MAX1992/MAX1993 Quick-PWM Step-Down Controllers with Inductor Saturation Protection and Dynamic Output Voltages
... V+ to AGND............................................................-0.3V to +30V VCC to AGND............................................................-0.3V to +6V VDD to PGND............................................................-0.3V to +6V PGOOD, ILIM, SKIP, SHDN to AGND ................ ...
... V+ to AGND............................................................-0.3V to +30V VCC to AGND............................................................-0.3V to +6V VDD to PGND............................................................-0.3V to +6V PGOOD, ILIM, SKIP, SHDN to AGND ................ ...
Agilent 34401A 6½ Digit Multimeter User’s Guide
... Multimeter is in dcv:dcv ratio function. A math operation is enabled (null, min-max, dB, dBm, or limit test). Hardware or remote interface command errors are detected. Rear input terminals are selected. “Shift” key has been pressed. Press “Shift” again to turn off. Multimeter is in 4-wire ohms funct ...
... Multimeter is in dcv:dcv ratio function. A math operation is enabled (null, min-max, dB, dBm, or limit test). Hardware or remote interface command errors are detected. Rear input terminals are selected. “Shift” key has been pressed. Press “Shift” again to turn off. Multimeter is in 4-wire ohms funct ...
Agilent 34401A
... Multimeter is in dcv:dcv ratio function. A math operation is enabled (null, min-max, dB, dBm, or limit test). Hardware or remote interface command errors are detected. Rear input terminals are selected. “Shift” key has been pressed. Press “Shift” again to turn off. Multimeter is in 4-wire ohms funct ...
... Multimeter is in dcv:dcv ratio function. A math operation is enabled (null, min-max, dB, dBm, or limit test). Hardware or remote interface command errors are detected. Rear input terminals are selected. “Shift” key has been pressed. Press “Shift” again to turn off. Multimeter is in 4-wire ohms funct ...
74AVCH16T245 1. General description 16-bit dual supply translating transceiver with configurable
... transceiver. It has dual supplies (VCC(A) and VCC(B)) for voltage translation and four 8-bit input-output ports (nAn, nBn) each with its own output enable (nOE) and send/receive (nDIR) input for direction control. VCC(A) and VCC(B) can be independently supplied at any voltage between 0.8 V and 3.6 V ...
... transceiver. It has dual supplies (VCC(A) and VCC(B)) for voltage translation and four 8-bit input-output ports (nAn, nBn) each with its own output enable (nOE) and send/receive (nDIR) input for direction control. VCC(A) and VCC(B) can be independently supplied at any voltage between 0.8 V and 3.6 V ...
VADA Lab.
... place and route of the clock system first, then the rest of the signals. For high performance functions, a large clock buffer driving a minimum size clock tree is the best way to accomplish the clocking. They place virtual flip-flops at the ends of the clock lines for loads, then let the software mo ...
... place and route of the clock system first, then the rest of the signals. For high performance functions, a large clock buffer driving a minimum size clock tree is the best way to accomplish the clocking. They place virtual flip-flops at the ends of the clock lines for loads, then let the software mo ...
– Piezoelectric Nanowires – Group 11 Project Specification
... The method of energy harvesting is to coat one fiber with a surface of gold (Au) and intertwine it with another fiber without Au. The gold creates a Schottky junction so that current is allowed to flow from the gold surface to the ZnO nanowire. As linearly axial vibrations are induced on the pair of ...
... The method of energy harvesting is to coat one fiber with a surface of gold (Au) and intertwine it with another fiber without Au. The gold creates a Schottky junction so that current is allowed to flow from the gold surface to the ZnO nanowire. As linearly axial vibrations are induced on the pair of ...
Stakeholder Comparison Comment Rationale Matrix 2011-04-28 AESO AUTHORITATIVE DOCUMENT PROCESS
... and Cascading or uncontrolled separation shall not occur. R2.6. In determining the system’s response to any of the multiple Contingencies, identified in Reliability Standard TPL-003, in addition to the actions identified in R2.3.1 and R2.3.2, the following shall be acceptable: R2.6.1. Planned or con ...
... and Cascading or uncontrolled separation shall not occur. R2.6. In determining the system’s response to any of the multiple Contingencies, identified in Reliability Standard TPL-003, in addition to the actions identified in R2.3.1 and R2.3.2, the following shall be acceptable: R2.6.1. Planned or con ...
Driver TA8411 Instruction Manual
... Thank you very much for purchasing the SV-NET Driver. To use the product correctly, please read this document and all supplied documents carefully before installing, operating, maintaining, and inspecting the product. Incorrect usage may lead to improper operation, and, at worst, can lead to damage ...
... Thank you very much for purchasing the SV-NET Driver. To use the product correctly, please read this document and all supplied documents carefully before installing, operating, maintaining, and inspecting the product. Incorrect usage may lead to improper operation, and, at worst, can lead to damage ...
The nuclear industry began with the Manhattan Project of World War
... electrostatic discharge affecting the Auxiliary Process Safety Cabinet (APC-S) in the South Korean Nuclear Power Plant 3 and 4, also known as Shin Kori 3 &4. The Auxiliary Process Safety Cabinet consists of the Acromag Signal Conditioners and is required to function and maintain structural integrity ...
... electrostatic discharge affecting the Auxiliary Process Safety Cabinet (APC-S) in the South Korean Nuclear Power Plant 3 and 4, also known as Shin Kori 3 &4. The Auxiliary Process Safety Cabinet consists of the Acromag Signal Conditioners and is required to function and maintain structural integrity ...
Modeling and Simulation of Transient Fault Response at
... owned by E.ON. One of these faults was a two phase short circuit fault, caused by colliding overhead lines and the other fault was a one phase to ground fault due to a lightning strike at the overhead line. Neither one of these faults caused any wind turbine to trip inside the farm, while other prod ...
... owned by E.ON. One of these faults was a two phase short circuit fault, caused by colliding overhead lines and the other fault was a one phase to ground fault due to a lightning strike at the overhead line. Neither one of these faults caused any wind turbine to trip inside the farm, while other prod ...
Profil 930-940 and TGV Analogue clocks instructions
... The clock is delivered in “Init” mode. To check this, ensure that, when the clock is powered, the LED (L) is blinking once per second. Otherwise, shunt the two pins (P) for more than 4 seconds. When inserting the batteries matching up the [+] and [-] symbols or switching on power supply (for TBT clo ...
... The clock is delivered in “Init” mode. To check this, ensure that, when the clock is powered, the LED (L) is blinking once per second. Otherwise, shunt the two pins (P) for more than 4 seconds. When inserting the batteries matching up the [+] and [-] symbols or switching on power supply (for TBT clo ...
Minimum Achievable Phase Noise of RC Oscillators
... is in equilibrium and can be replaced by a resistor of because its output conductance is dominantly determined by the conducting device (Fig. 5). In this model, the interstage noise effects are neglected.That is variations of the voltage on node A do not affect the voltage ...
... is in equilibrium and can be replaced by a resistor of because its output conductance is dominantly determined by the conducting device (Fig. 5). In this model, the interstage noise effects are neglected.That is variations of the voltage on node A do not affect the voltage ...
AC-DC Single Output Power Module
... ● Input voltage, Output current, Output power, ambient temperature and ambient humidity should be used within specifications, otherwise the unit will be damaged. ● For application equipment, which requires very high reliability (Nuclear related equipment, traffic control equipment, medical equipment, e ...
... ● Input voltage, Output current, Output power, ambient temperature and ambient humidity should be used within specifications, otherwise the unit will be damaged. ● For application equipment, which requires very high reliability (Nuclear related equipment, traffic control equipment, medical equipment, e ...
THS452x Very Low Power, Negative Rail Input
... These fully differential amplifiers feature accurate output common-mode control that allows for dc-coupling when driving analog-to-digital converters (ADCs). This control, coupled with an input common-mode range below the negative rail as well as rail-to-rail output, allows for easy interfacing betw ...
... These fully differential amplifiers feature accurate output common-mode control that allows for dc-coupling when driving analog-to-digital converters (ADCs). This control, coupled with an input common-mode range below the negative rail as well as rail-to-rail output, allows for easy interfacing betw ...
PAM8007
... on the line, a good low equivalent-series-resistance (ESR) ceramic capacitor, typically 1.0µF, placed as close as possible to the device VDD terminal works best. For filtering lower-frequency noise signals, a large capacitor of 10µF (ceramic) or greater placed near the audio power amplifier is recom ...
... on the line, a good low equivalent-series-resistance (ESR) ceramic capacitor, typically 1.0µF, placed as close as possible to the device VDD terminal works best. For filtering lower-frequency noise signals, a large capacitor of 10µF (ceramic) or greater placed near the audio power amplifier is recom ...
Praxis Script Programming Guide
... used are Delphi "VCL" components, other languages such as VBScript and JavaScript can be used to develop code if you wish. Most procedures and functions that are built into Delphi are also usable in a PRAXIS script, even when the script is programmed in languages other than DelphiScript. The Script ...
... used are Delphi "VCL" components, other languages such as VBScript and JavaScript can be used to develop code if you wish. Most procedures and functions that are built into Delphi are also usable in a PRAXIS script, even when the script is programmed in languages other than DelphiScript. The Script ...
A 3-V, 6-Bit C-2C Digital-to-Analog Converter Using Complementary
... C-2C versus 2240 pF for binary-weighted pF . This reduced switching capacitance results in faster DAC speed. In terms of the total capacitance in the DAC, the C-2C contains 4760 pF, whereas the binary-weighted contains 4410 pF. Thus, the C-2C DAC is only slightly larger in capacitor area than the bi ...
... C-2C versus 2240 pF for binary-weighted pF . This reduced switching capacitance results in faster DAC speed. In terms of the total capacitance in the DAC, the C-2C contains 4760 pF, whereas the binary-weighted contains 4410 pF. Thus, the C-2C DAC is only slightly larger in capacitor area than the bi ...
AFDD * Arcing Fault Protection
... Table 1c – Maximum allowed number of half-cycles within 0,5s for Un 230V AFDDs and Un 120V AFDDS Test arc current 1) (rms values) ...
... Table 1c – Maximum allowed number of half-cycles within 0,5s for Un 230V AFDDs and Un 120V AFDDS Test arc current 1) (rms values) ...
User Manual V1.03 - Scavenger Transmitter Module STM
... temperature sensors, or room operating panels including set point dial and occupancy button. It requires only a minimum number of external components and provides an integrated and calibrated temperature sensor. Power supply is provided by a small solar cell, an external energy harvester, or an exte ...
... temperature sensors, or room operating panels including set point dial and occupancy button. It requires only a minimum number of external components and provides an integrated and calibrated temperature sensor. Power supply is provided by a small solar cell, an external energy harvester, or an exte ...
EEC 126 Instrumentation 1-Theory - Unesco
... An analogue instrument is one in which the magnitude of the measured quantity is indicated by means of a pointer. Instruments of this category include moving coil instruments, moving noninstruments, oscilloscope, d.c and a.c bridges, megger etc. Analog instrumentas: An analog device is one which the ...
... An analogue instrument is one in which the magnitude of the measured quantity is indicated by means of a pointer. Instruments of this category include moving coil instruments, moving noninstruments, oscilloscope, d.c and a.c bridges, megger etc. Analog instrumentas: An analog device is one which the ...
MC33662, LIN 2.1 / SAEJ2602-2, LIN Physical Layer
... protocol, designed to support automotive networks in conjunction with a Controller Area Network (CAN). As the lowest level of a hierarchical network, LIN enables cost-effective communication with sensors and actuators when all the features of CAN are not required. The three 33662 versions are design ...
... protocol, designed to support automotive networks in conjunction with a Controller Area Network (CAN). As the lowest level of a hierarchical network, LIN enables cost-effective communication with sensors and actuators when all the features of CAN are not required. The three 33662 versions are design ...
digital 300 series - Teledyne Hastings Instruments
... The Digital 300 series instruments have a modular PCB design that allows for flexible connections for OEM applications. The standard configuration has the same 15 pin D connector as an analog 300 Series along with 2 parallel connectors (6P6C) for digital communication. The Digital 300 series will, n ...
... The Digital 300 series instruments have a modular PCB design that allows for flexible connections for OEM applications. The standard configuration has the same 15 pin D connector as an analog 300 Series along with 2 parallel connectors (6P6C) for digital communication. The Digital 300 series will, n ...