Download AXAS-A - Ketek

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Document related concepts

Ohm's law wikipedia , lookup

Islanding wikipedia , lookup

Power inverter wikipedia , lookup

History of electric power transmission wikipedia , lookup

Current source wikipedia , lookup

Pulse-width modulation wikipedia , lookup

Variable-frequency drive wikipedia , lookup

Distribution management system wikipedia , lookup

Triode wikipedia , lookup

Rectifier wikipedia , lookup

Voltage regulator wikipedia , lookup

Surge protector wikipedia , lookup

Stray voltage wikipedia , lookup

Buck converter wikipedia , lookup

Voltage optimisation wikipedia , lookup

Metadyne wikipedia , lookup

Power MOSFET wikipedia , lookup

Alternating current wikipedia , lookup

Switched-mode power supply wikipedia , lookup

Power electronics wikipedia , lookup

Current mirror wikipedia , lookup

Mains electricity wikipedia , lookup

Resistive opto-isolator wikipedia , lookup

Opto-isolator wikipedia , lookup

Transcript
KETEK VITUS SDD Manual
Fig. 15: Operating voltages filtering block diagram
In case of AXAS-A these filters are included. Additionally there are three potentiometers available to
adjust the three necessary SDD voltages (R1, RX and Back) to the appropriate voltages necessary for
each single SDD.
Before switching on the system, the output-signal of the preamplifier and the shaped signal should be
connected to an oscilloscope.
The preamplifier operating voltage must be switched on first.
The detector voltages should be switched on in the following order:
R1 – RX – Back
The voltages to be applied must be set according to the detector datasheet. Typical currents flowing
are several µA through Ring 1 and Ring X (voltage divider) and approx. 1nA for the back contact if the
back voltage is applied. R1 and RX currents should be equal!
After switching on the detector voltages the signal of the preamplifier should show a ramp. The ramp
period depends on the chip temperature. At -35°C the ramp period should be in the range of several
microseconds.
Rev. 1
Page 18 of 26
KETEK GmbH