Download Power Reduction Techniques For Microprocessor Systems

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Document related concepts

Standby power wikipedia , lookup

Three-phase electric power wikipedia , lookup

Pulse-width modulation wikipedia , lookup

Power inverter wikipedia , lookup

Microprocessor wikipedia , lookup

Rectifier wikipedia , lookup

Power factor wikipedia , lookup

Audio power wikipedia , lookup

Variable-frequency drive wikipedia , lookup

Immunity-aware programming wikipedia , lookup

Power over Ethernet wikipedia , lookup

Wireless power transfer wikipedia , lookup

Electrical substation wikipedia , lookup

Stray voltage wikipedia , lookup

Islanding wikipedia , lookup

Electrification wikipedia , lookup

Electric power system wikipedia , lookup

Amtrak's 25 Hz traction power system wikipedia , lookup

Surge protector wikipedia , lookup

History of electric power transmission wikipedia , lookup

Life-cycle greenhouse-gas emissions of energy sources wikipedia , lookup

Power electronics wikipedia , lookup

Distribution management system wikipedia , lookup

Distributed generation wikipedia , lookup

Power MOSFET wikipedia , lookup

Buck converter wikipedia , lookup

Power engineering wikipedia , lookup

Rectiverter wikipedia , lookup

Voltage optimisation wikipedia , lookup

AC adapter wikipedia , lookup

Switched-mode power supply wikipedia , lookup

Alternating current wikipedia , lookup

Mains electricity wikipedia , lookup

Transcript
Power Reduction Techniques
For Microprocessor
Systems
Presented by William Lane
Material and graphics presented here are from:
Power Reduction Techniques For Microprocessor Systems
Vasanth Venkatachalam and Michael Franz
ACM Computing Surveys, Vol. 37, No3, September 2005, pp. 195 - 237
“Power consumption is a major factor that
limits the performance of computer systems.”
Most of the power a computer consumes ends up as heat.
The above diagram shows the power density of a few microprocessors.
In some cases heat generation and power consumption may not be an issue.
For example: Home computer used for gaming vs. Cell phone
Forms of power consumption:

Dynamic
 Switched
capacitance
 Short circuit current

Static
 Leakage
Static power loss seems to be where most of the total power is ending up.
Dynamic Power Loss

Switched capacitance:
 85-90%
of dynamic power loss
 Energy used in charging or dissipating capacitors at
outputs of circuits

Short Circuit Current:
 10-15%
of dynamic power loss
 Energy used for pairs of transistors that switch current
with opposite polarity cause a momentary short circuit
Equation for Switched Capacitance
power loss
P = aCV2f
P = power loss
V = supply voltage
C = capacitance
a = activity factor
f = clock frequency
Methods of reducing Switched
Capacitance power loss

Decreasing the capacitance


Decreasing activity level


This can be difficult because generally we try to fit more on to
computer chips. Ex. Clock Gating
Reduce clock frequency


This can worsen the performance.
Reduces the performance and may not end up reducing the
energy used.
Decrease supply voltage

Lower supply voltage can increase time delay of the circuit which
would then need a lower clock frequency.
Dynamic Voltage Scaling



A combination of adjusting the supply voltage
and clock frequency are used to increase or
decrease the power of the processor. Adjusting
these two together gives the best results.
Many modern processors use such a method to
control the speed of the processor.
DVS can be used for consuming less power
while also keeping the temperature of the chip
cooler.
Static Power Loss

Reduce supply voltage


Reduce the size of the circuit



Clock gating
Technology Mapping (tool for circuit design)
Cool computer


Uses less power
Recent study showed that cooling the processor by 50 degrees reduced
leakage by up to a factor of 5
Change threshold voltage of transistors

Increasing the threshold voltage lowers the amount of leakage through
the transistor, but it then takes more voltage to switch the transistor. Ex:
Adaptive Body Biasing
Further studies in power consumption

Buses
 Reduce
the amount of switching in a bus. Invert
signal to decrease number of bits that change.
11111 to 00001
11111 to 11110
 Low

Swing Bus
Use lower voltage for the bus
 Bus

4 bits change
1 bit change
segmentation
Shut down parts of bus not used
Further studies in power consumption

Memory

Each memory access costs energy



Scratch pad memory


Used mostly in embedded application; programmer defines what
data to store in the cache.
Instruction level cache


Decrease number of memory access
Decrease amount of energy needed to access memory
Stores the next few instructions only. Any memory references are
removed. Located between L1 cache and processor
Adaptive Cache

Turns off part off cache to save energy. Can be used with drowsy
cache to save data in cache when cache is turned off.
A few open questions

Is it more energy efficient to run a program using a more powerful
processor which runs for less time, or is it better to run a processor
that is less powerful but finishes in more time? Which processor
uses more energy?

The speedup of a program is not linear to the speedup of the processor.

Is it better to use multiple slow processors or one fast processor?
Which uses more energy?

For a laptop computer would you pick a processor that would burn
through your battery quickly but gives you more computing power?
In conclusion

The energy efficiency of a processor
needs to be weighed against the
application of the processor.

Most often it is a choice between a more
powerful processor and a more energy
efficient one.