Survey
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Download Chapter 3.
Document related concepts
Superheterodyne receiver wikipedia , lookup
Analog-to-digital converter wikipedia , lookup
Spark-gap transmitter wikipedia , lookup
Crystal radio wikipedia , lookup
Power electronics wikipedia , lookup
Electronic engineering wikipedia , lookup
VHF omnidirectional range wikipedia , lookup
Signal Corps (United States Army) wikipedia , lookup
Oscilloscope history wikipedia , lookup
Resistive opto-isolator wikipedia , lookup
Radio direction finder wikipedia , lookup
Telecommunication wikipedia , lookup
Regenerative circuit wikipedia , lookup
405-line television system wikipedia , lookup
Valve RF amplifier wikipedia , lookup
Active electronically scanned array wikipedia , lookup
Analog television wikipedia , lookup
Opto-isolator wikipedia , lookup
Broadcast television systems wikipedia , lookup
Battle of the Beams wikipedia , lookup
Continuous-wave radar wikipedia , lookup
Direction finding wikipedia , lookup
Bellini–Tosi direction finder wikipedia , lookup
Cellular repeater wikipedia , lookup
High-frequency direction finding wikipedia , lookup
Index of electronics articles wikipedia , lookup
Transcript
Chapter 3. 2. An AM wave displayed on an oscilloscope has values of Vmax=4.8 V and Vmni=2.5 V as read from the graticule. What is the percentage of modulation? 5. The maximum peak-to-peak value of an AM wave is 45 V. The peak-to-peak value of modulating signal is 20 V. What is the percentage of modulation? 6. What is the mathematical relationship of the carrier and modulating signal voltages when overmodulation occurs? 7. An AM radio transmitter operating on 3.9 MHz is modulated by frequencies up to 4 kHz. What are the maximum upper and lower side frequencies? What is the total bandwidth of the AM signal? 9. How much power appears in one sideband of an AM signal of a 5-kW transmitter modulated by 80%? 10. What is the total power supplied by an AM transmitter with a carrier power of 2500 W and modulation of 77%? 11. An AM signal has a 12-W carrier and 1.5 W in each sideband. What is the percentage of modulation? 13. The antenna current produced by an unmodulated carrier is 2.4 Ainto an antenna with a resistance of 75 ohm. When amplitude-modulated, the antenna current rises to 2.7 A. What is the percentage of modulation? Chapter 4. 3. Describe the two basic ways in which amplitude modulator circuits generate AM. 4. What type of semiconductor device gives a near-perfect square-law response? 8. What kind of amplifier must be used to boost the power of a low-level AM signal? 12. What is the most critical component value in a diode detector circuit? Explain. 17. What is the most difficult part of producing SSB for voice signals by using the phasing methods? C1. State the relative advantages and disadvantage of synchronous detectors versus other types of amplitude demodulator.
