Survey
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
KNIGHT FIRE & SECURITY PRODUCTS LTD Unit 84, Seawall Road Industrial Estate Tremorfa, Cardiff CF24 5TH Tel: 029 2048 8129 Fax: 029 2048 9132 www.knightfireandsecurity.com Description The KFS15 is a Call Point with Microswitch, and LED selectable resistors. The KFS15 is operated by a cam-keyed resettable plate. Fitted with a LED indicator, it is manufactured to BS EN 54-11:2001. Good engineering practice limitations apply. Installation Release the front cover by depressing the 2 tangs on the underside of the control box, using the castellated tip of the key shown alongside Remove the operating plate by lifting upward to compress the springs and ease forward and outward. Use the back box template to mark up and drill fixing holes. Pass cabling through rear entry and fix back box in place. Complete the electrical connections ‘+’ & ‘-‘ terminals to the control box rear. Use the terminals marked ‘LINK’ & choice of LED resistor 470R or 680R. Use the terminals marked IN+ and OUT+ to connect the power to be switched Secure to the back box using the two screws provided. Re-insert the pressure plate cover into the cupped section channels at the upper edge of the control box. Ensure the springs are properly located in the cups and not underneath. Press upward to fully compress the springs and ease over and behind the central lens-retaining tang. Replace front cover to securely lock onto the control box base tangs. To reset, insert the cam-key into the underside of front cover & rotate clockwise until the yellow warning part of the label is hidden. Fixing Template Manual Resettable CallPoint Surface Part Code : KFS15 Type A