Survey
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Download Specification of Toe Grounder
Document related concepts
no text concepts found
Transcript
UNIT 6, RIVERGATE RIVERMEAD IND ESTATE SWINDON WILTS SN5 7ET BONDLINE ELECTRONICS LIMITED TEL (01793) 511000 FAX (01793) 514142 E-MAIL [email protected] Specification of Toe Grounder Product Code: TG2 Construction Constructed using a two layer rubber sheet, insulative white and conductive black, attached to ¾” elastic garter, with one meg ohm resistor and conductive tab, assembled with plastic connectors and hook and loop tape for adjustable feature. Rubber is punched with flat washer to the plastic connector through ultrasonic sealing. Electrical Properties Conductivity: 4 Black rubber surface: 8 x 10 ohms 12 White rubber surface: 1 x 10 ohms Moulded Resistor: 1 meg ohm ± 20% Conductive tab: 160 ohm/inch (max) Colour Available in black/white rubber. Conductive tab with silver yarn, elastic garter and hook and loop tape’s colours are available on request. Markings With customer logo and date code. Dimmensions Cutting length: black garter – 305 + 2mm garter width – 19 ~ 20mm Cutting length: rubber – 147 + 2mm rubber width – 35 + 1mm Cutting length: tab – 432 + 2mm tab width – 12 ~ 13mm Cutting length: hook tape – 114 + 2mm Cutting length: loop tape 140+ 2mm Hook and loop width – 19 ~ 20mm Hardware All metal parts shall show no evidence of corrosion and rust after 24 hours submersion to salt solution. Preferably, made from stainless steel or brass alloy plated with nickel. Plastic Parts Made of antistatic nylon material. The information contained within this spec sheet is for guidance only. We make no warranties expressed or implied and assume no liability regarding any use of this information.
