Download Conga Basics

Conga Basics
By Joseph P. D'Alicandro Jr.
There are a number of different strokes used to create the catchy conga patterns heard in Latin and
swing charts.
Nothing adds to the groove of a rhythm section like a well-played conga part. The variety of sounds and
intricate rhythmic phrases will add depth to the music.
Congas come in three sizes. The smallest drum, usually 11" in diameter, is called a quinto and is placed on
the player’s left. The conga is 11.75" in diameter and is on the right. Some players will add the 12.5" tumba
drum, but the most common setup is to use the quinto and conga. The drums may be placed on a stand or rest
on the floor, although a stand makes it easier to get a good bass sound.
The quinto should be tuned a perfect fourth above the conga, and the tumba should be tuned a minor third
below the conga. Tune the drums in a cross pattern.
Strokes
The most basic conga sound is called an open tone because the drum is allowed to ring after it is hit. The
open sound is played at the edge of the drum using the arm and wrist together with the fingers slightly apart.
Each open stroke should consist of a simple up-and-down motion of the forearm and hand. Make a quick
downward motion with the wrist as the forearm approaches the drum. All four fingers should hit the drum and
immediately come off it so the sound is not muffled.
The bass tone is produced by the palm of the hand pushing into the drumhead. The fingers and thumb are
relatively close together and the wrist bends upward so the drum is struck with the heel of the palm and the
weight of the arm helps produce the sound. The hand should not rebound off the drum as quickly as for the
open sound.
The slap tone is difficult to produce, and it takes quite a bit of practice to get consistent tones. The stroke is
similar to the open sound, but a whip motion with the fingers is added right before the drum is struck. At the
completion of the stroke the hand should be in an inverted V shape. The slap requires more finger strength than
the open and bass tones. Slaps can be open or muted, in which the left hand mutes the drum while the right
hand plays the slap.
The heel and toe strokes are softer filler sounds, played with a rocking motion in the left hand. Heel refers
to the heel of the palm and toe refers to the fingertips. These strokes are played on the far side of the drum.
Patterns
A conga swing pattern can be as simple as open quinto on beat two and open conga on beat four, or it can
be widely embellished. The quinto note on beat two can be changed to a muted slap with a heel right before it,
and the beat four note can be changed to two eighth notes with a toe right before. The same pattern can be used
for rock-style music by playing the eighth notes straight instead of swung.
The gallop pattern is also commonly used in rock charts.
To play the basic Latin
pattern, called the tumbao, the
conga player should
understand the two-measure
clave pattern. It is referred to
as a 3:2 pattern when the
measures are in this order and
a 2:3 pattern when they are
reversed.
The order of the measures
in the clave pattern
determines the order of the
tumbao measures.
It is important for conga
players to listen to
recordings and watch videos
to understand the sounds
required. Although learning
correct technique can be
frustrating, a good conga
sound can be a wonderful
addition to an ensemble.
For performance examples,
click the publications tab on
the author’s website: bigdmusicinc.com.
Joseph P. D'Alicandro Jr.
Joseph P. D’Alicandro Jr. is director of bands at William Penn Middle School in Yardley, Pennsylvania.
He is also the co-author of Percussion Time (C.L. Barnhouse), a collection of music for beginning
percussion ensemble.