# Download Find the Thévenin equivalent circuit at the terminals U, V.

Survey
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Document related concepts

Negative resistance wikipedia, lookup

Index of electronics articles wikipedia, lookup

Integrated circuit wikipedia, lookup

Josephson voltage standard wikipedia, lookup

Immunity-aware programming wikipedia, lookup

CMOS wikipedia, lookup

Test probe wikipedia, lookup

Regenerative circuit wikipedia, lookup

Power electronics wikipedia, lookup

Schmitt trigger wikipedia, lookup

Valve RF amplifier wikipedia, lookup

Switched-mode power supply wikipedia, lookup

Wilson current mirror wikipedia, lookup

Multimeter wikipedia, lookup

Electrical ballast wikipedia, lookup

Operational amplifier wikipedia, lookup

Two-port network wikipedia, lookup

Surge protector wikipedia, lookup

TRIAC wikipedia, lookup

Power MOSFET wikipedia, lookup

Resistive opto-isolator wikipedia, lookup

RLC circuit wikipedia, lookup

Opto-isolator wikipedia, lookup

Rectiverter wikipedia, lookup

Current source wikipedia, lookup

Current mirror wikipedia, lookup

Network analysis (electrical circuits) wikipedia, lookup

Ohm's law wikipedia, lookup

Transcript
Find the Thévenin equivalent circuit at the terminals U, V.
Note that we have dependent sources exclusively here.
Therefore, we can’t use the lookback method to find Thévenin resistance.
Since we have no independent sources, the circuit is purely resistive and Vt = 0.
Finally, we must use an external circuit to activate our circuit to find Vr.
This circuit is equivalent to a single resistor between U and V.
Applying a 1V test voltage causes a current Irt through Rt.
By Ohm’s law, the voltage is Rt * It.
So the Thévenin ressitance is the reciprocal of Irt.
Begin by applying a 1V source and arranging the current according to passive sign
convention.
So it should enter the terminal associated with the positive voltage.
This means that Va is 1V, so our left dependent source is 2 V.
We want the current that flows through this mesh, specifically current Ib.
Write a KVL equation around the mesh.
Gather like terms, gather constants on the right side, and solve for Ib.
We get Ib = 52.6 mA.
Ib becomes a known value.
The current through the 20 Ω resistor is also known since it’s V / R by Ohm’s law.
Irt must be the sum of those two currents by KCL.
So Irt is 103 mA.
So Rt is 1 / 103 mA, which is 9.74 Ω.
Related documents