Download tectonics

LECTURE 11. PLATE TECTONICS; DIASTROPHISM
Continental Drift
The theory of continental drift formulated by Alfred
Wegener in the early 20th century is the forerunner to the
modern theory of plate tectonics. It was based on the
observation that many continents "fit together like a
jigsaw puzzle" (e.g. S. America and Africa) and,
if joined back together, many similarities exist in rock
types, geologic structures and plant and animal fossils.
Harry Williams, Earth Science
1
North and South America, Europe and Africa all fit
together like pieces of a jigsaw puzzle. Mountain ranges,
rock types and fossils also match up.
Harry Williams, Earth Science
2
Harry Williams, Earth Science
3
PANGAEA
Wegener proposed that 200 million years ago all
continents were joined together in a supercontinent he
termed PANGAEA (“All land”, consisting of N. America
and Eurasia to the north - LAURASIA; and the southern
continents to the south - GONDWANALAND). Pangaea
broke apart and the continents drifted, like icebergs in
the sea, "bulldozing" their way through the denser
oceanic crust below.
Harry Williams, Earth Science
4
Pangaea
The continents
today
Harry Williams, Earth Science
5
There were two major criticisms of Wegener's
theory - firstly, no explanation was given for the driving
force behind continental drift, and secondly, the oceanic
crust is far too dense and rigid to allow the continents to
"push" their way through it. The theory was largely
dismissed. The explanation for the drifting of the
continents had to wait until the 1940's and 1950's when
exploration of the ocean floors (offshoot of submarine
detection) resulted in the new theory of plate tectonics.
Harry Williams, Earth Science
6
PLATE TECTONICS Recap: the upper 70 km of
MANTLE and CRUST = the rigid LITHOSPHERE;
beneath this is the partially molten ASTHENOSPHERE.
Harry Williams, Earth Science
7
The lithosphere is not continuous, but is fractured into a
number of LITHOSPHERIC PLATES (about 7 major plates).
The plates are moving, as shown by the arrows, at typical
velocities of 1 -10 cm/year (fingernail growth). It is the
movement of these plates and the interaction between them
that is known as PLATE TECTONICS.
Harry Williams, Earth Science
8
SEA FLOOR SPREADING BY CONVECTION
The exact driving force of plate motion still isn't certain, but
the most likely explanation is that the plates are driven by
convection currents in the asthenosphere. Plates spread
outwards from mid-oceanic ridges where new ocean floor is
created, and return into the earth at subduction zones were
plates sink and melt.
Subduction zone
Mid-oceanic ridge
Subduction zone
Sea-floor spreading
Convection
Harry Williams, Earth Science
9
Much important geologic activity, including earthquakes
and volcanoes, is found at
PLATE BOUNDARIES
3 types:
Divergent – plates move away from each other.
Convergent – plates move towards each other.
Transform fault – plates slide past each other.
Harry Williams, Earth Science
10
Divergent. Mid-oceanic ridges; shallow earth quakes, volcanic
eruptions -> new sea floor consisting of BASALT (magma from
asthenosphere forms basalt). Plate movement is initiated at midoceanic ridges; continents are carried along on top of plates;
supporting evidence from "hot spots".
Harry Williams, Earth Science
11
Harry Williams, Earth Science
12
A hot spot is a stationary plume of rising magma from the
Mantle, as this periodically erupts through the overlying
plate, a chain of volcanoes is formed in the direction of plate
motion.
E.g. Hawaiian islands
Harry Williams, Earth Science
13
Convergent. Subduction zones; earthquakes occur down the
subduction zone; volcanism from melting of subducted plate e.g.
Cascades, Mt. St. Helens. Possible collisions include: ocean plate ocean plate > island arcs e.g. Japan, Aleutian Islands. Ocean plate continental plate collision > volcanic arc e.g. Cascade Range;
Andes. Continent-continent collision > mountains e.g. Himalayas.
Harry Williams, Earth Science
14
Island Arc. E.g. Japan.
Earthquakes take place
down the WadatiBenioff zone (part of
subduction zone where
earthquakes occur).
Harry Williams, Earth Science
15
Juan de
Fuca plate
Volcanic Arc: Cascade
Range.
Harry Williams, Earth Science
16
Continent-continent collision;
suture zone.
Harry Williams, Earth Science
17
Transform
fault - plates
slide past
each other;
large
earthquakes
are common
e.g. San
Andreas
fault.
Harry Williams, Earth Science
18
1989 Loma Prieta
earthquake.
Harry Williams, Earth Science
19
Distribution of magnitude 5+ earthquakes, 1980-1990. The pattern
closely matches plate boundaries, particularly subduction zones and
transform faults.
Harry Williams, Earth Science
20
Distribution of major volcanoes. The pattern closely matches plate
boundaries, particularly subduction zones. Note the Pacific “Ring
of fire”.
Harry Williams, Earth Science
21
Diastrophism
Central to the theory of plate tectonics is the idea that the
crust is subject to both vertical and horizontal movements.
These movements can deform the crust by tilting it,
breaking it and bending it.
Tilted Beds: angle
of tilt is the dip ranges from 0
(horizontal) to 90o
(vertical).
Orientation of the
outcrop is the
strike e.g. northsouth, east-west
etc.
Harry Williams, Earth Science
22
Steeply dipping rock strata.
Harry Williams, Earth Science
23
Folded Beds: Rocks at depth under great pressure tend to bend
rather than break when subjected to stress, producing folds.
Main types = syncline, anticline, monocline, overturned fold.
Folds are often exposed at surface by erosion of overlying rocks,
typically ridges and valleys are formed e.g. Appalachians.
Harry Williams, Earth Science
24
The ridges and
valleys of the
Appalachians
are exposed
folds.
Harry Williams, Earth Science
25
Faults: Brittle rock (e.g. near surface) tends to break rather
than bend when subjected to stress -> fault.
Harry Williams, Earth Science
26
Harry Williams, Earth Science
27
Harry Williams, Earth Science
28
(Same as a transform
fault)
Harry Williams, Earth Science
29
Sometimes, the vertical movement of rock in a fault can result
in a cliff-like feature on the surface of the Earth - a FAULT
SCARP.
Harry Williams, Earth Science
30
Blocks of crust can be uplifted and depressed along faults
forming GRABENS and HORSTS. e.g. Death Valley is a
graben surrounded by horsts on either side.
Harry Williams, Earth Science
31
Death Valley, California. The flat valley floor
occupies a graben and is filled with sediment. The
horst rises abruptly on the far side of the valley.
Harry Williams, Earth Science
32