Survey
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
TECHNICAL INFORMATION SHEET NUMBER 227- ISSUE 1 392 CE AND NON CE POWER BOARD APRIL 11, 2002 []\ AUTHOR: THOM WARREN ISSUED BY THE APPLICATIONS ENGINEERING DEPARTMENT 392 CE power supply connector There is a slight difference in the wiring between the 392 CE version board (below), and the 392 Non-CE version earlier models. It is very important to distinguish the difference to keep from burning up the board. EUROTHERM CHESSELL RECORDERS 741-F MILLER DRIVE, LEESBURG, VIRGINIA 20175-8993 USA TECHNICAL SUPPORT: 703-669-1359 SALES: 703-669-1342 FAX: 703-669-1300 WWW: HTTP://WWW.EUROTHERM.COM E-MAIL: [email protected] [email protected] On the CE version, which can be identified easily by the J10 connector in the bottom middle of the board, the J8 connector is positioned horizontally. The pin layout follows. The far left pin is the earth ground, the middle pin is neutral, and the far right pin, closest to the fuse, is the line. The Non CE version (below) is identified by the J5 and J6 connectors on the bottom of the board. The power connector is located on the right side of the board as well, but with a different orientation. The position of the connector is vertical to the board and the pin placement is as follows. The top pin is the line voltage. The center pin is the neutral, and the bottom pin is the earth ground.