Download Item Spec`s Spec`s with Sw DL 3155E17 POWER SUPPLY

Item
DL 3155E17
Spec's
Spec's with Sw
POWER SUPPLY REGULATION CIRCUITS - didactic equipment - circuit
blocks: shunt voltage regulator, series voltage regulator, current
regulator, voltage feedback regulation, IC Regulation, DC-to-DC
Converter - theoretical topics: regulated power supplies, shunt voltage
regulator, Zener diode introductory information, shunt voltage regulator
with Zener diode parallel connected to the load, shunt voltage regulator
with bipolar transistor, series voltage regulators, voltage feedback
regulators with current limiting protection, series current regulators, IC
regulators and DC-to-DC converter, general characteristics of monolithic
regulators, Three-pin IC regulator operation (LM317T), DC-to-DC
converter operating characteristics (LM78S40N), fault simulation. It
must be possible to perform the following experiences: Shunt voltage
regulator, Series voltage regulator, Voltage feedback regulator, Current
regulator, IC regulator, DC to DC converter. The faults must be inserted
by microswitches mounted on the board; the module must be provided
with a EISA BUS 31+18 INTERFACE, connections and test points by 2mm
terminals.
Dimensions of the module: 297x260mm.
The module must be supplied with a theoretical and practical manual.
POWER SUPPLY REGULATION CIRCUITS - didactic equipment - circuit
blocks: shunt voltage regulator, series voltage regulator, current
regulator, voltage feedback regulation, IC Regulation, DC-to-DC Converter
- theoretical topics: regulated power supplies, shunt voltage regulator,
Zener diode introductory information, shunt voltage regulator with Zener
diode parallel connected to the load, shunt voltage regulator with bipolar
transistor, series voltage regulators, voltage feedback regulators with
current limiting protection, series current regulators, IC regulators and
DC-to-DC converter, general characteristics of monolithic regulators,
Three-pin IC regulator operation (LM317T), DC-to-DC converter operating
characteristics (LM78S40N), fault simulation. It must be possible to
perform the following experiences: Shunt voltage regulator, Series voltage
regulator, Voltage feedback regulator, Current regulator, IC regulator, DC
to DC converter. The faults must be inserted by software and by
microswitches mounted on the board. The module must be provided with
a EISA BUS 31+18 INTERFACE for connection to power supply and PC,
with a software able to allow the study of theoretical topics through PC
with hyper textual navigation according to the HTML standard.
Connections and test points by 2mm terminals.
Dimensions of the module: 297x260mm.
The module must be supplied with a theoretical and practical manual.