Download ln-10 bench model - Lincoln Electric

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Transcript
B-5
OPERATION
Minimum Limits Setting Mode Selection
The LN-10 control is set up for allowing a minimum weld
WFS and arc voltage setting for each procedure by setting S2 DIP Switch 6 (Labeled “-”).
S2 switch 6 ON - Minimum Limits Setting mode ON
M 4 S R + ON
1
2
3
4
5
6
7
8
S2
S2
When Minimum Limits Setting mode is selected, all keys
except the procedure key are disabled. Welding is not
allowed while in this mode. The mode is used for minimum limits setup only. See “Limits Setting Mode” in this
section for the correct procedure for setting the WFS and
voltage limits.
S2 switch 6 OFF = Minimum Limits Setting mode OFF
(As shipped)
M 4 S R + ON
1
2
3
4
5
6
7
8
S2
S2
LN-10
B-5