Download 04a_Your_First_Radio

Technician Licensing Class
Your First Radio
Page 63 to 68
Amateur Radio Technician Class
Element 2 Course Presentation
 ELEMENT 2 SUB-ELEMENTS (Groupings)
• About Ham Radio
• Call Signs
• Control
• Mind the Rules
• Tech Frequencies
 Your First Radio
• Going On The Air!
• Repeaters
• Emergency!
• Weak Signal Propagation
2
Amateur Radio Technician Class
Element 2 Course Presentation
 ELEMENT 2 SUB-ELEMENTS (Groupings)
•
•
•
•
•
•
•
•
•
•
Talk to Outer Space!
Your Computer Goes Ham Digital!
Multi-Mode Radio Excitement
Run Some Interference Protection
Electrons – Go With the Flow!
It’s the Law, per Mr. Ohm!
Go Picture These!
Antennas
Feed Me with Some Good Coax!
Safety First!
3
Your First Radio
•
Quick access to a favorite frequency on your transceiver can
be done by storing the frequency in a memory channel.
T4B4
With a transceiver (HT)
like one of these, you can
hold your ham station in
the palm of your hand.
•
A disadvantage of the "rubber duck" antenna supplied with
most handheld radio transceivers is that it does not transmit or
receive as effectively as a full-sized antenna.
T9A4
4
Your First Radio
•
A good reason not to use a
"rubber duck" antenna inside
your car is that signals can be
significantly weaker than when
it is outside of the vehicle.
T9A7
Modern dual- and tri-band
handheld transceivers like
these have amazing built-in
capabilities that make ham
radio easy, fun, and portable
•
An RF power amplifier
increases the low-power output
from a handheld transceiver.
T7A10
VHF/UHF
Power
Amplifier
5
Your First Radio
•
•
•
•
FM is the type of modulation most commonly used for VHF and
UHF voice repeaters.
T8A9 The approximate bandwidth of a VHF repeater FM phone
signal is between 5 and 15 kHz.
T8A2 FM is the type of modulation most commonly used for VHF
packet radio transmissions.
T4A1 Concerning the microphone connectors on amateur
transceivers, some connectors include push-to-talk and voltages
for powering the microphone.
T8A4
VHF/UHF
Transceiver
Push to talk button
Connector
6
Your First Radio
A set of headphones could be used in place of a regular
speaker to help you copy signals in a noisy area.
T4A2
7
Your First Radio
Preventing voltage fluctuations from reaching sensitive circuits
is a good reason to use a regulated power supply for
communications equipment.
T4A3
MFJ-4125
13.8VDC@22Amp
Jetstream JTPS30M
Regulated Power Supply
8
Your First Radio
SSB is the type of voice modulation most often used for longdistance or weak signal contacts on the VHF and UHF bands.
•
T8A3
•
T8A7
The primary advantage of single sideband over FM for voice
transmissions is that SSB signals have narrower bandwidth.
• SSB uses less bandwidth than FM signals.
•
The sideband normally used for 10 meter HF, VHF and UHF
single-sideband communications is upper sideband.
T8A6
• Upper sideband is always used on VHF & UHF
9
Your First Radio
•
A transverter is a device that takes the output of a low-powered 28
MHz SSB exciter and produces a 222 MHz output signal.
T7A6
Multi-mode radio
Transverter
10 GHz Dish
WB6NOA using a 10
GHz transverter that
down converts the
received signal to
144 MHz into his
weak-signal, multimode radio.
10
Element 2 Technician Class
Question Pool
Your First Radio
Valid July 1, 2010
Through
June 30, 2014
T4B04
What is a way to enable quick access to a
favorite frequency on your transceiver?
A. Enable the CTCSS tones
B. Store the frequency in a memory
channel
C. Disable the CTCSS tones
D. Use the scan mode to select the desired
frequency
T9A04
What is a disadvantage of the "rubber
duck" antenna supplied with most
handheld radio transceivers?
A. It does not transmit or receive as effectively
as a full-sized antenna
B. It transmits a circularly polarized signal
C. If the rubber end cap is lost it will unravel
very quickly
D. All of these choices are correct
T9A07
What is a good reason not to use a "rubber
duck" antenna inside your car?
A. Signals can be significantly weaker than
when it is outside of the vehicle
B. It might cause your radio to overheat
C. The SWR might decrease, decreasing
the signal strength
D. All of these choices are correct
T7A10
A.
B.
C.
D.
What device increases the low-power
output from a handheld transceiver?
A voltage divider
An RF power amplifier
An impedance network
A voltage regulator
T8A04
A.
B.
C.
D.
Which type of modulation is most
commonly used for VHF and UHF
voice repeaters?
AM
SSB
PSK
FM
T8A09
A.
B.
C.
D.
What is the approximate bandwidth of a
VHF repeater FM phone signal?
Less than 500 Hz
About 150 kHz
Between 5 and 15 kHz
Between 50 and 125 kHz
T8A02
A.
B.
C.
D.
What type of modulation is most commonly
used for VHF packet radio transmissions?
FM
SSB
AM
Spread Spectrum
T4A01
Which of the following is true concerning
the microphone connectors on amateur
transceivers?
A. All transceivers use the same
microphone connector type
B. Some connectors include push-to-talk
and voltages for powering the
microphone
C. All transceivers using the same
connector type are wired identically
D. Un-keyed connectors allow any
microphone to be connected
T4A02
A.
B.
C.
D.
What could be used in place of a regular
speaker to help you copy signals in a noisy
area?
A video display
A low pass filter
A set of headphones
A boom microphone
T4A03
Which is a good reason to use a regulated
power supply for communications
equipment?
A. It prevents voltage fluctuations from
reaching sensitive circuits
B. A regulated power supply has FCC
approval
C. A fuse or circuit breaker regulates the
power
D. Power consumption is independent of
load
T8A03
A.
B.
C.
D.
Which type of voice modulation is most
often used for long-distance or weak signal
contacts on the VHF and UHF bands?
FM
AM
SSB
PM
T8A07
What is the primary advantage of single
sideband over FM for voice transmissions?
A. SSB signals are easier to tune
B. SSB signals are less susceptible to
interference
C. SSB signals have narrower bandwidth
D. All of these choices are correct
T8A06
A.
B.
C.
D.
Which sideband is normally used for 10
meter HF, VHF and UHF single-sideband
communications?
Upper sideband
Lower sideband
Suppressed sideband
Inverted sideband
T7A06
A.
B.
C.
D.
What device takes the output of a lowpowered 28 MHz SSB exciter and produces
a 222 MHz output signal?
High-pass filter
Low-pass filter
Transverter
Phase converter