Download SP.764 Fall 04 - Problem Set 4

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Document related concepts

Oscilloscope history wikipedia , lookup

Integrating ADC wikipedia , lookup

CMOS wikipedia , lookup

Valve RF amplifier wikipedia , lookup

Immunity-aware programming wikipedia , lookup

TRIAC wikipedia , lookup

Resistive opto-isolator wikipedia , lookup

Surge protector wikipedia , lookup

Power electronics wikipedia , lookup

Transistor–transistor logic wikipedia , lookup

Wilson current mirror wikipedia , lookup

Power MOSFET wikipedia , lookup

Current source wikipedia , lookup

Schmitt trigger wikipedia , lookup

Voltage regulator wikipedia , lookup

Operational amplifier wikipedia , lookup

Switched-mode power supply wikipedia , lookup

Ohm's law wikipedia , lookup

Opto-isolator wikipedia , lookup

Current mirror wikipedia , lookup

Network analysis (electrical circuits) wikipedia , lookup

Rectiverter wikipedia , lookup

Transcript
SP.764 Fall 04 - Problem Set 4 Assume that the transistor has
a 0 V to 5 V sine wave.
=100 and that the AC wave generator is producing
1. Sketch a plot the output of the AC wave generator as a function of time.
2. Below that, sketch a plot of the base current (equal to the current through the 5k
resistor) as a function of time.
3. Below that, sketch a plot of the current through the 100 Ohm resistor, as a
function of time, assuming that the input voltage is +35.6 V.
4. Below that, sketch a plot of the voltage at the point A as a function of time.
5. Repeat steps 1-4 for the case where the input voltage is +5.6 Volts.
MIT OpenCourseWare
http://ocw.mit.edu
EC.S06 / EC.S11 Practical Electronics
Fall 2004
For information about citing these materials or our Terms of Use, visit: http://ocw.mit.edu/terms.