Download minimum position actuator interface

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Document related concepts

Electrical substation wikipedia , lookup

Heterodyne wikipedia , lookup

Three-phase electric power wikipedia , lookup

Control system wikipedia , lookup

Flip-flop (electronics) wikipedia , lookup

Current source wikipedia , lookup

Audio power wikipedia , lookup

History of electric power transmission wikipedia , lookup

Phone connector (audio) wikipedia , lookup

Solar micro-inverter wikipedia , lookup

Islanding wikipedia , lookup

Power inverter wikipedia , lookup

Pulse-width modulation wikipedia , lookup

Amplifier wikipedia , lookup

Analog-to-digital converter wikipedia , lookup

Variable-frequency drive wikipedia , lookup

Distribution management system wikipedia , lookup

Surge protector wikipedia , lookup

Stray voltage wikipedia , lookup

Alternating current wikipedia , lookup

Integrating ADC wikipedia , lookup

Rectifier wikipedia , lookup

Resistive opto-isolator wikipedia , lookup

Voltage regulator wikipedia , lookup

Voltage optimisation wikipedia , lookup

Buck converter wikipedia , lookup

Mains electricity wikipedia , lookup

Current mirror wikipedia , lookup

Schmitt trigger wikipedia , lookup

Switched-mode power supply wikipedia , lookup

Opto-isolator wikipedia , lookup

Transcript
ETMP
MINIMUM POSITION ACTUATOR INTERFACE
FEATURES:
♦
Precise Minimum Position Adjustment
♦
Easy Wiring and Installation
♦
30 mA Output Capacity
♦
Output Status Indication
♦
Low Cost, Compact Size.
APPLICATION:
SPECIFICATIONS:
The ETMP board is used to interface actuators,
controlled by DC voltage, with any generic Energy
Management System.
Typical applications include minimum position
adjustment, actuators ‘sequencing’ and boosting of
analog output driving capacity. The board may be
manufactured for a non-standard voltage levels and
used for input/output voltage re-scaling.
Power:
24 VAC, 30 mA
Input:
Factory set ; 0 to 10 VDC (0-20 available)
Output:
Factory set; 0- 10 VDC (0-20 available)
Accuracy: Better than 1.0 % FS.
Indication:
Power supply, output status.
Min. Pos. Adjust: Precision 20 Turn trim -pot.
Mounting:
PC board with snap track TR -2 (2.75” wide); L=1.4”
PRODUCT DESCRIPTION:
The ETMP board provides a convenient way to interface actuators controlled by DC
voltage signal with a generic Energy Management System.
Vout
This single channel board offers precision adjustment of the minimum output signal level.
The output voltage will follow the input only after the pre-set threshold value is exceeded.
The ‘minimum position’ voltage may be adjusted from 0 to the maximum of output rating.
The standard I/O configuration is 10 V input and 10 V output but the board may be
calibrated for any other voltage up to 20 VDC.
Vmin
The ETMP uses 24 VAC/DC excitation. It mounts is a 2.75” wide snap track that is
provided with the board. Output signal and power supply are indicated by LEDs. The
board is equipped with high quality angular connectors for easy and fast wiring.
Vin
ORDERING INFORMATION:
ETMP - standard board, 10 VDC in and 10 VDC out; please contact ELKOR for other I/O
configurations.
ELKOR Technologies Inc.
www.elkor.net
tel.519.652.9959 fax.519.652.1057