Download kombajn KTW200.cdr

WAMAG S.A.
KTW-200 Roadheader
The roadheader is equipped with electrical engines manufactured by the
DAMEL factory, certified in conformity
with IEC-60079 standards and new
electrohydraulic distributors manufactured by the Bosch – Retrox companies covered by ATEX certificates.
The following curious constructional
solutions are applied in the KTW-200
roadheader to cope with competitiveness and meet customers’ expectations:
• alternative option of operation either
manually or by radio remote control
up to 15m;
• programmable cutting;
• roadheader positioning system in the
gallery axis, together with leveling
system;
• sector spraying system;
• roadheader cooperation system with
control and visualization stand located 50m away from behind
the roadheader (optional- in case of
rock outburst hazard);
• cutting drum two-gear transmission
(optional);
• Scraper conveyor chain two-gear
transmission (optional).
In order to rationalize the raodheader servicing,
it is possible to register and reconstruct its
selected working parameters for the last two
operational weeks.
The KTW-200 is also equipped with running
parameters transmission system on the surface
through either cable or optical fiber networks.
KTW-200 Roadheader
The KTW-200 roadheader is designed for driving galleries of cross-section area amounting to 35.5 sqm.
It is capable of mining rocks whose compressive strength amounts to 110 MPa.
The roadheader can be operated in coal mines or used for f tunneling.
Bit blocks with injector air suction are used in the KTW-200; they ensure proper spark suppression
and reduction in dustiness.
Water batteries mounted on the arm and cutting drums with built in sector distributor produce
water spray curtain. Total spraying system capacity amounts to ca. 65 lpm.
WAMAG S.A.
ul. Prymasa S. Wyszyńskiego 1
58-309 Walbrzych
tel.: +48 74 846 80 83
fax: +48 74 846 85 54
e-mail: [email protected]
www.wamag.com.pl
PN-EN ISO 9001:2001
Specification
Total power installed [kW]
390
2.
Power installed on cutting drum [kW]
200
3.
Rock compressive strength [MPa]
110
4.
Maximum cross-section area of a gallery [sqm]
35,5
5.
Cutting height [m]
5,0
6.
Cutting width [m]
7,0
7.
Cut into the floor [m]
~0,3
8.
Transverse inclination angle of a gallery [º]
±5
9.
Longitudinal inclination angle of a gallery [º]
±18
10.
Compressive stress on the floor [MPa]
0,13
11.
Working drive speed [mpm]
0÷6
12.
Maneouvre driver speed [mpm]
0÷10
13.
Supply voltage [V]
1000
Cross-section area outline drawn
for one position of the roadheader
Cut into the floor
The KTW-200 roadheader position in the gallery with roof support arches in the range from ŁP11/V/25/A
to ŁP14/V/25/Ais shown in the drawing below. When galleries of different cross-section areas are driven,
special and approved versions of railings, working platforms and operator stand shields will have to be used.
Ø1048 (together with picks)
1.
Dismantable
railings
Wartość
Roadheader dimensions
No.
KTW-200 Roadheader
Technical parameters