Survey
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Typ: EKFP 1000/200 Art.-No.: G9140410 Features: Integrated channel temperature sensor, nominal length 200 mm, PT1000 class B, 2-conductor Application: The integrated duct sensors EKF / GFL are used for measuring temperatures in liquids and gases in pipes, air ducts or tanks. The mounting flange (MF) is required for use in air ducts. If used in liquids, immersion sleeves made of brass should be used with nickel plating (THMs). For aggressive media, immersion sleeves made of stainless steel V4A (THV) are recommended. Immersion sleeves or mounting flanges are not part of the delivery scope and must be ordered separately. Technical Data: Dimensions of housing: Fitting length: Electrical connection: 64 x 58 x 34 mm 215 mm Screw-type terminals 0,14 mm² to 2,5 mm² only at safety extra-low voltage max. 30VAC / 42VDC, 2-conductor Colour of housing: pure white, like RAL 9010 Sensor: PTC internal Sensor wire extendable up to: depending on the cross-section of the conductor and the sensor type Sensor type: PT-1000 Weight: ca. 100 Storage temperature: -30...+70 °C Material of housing: Plastic PA (30% GF reinforced) Material of sensor tube: V2A (1.4301) max. sensor temperature: 150 max. measurement current: Installation/fastening: in immersion sleeve (THMs, THV) for fluids or with mounting flange (MF) in air channels Surface quality: Degree of protection: Protection class: Sensor characteristic curves: Safety and EMC: Immersion sleeves: Tolerance: Ambient temperature up to: Ambient temperature from: Accessories: Permissible atmospheric humidity: Ciruit Diagram: matt IP 65 III The sensor characteristic curves can be found under Miscellaneous according to DIN EN 60730 from the fitting length (EL), subtract 15 mm to determine the nominal length (NL) of the immersion sleeve, for example, EL = 65 mm corresponds to THV/50 DIN EN 60751 B 70 -30 Mounting flange for installation in air channels: MF suitable immersion sleeves, brass: THMs can be found under Miscellaneous suitable immersion sleeves, special steel (V4A): THV can be found under Miscellaneous max. 95% r.h., non-condensing