# Download Chapter 3.

Survey
Was this document useful for you?
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Document related concepts

Superheterodyne receiver wikipedia, lookup

Analog-to-digital converter wikipedia, lookup

Spark-gap transmitter wikipedia, lookup

Crystal radio wikipedia, lookup

Power electronics wikipedia, lookup

Electronic engineering wikipedia, lookup

VHF omnidirectional range wikipedia, lookup

Signal Corps (United States Army) wikipedia, lookup

HD-MAC wikipedia, lookup

Oscilloscope history wikipedia, lookup

Resistive opto-isolator wikipedia, lookup

Radio direction finder wikipedia, lookup

Telecommunication wikipedia, lookup

Regenerative circuit wikipedia, lookup

405-line television system wikipedia, lookup

Valve RF amplifier wikipedia, lookup

Active electronically scanned array wikipedia, lookup

Analog television wikipedia, lookup

Opto-isolator wikipedia, lookup

Broadcast television systems wikipedia, lookup

Battle of the Beams wikipedia, lookup

Continuous-wave radar wikipedia, lookup

Direction finding wikipedia, lookup

Bellini–Tosi direction finder wikipedia, lookup

Cellular repeater wikipedia, lookup

High-frequency direction finding wikipedia, lookup

Index of electronics articles wikipedia, lookup

Single-sideband modulation wikipedia, lookup

Radio transmitter design wikipedia, lookup

Transcript
```Chapter 3.
2. An AM wave displayed on an oscilloscope has values of Vmax=4.8 V and Vmni=2.5 V as
read from the graticule. What is the percentage of modulation?
5. The maximum peak-to-peak value of an AM wave is 45 V. The peak-to-peak value of
modulating signal is 20 V. What is the percentage of modulation?
6. What is the mathematical relationship of the carrier and modulating signal voltages when
overmodulation occurs?
7. An AM radio transmitter operating on 3.9 MHz is modulated by frequencies up to 4 kHz.
What are the maximum upper and lower side frequencies? What is the total bandwidth of
the AM signal?
9. How much power appears in one sideband of an AM signal of a 5-kW transmitter modulated
by 80%?
10. What is the total power supplied by an AM transmitter with a carrier power of 2500 W and
modulation of 77%?
11. An AM signal has a 12-W carrier and 1.5 W in each sideband. What is the percentage of
modulation?
13. The antenna current produced by an unmodulated carrier is 2.4 Ainto an antenna with
a resistance of 75 ohm. When amplitude-modulated, the antenna current rises to 2.7 A.
What is the percentage of modulation?
Chapter 4.
3. Describe the two basic ways in which amplitude modulator circuits generate AM.
4. What type of semiconductor device gives a near-perfect square-law response?
8. What kind of amplifier must be used to boost the power of a low-level AM signal?
12. What is the most critical component value in a diode detector circuit? Explain.
17. What is the most difficult part of producing SSB for voice signals by using the phasing
methods?
C1. State the relative advantages and disadvantage of synchronous detectors versus other types
of amplitude demodulator.
```
Related documents