7 Series FPGAs PCB Design Guide (UG483)
... consequential loss or damage (including loss of data, profits, goodwill, or any type of loss or damage suffered as a result of any action brought by a third party) even if such damage or loss was reasonably foreseeable or Xilinx had been advised of the possibility of the same. Xilinx assumes no obli ...
... consequential loss or damage (including loss of data, profits, goodwill, or any type of loss or damage suffered as a result of any action brought by a third party) even if such damage or loss was reasonably foreseeable or Xilinx had been advised of the possibility of the same. Xilinx assumes no obli ...
DRM086, Sensorless BLDC Motor Control Using MC9S08AW60
... The brushless DC motor (BLDC motor) is a rotating electric machine with a classic 3-phase stator like an induction motor; the rotor has surface-mounted permanent magnets. It is also referred to as an electronically commuted motor. There are no brushes on the rotor, and the commutation is performed e ...
... The brushless DC motor (BLDC motor) is a rotating electric machine with a classic 3-phase stator like an induction motor; the rotor has surface-mounted permanent magnets. It is also referred to as an electronically commuted motor. There are no brushes on the rotor, and the commutation is performed e ...
Magnum VS 50 Magnum VS 100 -48 Vdc Power Systems User Manual
... 2.3. AC POWER CONNECTIONS ..............................................................................................................................10 AC Connections................................................................................................................................... ...
... 2.3. AC POWER CONNECTIONS ..............................................................................................................................10 AC Connections................................................................................................................................... ...
Kollmorgen S600 Servo Drive Instruction Manual S601-620
... Connection to stepper motor controllers (step and direction) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8.12.5.1 Step/Direction with 5 V signal level (X5) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8.12.5.2 Step/Direction with 24 ...
... Connection to stepper motor controllers (step and direction) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8.12.5.1 Step/Direction with 5 V signal level (X5) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8.12.5.2 Step/Direction with 24 ...
NOTES Tech Std H Applied Electronics
... switching ON the central heating at 20 °C). Changes in the resistance of an input transducer must be converted to changes in voltage before the signal can be processed. This is normally done by using a voltage divider circuit. Vcc cc R ...
... switching ON the central heating at 20 °C). Changes in the resistance of an input transducer must be converted to changes in voltage before the signal can be processed. This is normally done by using a voltage divider circuit. Vcc cc R ...
wassenaar-arrangement-control-list-of-dual-use-goods-and
... status of the equipment in which the integrated circuits will be used is unknown to the manufacturer, having any of the following: a. More than 1,500 terminals; b. A typical "basic gate propagation delay time" of less than 0.02 ns; or c. An operating frequency exceeding 3 GHz; 11. Digital integrated ...
... status of the equipment in which the integrated circuits will be used is unknown to the manufacturer, having any of the following: a. More than 1,500 terminals; b. A typical "basic gate propagation delay time" of less than 0.02 ns; or c. An operating frequency exceeding 3 GHz; 11. Digital integrated ...
Digitax ST Tech Data Iss2.book
... products throughout their life cycle. To this end, we operate an Environmental Management System (EMS) which is certified to the International Standard ISO 14001. Further information on the EMS, our Environmental Policy and other relevant information is available on request, or can be found at www.g ...
... products throughout their life cycle. To this end, we operate an Environmental Management System (EMS) which is certified to the International Standard ISO 14001. Further information on the EMS, our Environmental Policy and other relevant information is available on request, or can be found at www.g ...
DC Motors and Generators Unit 2
... In the first part of the exercise, you will set up the equipment in the Workstation, connect the equipment as shown in Figure 2-14, and make the appropriate settings on the equipment. In the second part of the exercise, you will measure the armature resistance ܴ of the DC Motor/Generator. It is not ...
... In the first part of the exercise, you will set up the equipment in the Workstation, connect the equipment as shown in Figure 2-14, and make the appropriate settings on the equipment. In the second part of the exercise, you will measure the armature resistance ܴ of the DC Motor/Generator. It is not ...
1.05 GHz MEMS Oscillator Based On Lateral-Field
... contour-mode resonators. The oscillator shows a phase noise level of –81 dBc/Hz at 1 kHz offset frequency and a phase noise floor of –146 dBc/Hz, which satisfies the GSM requirements of Ultra High Frequency (UHF) local oscillators (LO). The circuit was fabricated in the AMIS 0.5 μm CMOS process, wit ...
... contour-mode resonators. The oscillator shows a phase noise level of –81 dBc/Hz at 1 kHz offset frequency and a phase noise floor of –146 dBc/Hz, which satisfies the GSM requirements of Ultra High Frequency (UHF) local oscillators (LO). The circuit was fabricated in the AMIS 0.5 μm CMOS process, wit ...
Fuse Selection Guide
... the fuse to clear quickly. DC power on the other hand doesn’t oscillate so the fuse must find other means to clear itself when opening. Because of these differences, some fuses are designed specifically to be used in DC applications (such as automotive fuses). Some AC rated fuses may be used in DC a ...
... the fuse to clear quickly. DC power on the other hand doesn’t oscillate so the fuse must find other means to clear itself when opening. Because of these differences, some fuses are designed specifically to be used in DC applications (such as automotive fuses). Some AC rated fuses may be used in DC a ...
LTM4611 - Ultralow VIN, 15A DC/DC uModule Regulator
... The LTM®4611 is a high density 15A output, switch mode DC/DC buck converter power supply capable of operating from very low voltage input supplies. Included in the package are the buck switching controller, power FETs, inductor and loop-compensation components. The LTM4611 delivers up to 15A continu ...
... The LTM®4611 is a high density 15A output, switch mode DC/DC buck converter power supply capable of operating from very low voltage input supplies. Included in the package are the buck switching controller, power FETs, inductor and loop-compensation components. The LTM4611 delivers up to 15A continu ...
nSP5 PCD - Acuity Support
... a 3-wire dimming ballasts. All versions have an internal latching relay that switches the loads (see electrical specifications). Note, that in order to function the nSP5 PCD must be connected as part of an adequately powered nLight zone as the unit does not power itself from the line voltage it is s ...
... a 3-wire dimming ballasts. All versions have an internal latching relay that switches the loads (see electrical specifications). Note, that in order to function the nSP5 PCD must be connected as part of an adequately powered nLight zone as the unit does not power itself from the line voltage it is s ...
Clamp-On AC Ammeter
... by their line-to-line voltage. This voltage is higher than the line (or phase) to ground voltage. To determine if a line-to-line 3-phase voltage exceeds the rating of this multimeter, multiply the rated line-to-ground voltage by 1.732 (the square root of 3). For example, if the rated line-to-ground ...
... by their line-to-line voltage. This voltage is higher than the line (or phase) to ground voltage. To determine if a line-to-line 3-phase voltage exceeds the rating of this multimeter, multiply the rated line-to-ground voltage by 1.732 (the square root of 3). For example, if the rated line-to-ground ...
Ten-Tec 1254 Manual
... Electronic kit-building has changed dramatically during the 50 years since TEN-TEC's founder (Al Kahn, K4FW) gave a boxcar loaded with war surplus parts to some friends who started a company which became known as Heathkit™, so, the several generations of "the hams at TENTEC" are very aware of the s ...
... Electronic kit-building has changed dramatically during the 50 years since TEN-TEC's founder (Al Kahn, K4FW) gave a boxcar loaded with war surplus parts to some friends who started a company which became known as Heathkit™, so, the several generations of "the hams at TENTEC" are very aware of the s ...
AlphaNet DSM3 Series DOCSIS® Status Monitor
... Review the drawings and illustrations contained in this manual before proceeding. If there are any questions regarding the safe installation or operation of the system, contact Alpha Technologies or the nearest Alpha representative. Save this document for future reference. To reduce the risk of inju ...
... Review the drawings and illustrations contained in this manual before proceeding. If there are any questions regarding the safe installation or operation of the system, contact Alpha Technologies or the nearest Alpha representative. Save this document for future reference. To reduce the risk of inju ...
Gerhard Mercator Universität Gesamthochschule Duisburg
... The Fachgebiet Optoelektronik at the Gerhard-Mercator-Universität Duisburg has a tradition of research and teaching excellence dating back to its establishment in 1989/90. This Report provides a summary of major research involvements and teaching activities reviewing also publications and presenta ...
... The Fachgebiet Optoelektronik at the Gerhard-Mercator-Universität Duisburg has a tradition of research and teaching excellence dating back to its establishment in 1989/90. This Report provides a summary of major research involvements and teaching activities reviewing also publications and presenta ...