Download SRM-007t

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Document related concepts

Flip-flop (electronics) wikipedia , lookup

Analog-to-digital converter wikipedia , lookup

Test probe wikipedia , lookup

Loudspeaker wikipedia , lookup

Power MOSFET wikipedia , lookup

Power dividers and directional couplers wikipedia , lookup

Klystron wikipedia , lookup

Antique radio wikipedia , lookup

Oscilloscope history wikipedia , lookup

Audio power wikipedia , lookup

Integrating ADC wikipedia , lookup

Beam-index tube wikipedia , lookup

List of vacuum tubes wikipedia , lookup

Wilson current mirror wikipedia , lookup

CMOS wikipedia , lookup

Index of electronics articles wikipedia , lookup

Zobel network wikipedia , lookup

Distortion (music) wikipedia , lookup

Voltage regulator wikipedia , lookup

Negative-feedback amplifier wikipedia , lookup

Two-port network wikipedia , lookup

Wien bridge oscillator wikipedia , lookup

Power electronics wikipedia , lookup

Amplifier wikipedia , lookup

Resistive opto-isolator wikipedia , lookup

Schmitt trigger wikipedia , lookup

Regenerative circuit wikipedia , lookup

Current mirror wikipedia , lookup

Operational amplifier wikipedia , lookup

Transistor–transistor logic wikipedia , lookup

Switched-mode power supply wikipedia , lookup

Radio transmitter design wikipedia , lookup

Opto-isolator wikipedia , lookup

Valve RF amplifier wikipedia , lookup

Rectiverter wikipedia , lookup

Transcript
electrostatic audio products
SRM-007t
VACUUM TUBE DRIVER UNIT
FEATURES
SPECIFICATIONS
■ PARALLEL CONNECTED DUAL TRIODE VACUUM TUBE OUTPUT STAGE
The SRM-007t uses the widely respected STAX original output stage
using the high voltage 6FQ7/6CG7 output tubes in parallel. The low
impedance of this output stage is most effective for driving STAX
Earspeakers.
■ Type
■ NON-INDUCTIVE WIREWOUND LOAD RESISTOR
Because of the detrimental effect on sound quality by the load resistor
STAX have adopted a non-inductive Dale wirewound resistor.
Favoured by audiophiles the Dale resistor along with the parallel
6FQ7/6CG7 provides significantly improved dynamics and transparency.
■ BALANCED CIRCUIT WITH FIRST STAGE LOW NOISE DUAL FET
The SRM-007t features a pure balanced circuit with no transformer or
inverting amplifier in the signal path. A high quality 4 - Gang volume
control is used for the XLR balanced input to minimize sonic degradation.
■ HYBRID DC AMPLIFIER CONFIGURATION
By eliminating undesirable coupling capacitors throughout the circuit
through the use of a hybrid DC configuration with transistor and valve
STAX have achieved pure uncoloured sound. LISTEN!
STAX LIMITED
293-1 Fujikubo, Miyoshi-cho, Iruma-gun, Saitama Prefecture Japan 354-0041
Copyright (C)1999 STAX Ltd. All rights reserved.
■ Frequency Response
: Vacuum Tube Class-A DC direct Driver Unit
for Earspeakers
: DC~70KHz/+0, -1.5dB
■ Gain
■ Harmonic Distortion
: 60dB (Input 100mV→Output 100V)
: Less than 0.01%
■ Inputs
■ Maximum Output Voltage
■ Bias Voltage
■ Power Supply
■ Power Consumption
: RCA×2, XLR×1 (Balanced Input)
: 340V r.m.s. (1KHz)
: 230V×1, 580V×2)
: AC117V, 220V, 240V (50/60Hz)
: 55W
■ Operating Temperature
: 0~35 ℃ (No icing condition)
■ Dimensions
: 195(W)×103(H)×420(D) mm
■ Weight
■ Vacuum tube employed
: 4.7Kg
: 6FQ7/6CG7 × 4 PCS
(100Vr.m.s. about for 1 SR-007 Headphone)
(1KHz, 100Vr.m.s. to drive 1 SR-007 Headphone)
Including Knob (20mm) & RCA Jacks (10mm)
Specifications and design are subject to change without notice for improvements.
Tel :81-492-58-3988
Fax :81-492-58-2659
Home Page: http://www.stax.co.jp
E-mail
: [email protected]