• Study Resource
  • Explore
    • Arts & Humanities
    • Business
    • Engineering & Technology
    • Foreign Language
    • History
    • Math
    • Science
    • Social Science

    Top subcategories

    • Advanced Math
    • Algebra
    • Basic Math
    • Calculus
    • Geometry
    • Linear Algebra
    • Pre-Algebra
    • Pre-Calculus
    • Statistics And Probability
    • Trigonometry
    • other →

    Top subcategories

    • Astronomy
    • Astrophysics
    • Biology
    • Chemistry
    • Earth Science
    • Environmental Science
    • Health Science
    • Physics
    • other →

    Top subcategories

    • Anthropology
    • Law
    • Political Science
    • Psychology
    • Sociology
    • other →

    Top subcategories

    • Accounting
    • Economics
    • Finance
    • Management
    • other →

    Top subcategories

    • Aerospace Engineering
    • Bioengineering
    • Chemical Engineering
    • Civil Engineering
    • Computer Science
    • Electrical Engineering
    • Industrial Engineering
    • Mechanical Engineering
    • Web Design
    • other →

    Top subcategories

    • Architecture
    • Communications
    • English
    • Gender Studies
    • Music
    • Performing Arts
    • Philosophy
    • Religious Studies
    • Writing
    • other →

    Top subcategories

    • Ancient History
    • European History
    • US History
    • World History
    • other →

    Top subcategories

    • Croatian
    • Czech
    • Finnish
    • Greek
    • Hindi
    • Japanese
    • Korean
    • Persian
    • Swedish
    • Turkish
    • other →
 
Profile Documents Logout
Upload
3rd Edition, Chapter 5
3rd Edition, Chapter 5

...  Framing, link access: ...
Micro controller Based Control of Three Phase Induction Motor
Micro controller Based Control of Three Phase Induction Motor

... DESIGN CO.NSIDERA TIOSS:- ...
Chapter 5 - Professor Dan Web
Chapter 5 - Professor Dan Web

...  Framing, link access: ...
Part 1 Module 9 Controller Area Network
Part 1 Module 9 Controller Area Network

... case of error an active error frame will be transmitted Error Passive : after detection of a fixed number of errors , the node reaches this state. messages will be received and transmitted, in case of error the node sends a passive error frame. Bus Off : the node is separated from CAN , neither tran ...
Marina Papatriantafilou – Network layer part 2 (Control Plane)
Marina Papatriantafilou – Network layer part 2 (Control Plane)

... • instantiation, implementation in the Internet routing protocols – RIP – OSPF – BGP • ICMP (control protocol) ...
Introduction
Introduction

... each of which is a separate collision domain. That is, they were designed to create more useable bandwidth. The purpose of a bridge is to filter traffic on a LAN—to keep local traffic local—yet allow connectivity to other parts (segments) of the LAN for traffic that is directed there. You might wond ...
DC GW - IETF
DC GW - IETF

... • VM movement and network rapid convergence in the presence of a large number of tenants and VMs  Optimize network resource utilization • Bandwidth utilization within data center, on the DC connection to the WAN, and across the WAN • FIB utilization at routers and switches • Control plane resource ...
M500DMA Dual Monitor Module
M500DMA Dual Monitor Module

Dynamic Tunneling Configuration for Network with Uni
Dynamic Tunneling Configuration for Network with Uni

... Virtual Link Module • Total of 120 lines: – if_ethersubr.c • ether_input(), ether_output() • Add encapsulation/decapsulation function ...
Labeled Optical Burst Switching and IP/WDM Integration Chunming Qiao 1
Labeled Optical Burst Switching and IP/WDM Integration Chunming Qiao 1

... – at least 10 x increase in users, and uses per user – at least 100 x increase in BW per use: • current web pages contain 10 KB each • MP3 & MPEG files are 5 & 40 MB each, resp. ...
Practice Questions: Congestion Control and Queuing COS 461: Computer Networks
Practice Questions: Congestion Control and Queuing COS 461: Computer Networks

... Assume that the network has an MSS of 1000 bytes and the roundtrip-time between sender and receiver of 100 milliseconds. Assume at time 0 the sender attempts to open the connection. Also assume that the sender can “write” a full window’s worth of data instantaneously, so the only latency you need to ...
AdL Subsystems part 1 - DCC
AdL Subsystems part 1 - DCC

... z Motivation: » Arm length fluctuations are dominated by low frequency motions, f < 0.5 Hz; motion in this band (~100 nm-rms) not expected to be much lower than in initial LIGO (@LLO, w/ HEPI) » Reducing this rms by another factor of 10-100x could: – Make lock acquisition much simpler – Enable lock ...
pptx - Cornell Computer Science
pptx - Cornell Computer Science

... • Next Monday, Review chapter 4 from the book, Network Layer – We will also briefly discuss data center topologies ...
Document
Document

... providing flawless operation even in the complicated electromagnetic environment. The frequency tuning algorithm implemented in NLJD automatically selects the probing signal frequency such that the noise level in the 2nd harmonic receiving channel is held minimal, while digital processing of a demod ...
Network Programming
Network Programming

... Type: The 1-byte type element helps to define the kind of ICMP message that is present in the packet. Many types of ICMP packets are used to send the control request messages to the remote hosts. Each message type has its own format and data requirements. Code: An assorted ICMP message type requires ...
The Token Based Switch: per-packet access authorisation to optical shortcuts
The Token Based Switch: per-packet access authorisation to optical shortcuts

... it separates data from control, keeping the fast-path as involves shifting packet data to make space for the opefficient as possible. Third, FFPF avoids packet copies tion field. It also involves re-computing its IP checksum by way of a ‘smart’ buffer management system. Fourth, because of the IP hea ...
Latest Advances in Optical Transport for Research and
Latest Advances in Optical Transport for Research and

IEEE C802.16n-11/0127r3 Project Title
IEEE C802.16n-11/0127r3 Project Title

... 3) HR-MS should get the value for the duration of back-off from a window, for example, from a window of [wmin, wmax], the size of window can be adjusted based on the traffic of networks. The value of Wmin and Wmax are TBD. For the FCH, it takes the same format as defined in 8.4.4.4. For the DL-MAP, ...
OHMS_LAW_New_PhET
OHMS_LAW_New_PhET

... and resistance was discovered by Georg Simon Ohm. The relationship and the unit of electrical resistance were both named for him to commemorate this contribution to physics. One statement of Ohm’s law is that the current through a resistor is proportional to the voltage across the resistor and inver ...
Data Source Configuration Guide for McAfee Network Security
Data Source Configuration Guide for McAfee Network Security

Transmission Control Protocol
Transmission Control Protocol

Software Design
Software Design

...  Problem Statements  The transmission network was single, cannot be used once the environment is not good enough;  The outdoor power was not durable enough;  The suit was too expensive for wide range plant in destination areas. ...
05 – Internet Protocol
05 – Internet Protocol

... each router. A packet is discarded by a router if TTL is zero. ...
Slides - Indico
Slides - Indico

... Study of different extended RPC-based calorimeters ...
3rd Edition, Chapter 5
3rd Edition, Chapter 5

...  framing, link access: ...
< 1 ... 83 84 85 86 87 88 89 90 91 ... 258 >

UniPro protocol stack

In mobile-telephone technology, the UniPro protocol stack follows the architecture of the classical OSI Reference Model. In UniPro, the OSI Physical Layer is split into two sublayers: Layer 1 (the actual physical layer) and Layer 1.5 (the PHY Adapter layer) which abstracts from differences between alternative Layer 1 technologies. The actual physical layer is a separate specification as the various PHY options are reused in other MIPI Alliance specifications.The UniPro specification itself covers Layers 1.5, 2, 3, 4 and the DME (Device Management Entity). The Application Layer (LA) is out of scope because different uses of UniPro will require different LA protocols. The Physical Layer (L1) is covered in separate MIPI specifications in order to allow the PHY to be reused by other (less generic) protocols if needed.OSI Layers 5 (Session) and 6 (Presentation) are, where applicable, counted as part of the Application Layer.
  • studyres.com © 2025
  • DMCA
  • Privacy
  • Terms
  • Report