 
									
								
									repetitive current controller for grid
									
... Currently, most grid-connected inverters adopt the VSI topology with a current controller to regulate the current injected into the grid by using schemes Proportional-integral (PI) controllers in the synchronously rotating (d, q) reference frame: works well with balanced systems, but cannot cope wit ...
                        	... Currently, most grid-connected inverters adopt the VSI topology with a current controller to regulate the current injected into the grid by using schemes Proportional-integral (PI) controllers in the synchronously rotating (d, q) reference frame: works well with balanced systems, but cannot cope wit ...
									High Voltage Solar Inverter System GUI Overview
									
... control card. If the LED is flashes every second then continue to do the next steps. Otherwise, check the auxiliary power, the control card jumper configuration for boot from flash, or reload the program. At this point, the LED LD2 on the DC-DC EVM should start flashing, indicating the communication ...
                        	... control card. If the LED is flashes every second then continue to do the next steps. Otherwise, check the auxiliary power, the control card jumper configuration for boot from flash, or reload the program. At this point, the LED LD2 on the DC-DC EVM should start flashing, indicating the communication ...
									Word
									
... C57.12.28™-2014 standard. The exterior of the unit shall be painted ANSI® 61 or ANSI® 70 gray. If a special paint color is required, a federal spec number or paint chip must be provided at the time of order. ...
                        	... C57.12.28™-2014 standard. The exterior of the unit shall be painted ANSI® 61 or ANSI® 70 gray. If a special paint color is required, a federal spec number or paint chip must be provided at the time of order. ...
									Drive Solutions for the Global Cement Industry
									
... making is a thermal and a chemical process, both air volume and mass flow must be controlled. The process control system continuously monitors process conditions such as inlet air temperature, kiln feed, cement composition, and required fuelair ratio. The process control system then directs the blowe ...
                        	... making is a thermal and a chemical process, both air volume and mass flow must be controlled. The process control system continuously monitors process conditions such as inlet air temperature, kiln feed, cement composition, and required fuelair ratio. The process control system then directs the blowe ...
									2.5-V Integrated Reference Circuit (Rev. N)
									
... replacement for the LM136-2.5, which eliminates the external trim network. The LT1009 uses include 5-V system references, 8-bit analog-to-digital converter (ADC) and digital-to-analog converter (DAC) references, and power-supply monitors. The device also can be used in applications such as digital v ...
                        	... replacement for the LM136-2.5, which eliminates the external trim network. The LT1009 uses include 5-V system references, 8-bit analog-to-digital converter (ADC) and digital-to-analog converter (DAC) references, and power-supply monitors. The device also can be used in applications such as digital v ...
									Considerations for Polymer Capacitors in Extreme Environments
									
... MSL Rating: The polymer material used in these capacitors is hygroscopic. For this reason before parts are mounted to a PCB, they should be treated as MSL 3 (or higher) components. Parts that are not handled to MSL 3 may “popcorn” during the reflow process, damaging the capacitive element. ...
                        	... MSL Rating: The polymer material used in these capacitors is hygroscopic. For this reason before parts are mounted to a PCB, they should be treated as MSL 3 (or higher) components. Parts that are not handled to MSL 3 may “popcorn” during the reflow process, damaging the capacitive element. ...
									MAX13051 ±80V Fault-Protected Can Transceiver with Autobaud General Description
									
... In slope-control mode, the CANH and CANL outputs are slew-rate limited, minimizing high-frequency EMI, and reducing reflections caused by improperly terminated cables. In multidrop CAN applications, it is important to maintain a direct point-to-point wiring scheme. A single pair of wires should conn ...
                        	... In slope-control mode, the CANH and CANL outputs are slew-rate limited, minimizing high-frequency EMI, and reducing reflections caused by improperly terminated cables. In multidrop CAN applications, it is important to maintain a direct point-to-point wiring scheme. A single pair of wires should conn ...
									Atmel LED Drivers MSL2023 / MSL2024
									
... efficiency optimizer algorithm controls the voltage output of any AC/DC or DC/DC isolated or non-isolated topology, including ultra-low bandwidth single-stage PFC flyback controller. The MSL2023/24 feature peak current control and individual string PWM dimming. The MSL2023 features individual, regis ...
                        	... efficiency optimizer algorithm controls the voltage output of any AC/DC or DC/DC isolated or non-isolated topology, including ultra-low bandwidth single-stage PFC flyback controller. The MSL2023/24 feature peak current control and individual string PWM dimming. The MSL2023 features individual, regis ...
									DC-DC Converter
									
... The maximum required value of Lboundary occurs when D → 0. Therefore, the value of L ...
                        	... The maximum required value of Lboundary occurs when D → 0. Therefore, the value of L ...
									DU-45MV 50/100/200mV DC Full Scale 4 1/2 Digit with 0.56” LEDs
									
... Range values are marked on the PCB. Three positions are provided. After selecting a new range with the single jumper clip, recalibration is required. SPAN Potentiometer (Pot) ...
                        	... Range values are marked on the PCB. Three positions are provided. After selecting a new range with the single jumper clip, recalibration is required. SPAN Potentiometer (Pot) ...
									enclosed meters
									
... The Eaton enclosed meter line provides a complete energy metering and data acquisition solution in a single enclosure. Designed for Eaton’s IQ 35M, IQ 150, IQ 250/260, and Power Xpert® 2000/4000/6000/8000 and Multi-Point Meters, Eaton’s enclosed meter line offers mounting and installation flexibilit ...
                        	... The Eaton enclosed meter line provides a complete energy metering and data acquisition solution in a single enclosure. Designed for Eaton’s IQ 35M, IQ 150, IQ 250/260, and Power Xpert® 2000/4000/6000/8000 and Multi-Point Meters, Eaton’s enclosed meter line offers mounting and installation flexibilit ...
									H8CA-S - OMRON Kft.
									
... When connecting external signal input contacts and transistors, use a power supply having a power transformer whose primary and secondary circuits are isolated from each other with the secondary circuit not grounded, for the input devices, to prevent current feedback and short-circuiting. H8CA-S ...
                        	... When connecting external signal input contacts and transistors, use a power supply having a power transformer whose primary and secondary circuits are isolated from each other with the secondary circuit not grounded, for the input devices, to prevent current feedback and short-circuiting. H8CA-S ...
									Pignose G40V 40w Tube Amp
									
... leg of the resistor closest to the controls board before the resistor is soldered to the main board. R19 is the resistor immediately to the right of the treble cap C12, which has wires soldered to both leads for the switch. The on-board values I chose are a 250pF mica treble cap and a 68k slope resi ...
                        	... leg of the resistor closest to the controls board before the resistor is soldered to the main board. R19 is the resistor immediately to the right of the treble cap C12, which has wires soldered to both leads for the switch. The on-board values I chose are a 250pF mica treble cap and a 68k slope resi ...
									WT 1600 Total Solution Numerical, Waveform, and Trend Displays
									
... Current and power DC accuracy (5 A input element) -----Add 20 µA to current and 20 µA × (voltage reading) to power Current and power DC accuracy (50 A input element) -----Add 1 mA to current and 1 mA × (voltage reading) to power External input -----Add (0.05/scaling value) A to current and (0.05/sca ...
                        	... Current and power DC accuracy (5 A input element) -----Add 20 µA to current and 20 µA × (voltage reading) to power Current and power DC accuracy (50 A input element) -----Add 1 mA to current and 1 mA × (voltage reading) to power External input -----Add (0.05/scaling value) A to current and (0.05/sca ...
									MAX9100/MAX9101 +1.0V Micropower SOT23 Comparators General Description ____________________________Features
									
... Note 1: All specifications are 100% production tested at TA = +25°C. All temperature limits are guaranteed by design. Note 2: Operation with VCM up to VCC is possible with reduced accuracy. See the Input Stage Circuitry and Rail-to-Rail Operation section. Note 3: Tested over the specified Input Comm ...
                        	... Note 1: All specifications are 100% production tested at TA = +25°C. All temperature limits are guaranteed by design. Note 2: Operation with VCM up to VCC is possible with reduced accuracy. See the Input Stage Circuitry and Rail-to-Rail Operation section. Note 3: Tested over the specified Input Comm ...
									LT5527 - 400MHz to 3.7GHz High Signal Level Downconverting Mixer.
									
... transformer, which has low DC resistance to ground. If the RF source is not DC blocked, then a series blocking capacitor must be used. The RF input is internally matched from 1.7GHz to 3GHz. Operation down to 400MHz or up to 3700MHz is possible with simple external matching. ...
                        	... transformer, which has low DC resistance to ground. If the RF source is not DC blocked, then a series blocking capacitor must be used. The RF input is internally matched from 1.7GHz to 3GHz. Operation down to 400MHz or up to 3700MHz is possible with simple external matching. ...
Rectifier
 
                        A rectifier is an electrical device that converts alternating current (AC), which periodically reverses direction, to direct current (DC), which flows in only one direction. The process is known as rectification. Physically, rectifiers take a number of forms, including vacuum tube diodes, mercury-arc valves, copper and selenium oxide rectifiers, semiconductor diodes, silicon-controlled rectifiers and other silicon-based semiconductor switches. Historically, even synchronous electromechanical switches and motors have been used. Early radio receivers, called crystal radios, used a ""cat's whisker"" of fine wire pressing on a crystal of galena (lead sulfide) to serve as a point-contact rectifier or ""crystal detector"".Rectifiers have many uses, but are often found serving as components of DC power supplies and high-voltage direct current power transmission systems. Rectification may serve in roles other than to generate direct current for use as a source of power. As noted, detectors of radio signals serve as rectifiers. In gas heating systems flame rectification is used to detect presence of a flame.Because of the alternating nature of the input AC sine wave, the process of rectification alone produces a DC current that, though unidirectional, consists of pulses of current. Many applications of rectifiers, such as power supplies for radio, television and computer equipment, require a steady constant DC current (as would be produced by a battery). In these applications the output of the rectifier is smoothed by an electronic filter (usually a capacitor) to produce a steady current.More complex circuitry that performs the opposite function, converting DC to AC, is called an inverter.
 
									 
									 
									 
									 
									 
									 
									 
									 
									 
									 
									 
									 
									 
									 
									 
									 
									 
									 
									 
									 
									 
									 
									