Download Visio-ME-AGS (Honda EM3800SX, EM5000SX, EM6500SX) Rev 3

ON
inside
12/24/48V
These 5 adjustments
are not active when a
ME-RC Remote
Control with revision
1.5 or higher is used.
They are set using
displays under the
AGS button on the
remote control.
Input DC Voltage
jumper - set to
Monitored battery
bank voltage
(on 48V setting)
1 2 3 4
inside
ME-AGS wiring diagram –
For Honda Generator (EM3800SX • EM5000SX • EM6500SX with Remote Control Box)
Dip-switch
configuration
(3-Wire mode)
Remote control
connector
DC
TERMINALS
G
W/
Bl
Honda™ Remote
Control Box
PILOT
LAMP
W
G
Y
P
RUN TIME HOURS
STOP
Timing Information
STOP Time
START Time
Time between start attempts
Delay Time
10 seconds
10 seconds
2 minutes
4 seconds
START SWITCH
STOP
Delay
START
STOP SWITCH
Relay 2
(pins 6 & 7)
W/Bu
Ground
Relay 1
(pins 5 & 6)
G
Battery
Bank
(monitored
for gen
turn on)
Y
GEN
BATTERY
W/Bu
5 amp
fuse
P
Gen Run Signal
(input to pin 2 must
be 10 to 40 DC volts
only while generator
is running); this
can be the generator
hour-meter or a
12vdc pilot/run light
Honda Generator
Remote Control Box
ME-AGS relay timing for 3-Wire Mode
Magnum Energy, Inc. provides this diagram to assist in the installation of the Auto-Generator Start controller.
Since the use of this diagram and the conditions or methods of installation, operation and use are beyond the
control of Magnum Energy, Inc., we do not assume responsibility and expressly disclaim liability for loss,
damage or expense arising out of the installation, operation and use of this unit.
3-23-2010