model 6400a sulfur dioxide analyzer
... 5.1 INDEX TO FRONT PANEL MENUS .................................................................................. 5-1 5.1.1 Sample Menu .................................................................................................... 5-3 5.1.2 Set-Up Menu ......................................... ...
... 5.1 INDEX TO FRONT PANEL MENUS .................................................................................. 5-1 5.1.1 Sample Menu .................................................................................................... 5-3 5.1.2 Set-Up Menu ......................................... ...
ENHANCEMENT OF DEFECT DIAGNOSIS BASED ON THE ANALYSIS OF CMOS DUT BEHAVIOUR
... Figure 3.17. Predicted vs. measured IDDQ values in the presence of downstream current......................... 60 Figure 3.18. Graphical representation of the quality parameters. ............................................................. 61 Figure 3.19. Diagnosis flow for bridging defects. ...... ...
... Figure 3.17. Predicted vs. measured IDDQ values in the presence of downstream current......................... 60 Figure 3.18. Graphical representation of the quality parameters. ............................................................. 61 Figure 3.19. Diagnosis flow for bridging defects. ...... ...
PDF - This Chapter (1.46 MB)
... Rather, these terms, as well as "Path Protected Mesh Network" and "PPMN," refer generally to Cisco's path protection feature, whicvmh may be used in any topological network configuration. Cisco does not recommend using its Linear Multiplex Section protection feature in any particular topological net ...
... Rather, these terms, as well as "Path Protected Mesh Network" and "PPMN," refer generally to Cisco's path protection feature, whicvmh may be used in any topological network configuration. Cisco does not recommend using its Linear Multiplex Section protection feature in any particular topological net ...
Published SFF Committee documentation may be purchased in hard copy or... SFF specifications are available at
... The first use of these disk drives was in specific applications such as laptop portable computers and system integrators worked individually with vendors to develop the packaging. The result was wide diversity, and incompatibility. The problems faced by integrators, device suppliers, and component s ...
... The first use of these disk drives was in specific applications such as laptop portable computers and system integrators worked individually with vendors to develop the packaging. The result was wide diversity, and incompatibility. The problems faced by integrators, device suppliers, and component s ...
User Guide of ANSI/ESDA/JEDEC JS
... and extra effort for maintaining two standards for the same test. However, JS-001-2010 did not address several important technical issues. To merge the two documents, a number of technical challenges involving the HBM test method, which have emerged over the last several years, were not addressed. T ...
... and extra effort for maintaining two standards for the same test. However, JS-001-2010 did not address several important technical issues. To merge the two documents, a number of technical challenges involving the HBM test method, which have emerged over the last several years, were not addressed. T ...
LP3470 - Texas Instruments
... The LP3470 is a micropower CMOS voltage supervisor that is ideal for use in battery-powered microprocessor and other digital systems. It is small in size and provides maximum adjustability for power-on-reset (POR) and supervisory functions, making it a good solution in a variety of applications. The ...
... The LP3470 is a micropower CMOS voltage supervisor that is ideal for use in battery-powered microprocessor and other digital systems. It is small in size and provides maximum adjustability for power-on-reset (POR) and supervisory functions, making it a good solution in a variety of applications. The ...
MASTER SPECIFICATIONS Division 26
... Normal maintenance shall not require the removal of protective guards from adjacent equipment. Install equipment as close as practical to the locations shown on the Drawings. 1. Where the Cleveland Clinic determines that the Contractor has installed equipment not conveniently accessible for operatio ...
... Normal maintenance shall not require the removal of protective guards from adjacent equipment. Install equipment as close as practical to the locations shown on the Drawings. 1. Where the Cleveland Clinic determines that the Contractor has installed equipment not conveniently accessible for operatio ...
DRV2667 - Texas Instruments
... and begin playing the waveform after the 2-ms internal startup procedure. When the data flow stops or the FIFO under-runs, the device will automatically enter a pop-less shutdown procedure. The DRV2667 device also includes waveform memory to store and recall waveforms with minimal latency as well as ...
... and begin playing the waveform after the 2-ms internal startup procedure. When the data flow stops or the FIFO under-runs, the device will automatically enter a pop-less shutdown procedure. The DRV2667 device also includes waveform memory to store and recall waveforms with minimal latency as well as ...
APPLICATION NOTE AN255-02 I²C / SMBus REPEATERS, HUBS AND EXPANDERS
... contention with bus masters located on any segment. They are multi-directional and require no direction control. Operational voltage supply is 3.0 V to 3.6 V with I/Os that are 6.0 V tolerant allowing easy interfacing of 3.3 V and 5 V devices. Operational temperature range is -40 ºC to 85 ºC. The P8 ...
... contention with bus masters located on any segment. They are multi-directional and require no direction control. Operational voltage supply is 3.0 V to 3.6 V with I/Os that are 6.0 V tolerant allowing easy interfacing of 3.3 V and 5 V devices. Operational temperature range is -40 ºC to 85 ºC. The P8 ...
AN11267 EMC and system level ESD design guidelines for LCD
... ElectroMagnetic Compatibility (EMC) and ElectroStatic Discharge (ESD) immunity must be considered in the early design phase of a system. This is also true for the application of liquid crystal displays and the accompanying drivers. If ignored, problems encountered later during testing or in the fiel ...
... ElectroMagnetic Compatibility (EMC) and ElectroStatic Discharge (ESD) immunity must be considered in the early design phase of a system. This is also true for the application of liquid crystal displays and the accompanying drivers. If ignored, problems encountered later during testing or in the fiel ...
Measurements and Instrumentation Objective Type Questions
... 101. An instrument transformer is used to extend the range of (a) induction instrument (b) electrostatic instrument (c) moving coil instrument (d) any of the above Ans: a 102. Wattmeter cannot be designed on the principle of (a) electrostatic instrument (b) thermocouple instrument (c) moving iron i ...
... 101. An instrument transformer is used to extend the range of (a) induction instrument (b) electrostatic instrument (c) moving coil instrument (d) any of the above Ans: a 102. Wattmeter cannot be designed on the principle of (a) electrostatic instrument (b) thermocouple instrument (c) moving iron i ...
TPS3851-Q1 High-Accuracy Voltage Supervisor
... 7 Detailed Description 7.1 Overview The TPS3851-Q1 is a high-accuracy voltage supervisor with an integrated watchdog timer. This device includes a precision undervoltage supervisor with a threshold that achieves 0.8% accuracy over the specified temperature range of –40°C to +125°C. In addition, the ...
... 7 Detailed Description 7.1 Overview The TPS3851-Q1 is a high-accuracy voltage supervisor with an integrated watchdog timer. This device includes a precision undervoltage supervisor with a threshold that achieves 0.8% accuracy over the specified temperature range of –40°C to +125°C. In addition, the ...
bq76200 High Voltage Battery Pack Front-End
... implementation, a system-side processor can always communicate with the monitor or micro-controller (MCU) within the battery pack, regardless of whether the FETs are on or off — this is not easily supported in a low-side switching architecture due to the lack of a shared ground reference. One key be ...
... implementation, a system-side processor can always communicate with the monitor or micro-controller (MCU) within the battery pack, regardless of whether the FETs are on or off — this is not easily supported in a low-side switching architecture due to the lack of a shared ground reference. One key be ...
Institutionen för systemteknik
... Rodon is a diagnostic tool developed by Sörman. SAAB’s interest in Rodon regards the possibility to use the tool for development and operations of aircraft systems. The main goal of this thesis was to evaluate the capacity of Rodon and determine how SAAB can use the diagnostic tool during developmen ...
... Rodon is a diagnostic tool developed by Sörman. SAAB’s interest in Rodon regards the possibility to use the tool for development and operations of aircraft systems. The main goal of this thesis was to evaluate the capacity of Rodon and determine how SAAB can use the diagnostic tool during developmen ...
PowerScout™ 24 ViewPoint
... PowerScout 24 Serial/PowerScout 24 Ethernet The PowerScout 24 is capable of reading eight 3-phase or 24 single-phase services at a time and is mounted near the breakers. It is typically used for long-term monitoring of electrical systems. Up to 127 PowerScout 24 meters may be connected to a single B ...
... PowerScout 24 Serial/PowerScout 24 Ethernet The PowerScout 24 is capable of reading eight 3-phase or 24 single-phase services at a time and is mounted near the breakers. It is typically used for long-term monitoring of electrical systems. Up to 127 PowerScout 24 meters may be connected to a single B ...
Manual: Smart Wireless THUM™ Adapter
... The THUM Adapter communicates and derives power from a standard 4-20 mA/HART loop. The THUM Adapter causes a small voltage drop on the loop which is linear from 2.25 V at 3.5 mA to 1.2 V at 25 mA. Under fault conditions, the maximum voltage drop is 2.5 V. The THUM Adapter will not affect the 4-20 mA ...
... The THUM Adapter communicates and derives power from a standard 4-20 mA/HART loop. The THUM Adapter causes a small voltage drop on the loop which is linear from 2.25 V at 3.5 mA to 1.2 V at 25 mA. Under fault conditions, the maximum voltage drop is 2.5 V. The THUM Adapter will not affect the 4-20 mA ...
June 13, 2011 - Telecommunications Industry Association
... WTO. This year, ITA expansion would complement one of APEC’s themes for 2011 -innovation and ICT usage. The Federal Register Notice asks: “(1) Which additional information and communications technology (ICT) products the United States should seek to include and provide duty-free treatment under the ...
... WTO. This year, ITA expansion would complement one of APEC’s themes for 2011 -innovation and ICT usage. The Federal Register Notice asks: “(1) Which additional information and communications technology (ICT) products the United States should seek to include and provide duty-free treatment under the ...
Automatic test equipment
Automatic or automated test equipment (ATE) is any apparatus that performs tests on a device, known as the Device Under Test (DUT), Equipment Under Test (EUT) or Unit Under Test (UUT), using automation to quickly perform measurements and evaluate the test results. An ATE can be a simple computer controlled digital multimeter, or a complicated system containing dozens of complex test instruments (real or simulated electronic test equipment) capable of automatically testing and diagnosing faults in sophisticated electronic packaged parts or on Wafer testing, including System-On-Chips and Integrated circuits.