Download Datasheet

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Document related concepts

Electric power system wikipedia , lookup

Power inverter wikipedia , lookup

Immunity-aware programming wikipedia , lookup

Pulse-width modulation wikipedia , lookup

Variable-frequency drive wikipedia , lookup

Rectifier wikipedia , lookup

Three-phase electric power wikipedia , lookup

Power engineering wikipedia , lookup

Power over Ethernet wikipedia , lookup

Metadyne wikipedia , lookup

Amtrak's 25 Hz traction power system wikipedia , lookup

Buck converter wikipedia , lookup

Surge protector wikipedia , lookup

Stray voltage wikipedia , lookup

Power electronics wikipedia , lookup

Electrical substation wikipedia , lookup

Opto-isolator wikipedia , lookup

History of electric power transmission wikipedia , lookup

Electrical ballast wikipedia , lookup

Power MOSFET wikipedia , lookup

Distribution management system wikipedia , lookup

Alternating current wikipedia , lookup

Switched-mode power supply wikipedia , lookup

AC adapter wikipedia , lookup

Voltage optimisation wikipedia , lookup

Mains electricity wikipedia , lookup

Transcript
Gateway KNX-DALI
GW610200
v1.1
General description
Installation
The device GW610200 is a gateway to control lights with
DALI protocol in a similar way to any KNX dimmer. It allows to
control a maximum of 64 DALI ballasts in two channels with
broadcast commands, that is, all of them simultaneously per
channel.
It includes an integrated power supply to feed the DALI bus, it
also has 2 inputs to control each channel by conventional
pushbuttons and the possibility to configure up to 16 scenes.
With this device it is possible to control the DALI lights via any
KNX device such as touch screens, pushbuttons, etc. being
possible to use it also as a stand-alone solution, without
needing a home automation installation.
Technical information
Main power
supply
Max. power
consumption
KNX supply
KNX
consumption
Connections
DALI voltage
Max. number of
DALI ballasts
Inputs
Inputs max.
cable distance
Mounting /size
Environment
temperature
range
Regulation
85 - 265 VAC @ 50 / 60 Hz
0,5W @ 230Vac
29Vdc from KNX bus
5mA from KNX bus
KNX bus connection terminal.
Screw terminal block for main
supply and DALI.
16 Vdc
Channel 1 + Channel 2 ≤ 64
2 safety extra-low voltage inputs
(SELV)
30 meters
DIN rail / 4 modules
Operation: from -10ºC to 55ºC
Storage: from -30ºC to 60ºC
Transportation: from -30ºC to
60ºC.
According to the directives of
electromagnetic compatibility and
low voltage. EN 50090-2-2/UNEEN 61000-6-3:2007/UNE-EN
61000-6-1:2007/UNE-EN 61010-1
Observations
It is essential to switch off the power and restart the gateway
once all DALI ballasts are connected to the channel for proper
operation.
Install low voltage lines (KNX bus and inputs) in a ducting
separated from the power (230V) and outputs lines ducting to
ensure there is enough insulation and avoid interferences.
Do not connect the main voltages (230V) or any other
external voltages to any point of the KNX bus or inputs.
More information
Ingenium, Ingeniería y Domótica S.L. - Parque Tecnológico de Asturias, Parcela 50 - 33428 Llanera, Asturias, Spain
T (+34) 985 757 195 - [email protected] - www.besknx.com - www.ingeniumsl.com