* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Download Test Procedure for the LV5683PGEVB Evaluation Board SANYO Semiconductors
Audio power wikipedia , lookup
Spark-gap transmitter wikipedia , lookup
Ground loop (electricity) wikipedia , lookup
Immunity-aware programming wikipedia , lookup
Power engineering wikipedia , lookup
Stepper motor wikipedia , lookup
Electrical ballast wikipedia , lookup
Power inverter wikipedia , lookup
Pulse-width modulation wikipedia , lookup
Electrical substation wikipedia , lookup
Three-phase electric power wikipedia , lookup
History of electric power transmission wikipedia , lookup
Integrating ADC wikipedia , lookup
Variable-frequency drive wikipedia , lookup
Current source wikipedia , lookup
Power MOSFET wikipedia , lookup
Resistive opto-isolator wikipedia , lookup
Power electronics wikipedia , lookup
Surge protector wikipedia , lookup
Schmitt trigger wikipedia , lookup
Alternating current wikipedia , lookup
Stray voltage wikipedia , lookup
Switched-mode power supply wikipedia , lookup
Opto-isolator wikipedia , lookup
Buck converter wikipedia , lookup
Voltage regulator wikipedia , lookup
SANYO Semiconductors Test Procedure for the LV5683PGEVB Evaluation Board Prepare DC POWER SUPPLY, capability is 40V or more and 2.5A or more, Digital MULTIMETER, and ELECTRIC DC LOAD Shorted Ring 1. Initial Setting Refer to Fig1, In initial setting, “USB_EN”, “SWU_EN”, “AUDIO_EN” pins are shorted GND. And USB, AUDIO and SWU-OUT are low potential. 2. Measurement Connect VCC/VCC1 cable and GND cable. Bias VCC/VCC1 voltage. Regarding bias voltage range, refer to Application note. Next step remove 3 “Shorted Ring”. Then measure each USB, AUDIO SWU-OUT of voltage and Iq at no load. And then refer to the descriptive text below. Fig1 Line regulation Line regulation is defined as the maximum change in output voltage as the input voltage is varied through the specified range. It is measured by changing the input voltage and measuring the minimum/maximum voltage of the output. Line regulation is defined as the difference between maximum and minimum voltage. Load regulation Load regulation is defined as the maximum change in output voltage as the load current is varied through the specified range. It is measured by changing the load current and measuring the minimum/maximum voltage of the output. Load regulation is defined as the difference between maximum and minimum voltage. Dropout voltage Dropout voltage is defined as the minimum input-to-output differential voltage at the specified load current required by the regulator to keep the output voltage in regulation. It is measured by reducing input voltage until the output voltage drops below the nominal value. Ripple rejection Ripple rejection is defined as the ratio of input ripple amplitude versus that of output. 8/27/2012 www.BDTIC.com/ON/ 1 www.onsemi.com