Survey
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Roland GK 13 pin to 1/4 inch guitar adapter cable The following modifications will permit a non-GK equipped guitar to connect to the GR-55 guitar synthesizer. The normal guitar pickup signal is transmitted via pin 7 on the GK 13 pin plug. The added resistors provide a voltage divider to supply +5 vdc to pin 8 which tells the GR-55 that a GK pickup’s volume is set at 10. A thank you is extended to Elantric on Vguitarforums.com for originally providing this information. Install resistors inside J1 DIN13 shell Roland GK 13-pin Male Plug DIN13 Male Plug Internal End View 4 3 2 1 J1 1 – 6 are not used. 243 8 7 6 5 121 12 10 11 9 To ¼” cable signal/tip 1 B String 2 G String 3 D String 4 A String 5 E String 6 Guitar Mag Output +5V 13 e String Synth Vol. NC 243 121 SW1 SW2 +7V Ground Items required: • DIN13 male plug Qty 1 (Digi-Key Part Number CP-1013-ND) • 240 ohm resistor (243 1%) Qty 1 • 120 ohm resistor (121 1%) Qty 1 • 1/4 inch instrument cable Qty 1 8 9 10 11 12 -7V To ¼” cable braid/shield 7 13 Shield DIN13