Survey
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Installation Guide Important information: Luster Beam III • Red wire has + polarity while white wire has - polarity to DC 24V PSU. *LED will be damage with reverse polarity. • Do not connect more than 20 feet in a series circuit. • If total Lusterbeam III is more than 2 pcs, divide them equally in parallel connection • To avoid voltage drop issue, lead wire (DC extension) should not be longer than 5m length with wire size >AWG18 • Ensure the current per series connection not exceeding 4A + - A standard length of 1 feet, 2 feet, 3 feet and 4 feet. Semi outdoor version - IP 65 (Do not to direct expose to sun) Outdoor version - IP67 Direct connection: 1st H: High Lumen, L: Low power ~ + PSU Max 20ft in series <4A Max 20ft in series - <4A AC <5m >AWG18 Table 1 1-10V Dimming Connection: Power Supply Unit - Constant Voltage 24VDC Max. no. of length/ PSU 25W 50W 100W 150W Luster Beam III (H) 5 feet 10 feet 21 feet 32 feet Luster Beam III (L) 7 feet 14 feet 28 feet 43 feet B-10A MCB 8 PSU 7 PSU 4 PSU 3 PSU C-10A MCB 12 PSU 10 PSU 6 PSU 5 PSU B-20A MCB C-20A MCB 14 PSU 20 PSU 12 PSU 16 PSU 10 PSU 12 PSU 8 PSU 12 PSU + ~ AC PSU 1st 1-10V (signal) + Signal Converter - - Max 20ft in series <4A + - + Max 20ft in series 1-10V (signal) - + Signal Converter - <4A <5m >AWG18 • Ensure the mounting surface is free from dust and grease. Each linear comes with a pair of swivel brackets. Position the swivel bracket base according to the calculated distrance/pitch. • Secure the swivel bracket base with 2 pieces of M4 countersunk head screws. Latch on the top swivel bracket holder onto the base. Gently push in the LusterBeam III into both side of swivel bracket holder until hear a click sound. • Place the LusterBeam III near head to head to achieve continuous light effect. Angle adjustable swivel bracket able to tilt from 0° to 60° on both sides. Individual luster Beam per group should be tilt in the same angle to avoid uneven brightness issue. • Ensure ALL connection are properly done before switching on the power. Allow 5 min to discharge the PSU if power supply is on without the load. *LED will burn for any hot plug connection. Disclaimer: Aristo Engineering disclaim liabilty for any direct/ indirect damage in case of improper installation or not performed by a professional electrician. M4 screw Cable tie 0° 30° 60°