Download Tower Dryer

Safety Section
General Safety Practices
The safety alert symbol means “ATTENTION! Be Alert! Your personal safety is involved.”
This symbol draws your attention to important instructions concerning your personal
safety. Read the messages carefully to avoid personal injury or death.
SAFETY SIGNAL WORDS
On safety decals, three signal words are used with corresponding colors of red, orange, and yellow to
indicate hazard intensity. Definitions are as follows:
(red) indicates an imminently hazardous situation, which, if not avoided, will result
in death or serious injury.
WARNING (orange) indicates a potentially hazardous situation, which, if not avoided, could
result in death or serious injury, and includes hazards that are exposed when guards are removed. It
may also be used to alert against unsafe practices.
CAUTION (yellow) indicates a potentially hazardous situation, which, if not avoided, may result
in minor or moderate injury. It may also be used to alert against unsafe practices.
OBSERVE SAFE OPERATING PRACTICES
Carefully read this manual and all safety decals on your equipment. Safety decals
must be kept in good condition. Replace missing or damaged safety decals free of
charge by contacting Sukup Manufacturing Co. by mail at PO Box 677, Sheffield,
Iowa 50475; by phone at 641-892-4222; or by e-mail at [email protected].
It is the responsibility of the owner/operator to know what specific requirements,
precautions, and work hazards exist.
It is also the responsibility of the
owner/operator to inform anyone operating or working in the area of this
equipment of the hazards and the safety precautions that need to be taken to
avoid personal injury or death.
Do not modify or redesign this product without first obtaining written approval from Sukup Mfg Co.
Unauthorized modifications may impair the function and/or safety of the equipment, and affect service life.
EMERGENCIES - KNOW WHAT TO DO
Have emergency numbers and written directions to your location near your telephone in case of
emergency. An area for emergency phone numbers to be recorded has been provided below.
Ambulance Service: ______________________
Doctor: _________________________________
Emergency Medical Squad: ________________
Fire Department: _________________________
Hospital: _______________________________
911 Address: ____________________________
Written Directions to Your Location: ________
_______________________________________
4
Safety Section
WARNING: TO PREVENT EXPLOSION OR FIRE
• Carefully review operator's manual.
• Keep dryer clean inside and out, as fines may cause a fire.
• Check for gas leaks, (spray soapy solution on piping and joints.)
• Run fan at least a half minute before starting heater.
• NEVER start heater if you smell gas or hear a hissing sound.
• NEVER run heater with inspection door open.
Failure to heed these warnings may cause serious injury or death.
WARNING: KEEP CLEAR OF ALL MOVING PARTS
Keep people (ESPECIALLY YOUTH) away from equipment,
particularly during operation. Keep away from all moving
parts. Entanglement can cause serious injury or death. Keep
fan screen guards and all shields in place and in good working
condition. Replacement screen guards and shields are
available from Sukup Mfg. Co. at no charge.
Failure to follow the above precautions may cause serious injury or death.
WARNING: Inspect ladder carefully before use. Never climb
deteriorated, damaged, or improperly assembled ladder components.
Maintain secure hand and foothold when climbing. Metal is slippery
when wet. Never carry items while climbing. Failure to heed these warnings
may cause serious injury or death. Use safety harness and safety line as
required.
CAUTION: Metal edges are sharp. To avoid injuries wear protective clothing and handle
equipment and parts with care.
USE PROPER LOCK OUT PROCEDURES. Facility management needs to proactively train employees to
ensure use of proper lock out procedures while working on the dryer. Management also needs to inspect
this unit for any covers or guards not in the proper place. It is the responsibility of everyone to report any
missing grates, guards, equipment failures, or failures to lock out. Make certain that no cover is removed
unless power is locked out.
NOTE: Refer to the OSHA document 1910.147 App A for a typical minimum lockout procedure.
SAFETY QUESTIONS OR CONCERNS
Please feel free to contact Sukup Mfg Co with any specific safety needs surrounding your tower dryer or
its use!
Remember: Good housekeeping practices and correct safety procedures will help protect lives,
jobs, property and profits.
5
Safety Section
2. Decal L0258A - DANGER: Do not enter this
bin! Keep clear of all augers.
To prevent serious injury or death to all persons
involved in the operation of this equipment, it is
essential that these safety decals be mounted
on your dryer.
Check that all safety decals are in place
according to the decal placement drawing
and in good legible condition when dryer is
installed.
IMPORTANT!! If suggested locations are not
clearly visible, place safety decals in a more
suitable area. Never cover up existing safety
decals.
Make sure location for decal is free from grease,
oil and dirt. Remove backing from decal and
place in proper position. Replace missing or
damaged safety decals or shields free of charge
by contacting Sukup Manufacturing Company,
by mail at PO Box 677, Sheffield, Iowa 50475;
by phone at 641-892-4222; or by e-mail at
[email protected]. Please specify computer
number when ordering.
3. Decal L0520 - CAUTION: Failure to keep unit
clean may cause fire and serious injury or death.
1. Decal L0164 - WARNING: Ladder safety –
falling from heights hazard. Overall precautions
for ladder safety.
4. Decal L0237 - DANGER: Door interlock
switch. Augers are dangerous.
5. Decal L0165 - WARNING:
Electricity; Bleed gas; etc.
6
Disconnect
Safety Section
6. Decal L0284 - WARNING: Keep away from
all moving parts.
7. Decal L0281 - WARNING: To avoid serious
injury or death.
7
TOWER DRYER SAFETY (DECAL PACKET- U99999)
Safety decals should be mounted on your equipment as shown on this page.
L0165
L0237
L0164
L0520
L0281
L0258A
L0284
L0520
L0284
L0281
NEAR
POWER
BOX
L0258A
L0164
L0165
L0237
8