding ions - this favors dissolving of ionic solids in water • Lattice energy: energy holding together ions in a crystal lattice - this works against dissolving – Lattice energy increases with ion charge – Lattice energy decreases with ionic radius – Hydration energy increases with ionic radius Temperature effects on solubility • Most gases are less soluble in water at higher temperatures (bubbles that appear when heating water) • Most ionic solids are more soluble in water at higher temperatures – Some have very little change, like NaCl – Some are less soluble in higher temperatures • Heat of solution: heat absorbed or released when a solid is dissolved – Depends on combination of lattice energy and hydration energy – Chemical hot packs and cold packs take advantage of this Pressure effects on solubility • All gases become more soluble in a liquid at a given temperature when the partial pressure fo the gas over the solution is increased – Le Chatelier’s principle: if an equilibrium is disturbed by a temperature, pressure or concentration change, the equilibrium will shift to compensate for the change – Increasing the partial pressure of CO2(g) over water will cause more CO2 to dissolve CO2(g) CO2(aq) • This equilibrium will shift to the right (more CO2 will dissolve) to compensate for the pressure increase Henry’s law • Henry’s law: solubility of a gas is directly proportional to the partial pressure of the gas above the solution S = k HP where S is solubility (mass of solute per unit volume of solvent), kH is Henry’s law constant (for gas and liquid at a given temperature), P is partial pressure of the gas Colligative properties and concentration • Colligitave properties depend on concentration of solute molecules or ions in solution, but not the chemical identity of the solute • Molarity, M = (moles solute)/(liters solution) • Mass percentage: [(mass solute)/(mass solution)]*100% • Molality, m = (moles solute)/(kilograms solvent) • Mole fraction, XA = (moles A)/(total moles solution) Vapor pressure of a solution • Vapor pressure lowering: colligative property – Vapor pressure of pure solvent minus vapor pressure of solution • Raoult’s law: PA = P°AXA – if solute must be nonvolatile nonelectrolyte – PA = partial pressure of solvent – P°A = vapor pressure of pure solvent – XA = mole fraction of solvent in solution • Or, ∆P = P°AXB where XB = mole fraction of solute Distillation • An ideal solution follows Raoult’s law for all mole fractions 0–1 – When two components are chemically similar, their intermolecular forces are similar • Total vapor pressure, P = P°AXA + P°BXB • Vapor over an ideal solution is richer in the more volatile component • Fractional distillation condenses and re-vaporizes the solution many times to exploit this Boiling point elevation • Addition of a nonvolatile solute reduces the solvent’s vapor pressure • Normal boiling point: temperature at which vapor pressure = 1 atm • So, addition of solute requires a higher temperature in order for vapor pressure to reach 1 atm • Boiling point elevation, ∆Tb = Kbcm Kb = bp elevation constant, depends only on solvent cm = molal concentration of solution Freezing point depression • Nonvolatile solutes will lower the freezing point of a solvent in a similar way to bp elevation • ∆Tf = Kfcm • Antifreeze both lowers the freezing point and raises the boiling point of the coolant • Molecular weight of a solute can be determined by measuring its freezing point depression Osmosis • Semipermeable membrane: allows solvent molecules to pass but large solute molecules cannot • Osmosis: flow of solvent through a semipermeable membrane to equalize solute concentrations on both sides of the membrane • π = MRT (M = molar conc., R = gas constant, T = absolute temperature) • Reverse osmosis: apply greater pressure to more concentrated solution and force pure solvent through membrane Colligative properties of ionic solutions • Effective concentration of ionic solutions is greater than molecular solutions even at the same molarity or molality – Ionic compounds dissociate into individual ions • i = number of ions resulting from solvation of one formula unit • Multiply i in any colligative formula if the solute is ionic ∆Tf = iKfcm ∆P = iP°AXB ∆Tb = iKbcm π = iMRT • i is only accurate in dilute solutions Colloid formation • Colloid: dispersion of particles throughout another substance or solution – Differs from a solution in that its dispersed particles are more than one molecule in size (but still too small to see with the naked eye) • Tyndall effect: colloids scatter light, while solutions do not Types of colloids • Aerosol: liquid or solid particles dispersed throughout a gas – Fog, smoke • Emulsion: liquid droplets dispersed throughout another liquid – Particles of butterfat dispersed through homogenized milk • Sol: solid particles dispersed in a liquid • Hydrophilic colloid: when there is a strong attraction between particles and water – Gelatin • Hydrophobic colloid: no attraction between particles and water Coagulation and association • Coagulation: particles of a colloid are made to aggregate and separate from solvent – Milk curdles when its colloidal particles no longer have the same charge (they’re no longer repelled from each other) • Association colloid: formed when colloidal particles have both hydrophobic and hydrophilic portions – Soaps have long hydrocarbon chain (hydrophobic) and charged functionality (hydrophilic) – The hydrophobic portions gather inwards to form spheres with a hydrophilic outside (micelles)