Survey
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Power MOSFET wikipedia , lookup
Surge protector wikipedia , lookup
Nanogenerator wikipedia , lookup
Galvanometer wikipedia , lookup
Superconductivity wikipedia , lookup
Opto-isolator wikipedia , lookup
Nanofluidic circuitry wikipedia , lookup
Electromigration wikipedia , lookup
Rectiverter wikipedia , lookup
Electric charge wikipedia , lookup
Steady Electric Currents Topics covered in this chapter are: Current Density and Ohm's Law Electromagnetic force and Kirchoff's Voltage Law, Continuity Equation and Kirchoff's Current Law. Power Dissipation and Joule's law Boundary Conditions for Current Density Introduction: In our discussion so far we have considered field problems that are associated with static charges. In this chapter we consider the situation when the charges can be in motion and thereby constituting current flow. Due to the movement of free charges, several types of electric current can be caused: Conduction Current is due to the drift of electrons and/or holes and occurs in conductor and semiconductor. Motion of ions gives rise to electrolytic currents and convection current results from motion of electrons and/or ions in an insulating medium such as liquid, rarified gas and vacuum. It is worth mentioning here that in time varying scenario, bound charges give rise to another type of current known as Displacement current, which we shall consider in more detail in later chapters. Current Density and Ohm's Law: In our earlier discussion we have mentioned that, conductors have free electrons that move randomly under thermal agitation. In the absence of an external electric field, the average thermal velocity on a microscopic scale is zero and so is the net current in the conductor. Under the influence of an applied field, additional velocity is superimposed on the random velocities. While the external field accelerates the electron in a direction opposite to it, the collision with atomic lattice however provide the frictional mechanism by which the electrons lose some of the momentum gained between the collisions. As a result, the electrons move with some average drift velocity relationship . This drift velocity can be related to the applied electric field ......................(3.1) where is the average time between the collisions. by the The quantity i.e., the the drift velocity per unit applied field is called the mobility of electrons and denoted by . Thus , e is the magnitude of the electronic charge and opposite to the applied field. , as the electron drifts Let us consider a conductor under the influence of an external electric field. If number of electrons per unit volume, then the charge the direction of the drift velocity is given by: crossing an area represents the that is normal to ........................................(3.2) This flow of charge constitutes a current across , which is given by, ................(3.3) The conduction current density can therefore be expressed as .................................(3.4) where is called the conductivity. In vector form, we can write, ..........................................................(3.5) The above equation is the alternate way of expressing Ohm's law and this relationship is valid at a point. For semiconductor material, current flow is both due to electrons and holes (however in practice, it the electron which moves), we can write ......................(3.6) and are respectively the density and mobility of holes. The point form Ohm's law can be used to derive the form of Ohm's law used in circuit theory relating the current through a conductor to the voltage across the conductor. Let us consider a homogeneous conductor of conductivity , length L and having a constant cross section S as shown the figure 3.1. A potential difference of V is applied across the conductor. Fig 3.1: Homogeneous Conductor For the conductor under consideration we can write, V = EL ..................................(3.7) Considering the current to be uniformly distributed, .............(3.8) From the above two equations, ............................(3.9) Therefore, ............(3.10) where is the resistivity in and R is the resistance in Electromotive force and Kirchhoff’s Voltage Law From our earlier discussion we know that ......................(3.11) Using the point form of Ohm’s Law we can write ......................(3.12) Thus we observe that an electrostatic field cannot maintain a steady current in a closed circuit. Motion of charged carriers in a circuit, which is required to establish a steady current, is a dissipative process while charges moving in a closed path in a conservative electrostatic field neither gain nor lose energy after completing one trip round the circuit. The loss of energy is normally supplied by sources of non-conservative field (e.g. battery, generator, photovoltaic cell etc) and provides a driving force for the carriers. Fig 3.2: Typical Batter If we consider the battery shown in figure 3.2, chemical action causes accumulation of positive and negative charges, these charges establish electrostatic field both inside and outside the battery. When the battery is under open circuited condition no current flows through it and the net force acting on the charges must be zero. Therefore, ......................(3.13) Fig 3.3: Battery in Closed Circuit When we have a closed circuit as shown in figure 3.3, we must have at all points ......................(3.14) , being a conservative field, . Since finite conductivity only in the conductor region, is zero outside the battery and considering ......................(3.15) We define, Electromotive force or EMF to be sources and multiple resistors, . In a circuit where we have multiple ..........................................(3.16) The expression (3.16) is that of Kirchhoff’s voltage Law, which states that algebraic summation of the EMF’s (voltage rise) in a circuit is equal to the algebraic sum of the of the voltage drop across the resistors. Continuity Equation and Kirchhoff’s Current Law Let us consider a volume V bounded by a surface S. A net charge Q exists within this region. If a net current I flows across the surface out of this region, from the principle of conservation of charge this current can be equated to the time rate of decrease of charge within this volume. Similarly, if a net current flows into the region, the charge in the volume must increase at a rate equal to the current. Thus we can write, .....................................(3.17) or, ......................(3.18) Applying divergence theorem we can write, .....................(3.19) It may be noted that, since in general may be a function of space and time, partial derivatives are used. Further, the equation holds regardless of the choice of volume V , the integrands must be equal. Therefore we can write, ................(3.20) The equation (3.20) is called the continuity equation, which relates the divergence of current density vector to the rate of change of charge density at a point. For steady current flowing in a region, we have ......................(3.21) Considering a region bounded by a closed surface, ..................(3.22) which can be written as, ......................(3.23) when we consider the close surface essentially encloses a junction of an electrical circuit. The above equation is the Kirchhoff’s current law of circuit theory, which states that algebraic sum of all the currents flowing out of a junction in an electric circuit, is zero. Power Dissipation and Joule’s Law We have mentioned that in practical conductors, under the action of an applied electric field, the electrons travel with drift velocity and the collision of electrons with the atomic lattice transfers energy acquired by the electrons from the field to the lattice in form of vibration and subsequent dissipation of energy as heat. Under the action of applied electric field volume is given by, , the power delivered to the charge carriers in a ......................(3.24) where N is the density of carriers, q represent charge of a carrier and vd is the drift velocity. Therefore, ......................(3.25) When ---> 0, the equation (3.25)can be written as, ......................(3.26) The quantity represents the power density under steady current condition and for a given volume V the electric power converted to heat is given by ......................(3.27) The above expression is the Joule’s Law. It may be noted that the SI unit for P is Watt.