TPS5130 数据资料 dataSheet 下载
... synchronous buck regulator controllers (SBRC) and one low drop-out (LDO) regulator controller. On-chip high-side and low-side synchronous rectifier drivers are integrated to drive less expensive N-channel MOSFETs. The LDO controller can also drive an external N-channel MOSFET. Since the input curren ...
... synchronous buck regulator controllers (SBRC) and one low drop-out (LDO) regulator controller. On-chip high-side and low-side synchronous rectifier drivers are integrated to drive less expensive N-channel MOSFETs. The LDO controller can also drive an external N-channel MOSFET. Since the input curren ...
Chap006-2011
... NMOS Saturated Load Inverter Design Strategy • Given VDD, VL, and the power level, find IDD from VDD and power • Assume MS off, and find high output voltage level VH • Use the value of VH for the gate voltage of MS and calculate (W/L)S of the switching transistor based on the design values of IDD a ...
... NMOS Saturated Load Inverter Design Strategy • Given VDD, VL, and the power level, find IDD from VDD and power • Assume MS off, and find high output voltage level VH • Use the value of VH for the gate voltage of MS and calculate (W/L)S of the switching transistor based on the design values of IDD a ...
TANGO PCIe | Operating Manual
... ● Only devices, which have been released for this purpose by Märzhäuser Wetzlar, may be connected. Non-compliance can cause damage to the Controller or to the connected device. Accessories such as joystick, hand wheel, track ball, wiring sets in the PC, connecting leads exterior of the PC, etc. are ...
... ● Only devices, which have been released for this purpose by Märzhäuser Wetzlar, may be connected. Non-compliance can cause damage to the Controller or to the connected device. Accessories such as joystick, hand wheel, track ball, wiring sets in the PC, connecting leads exterior of the PC, etc. are ...
73S8014RN Smart Card Interface DATA SHEET
... 6kV ESD protection on the card interface Package: SO 20-pin RoHS compliant (6/6) lead-free package ...
... 6kV ESD protection on the card interface Package: SO 20-pin RoHS compliant (6/6) lead-free package ...
Exeltech User Manual - Alternative Energy, Inc.
... specify these products is in Watts (W), which is power the inverter can actually deliver. If Exeltech inverters were specified in VA, Our 1100 Watt inverter could be rated at 1375 VA at .8 power factor, 1570 VA @ .7 pf, or an incredible 2200 VA @ .5 pf. It is confusing to specify a product in VA, be ...
... specify these products is in Watts (W), which is power the inverter can actually deliver. If Exeltech inverters were specified in VA, Our 1100 Watt inverter could be rated at 1375 VA at .8 power factor, 1570 VA @ .7 pf, or an incredible 2200 VA @ .5 pf. It is confusing to specify a product in VA, be ...
What Now??? - UCF Physics
... The switch in Figure P32.52 is connected to point a for a long time. After the switch is thrown to point b, what are (a) the frequency of oscillation of the LC circuit, (b) the maximum charge that appears on the capacitor, (c) the maximum current in the inductor, and (d) the total energy the circuit ...
... The switch in Figure P32.52 is connected to point a for a long time. After the switch is thrown to point b, what are (a) the frequency of oscillation of the LC circuit, (b) the maximum charge that appears on the capacitor, (c) the maximum current in the inductor, and (d) the total energy the circuit ...
ABSTRACT Title of Document:
... and systems intentionally from high power microwave (HPM) sources or unintentionally due to the proximity to general electromagnetic (EM) environments, and cause “soft” reversible upsets and “hard” irreversible failures. As scaling-down of device feature size and bias voltage progresses, the circuit ...
... and systems intentionally from high power microwave (HPM) sources or unintentionally due to the proximity to general electromagnetic (EM) environments, and cause “soft” reversible upsets and “hard” irreversible failures. As scaling-down of device feature size and bias voltage progresses, the circuit ...
Capacitor
... Whereas the resistor behaves all the “same” in AC or DC regimes, the capacitor doesn't - a capacitor will in general not conduct DC current, so it's influence becomes obvious only in AC and signal regime. ...
... Whereas the resistor behaves all the “same” in AC or DC regimes, the capacitor doesn't - a capacitor will in general not conduct DC current, so it's influence becomes obvious only in AC and signal regime. ...
Behavior-Based Robotics
... • Any time dependent physical quantity • Constant – DC, Variable - AC • Electrical, Optical, Mechanical ...
... • Any time dependent physical quantity • Constant – DC, Variable - AC • Electrical, Optical, Mechanical ...
IL3285, IL3222 - NVE Corporation
... Skew limit is the maximum difference in any two channels in one device. The power-off measurement in ANSI Standard EIA/TIA-422-B applies to disabled outputs only and is not applied to combined inputs and outputs. All typical values are at VDD1, VDD2 = 5 V or VDD1= 3.3 V and TA = 25°C. While −7 V < V ...
... Skew limit is the maximum difference in any two channels in one device. The power-off measurement in ANSI Standard EIA/TIA-422-B applies to disabled outputs only and is not applied to combined inputs and outputs. All typical values are at VDD1, VDD2 = 5 V or VDD1= 3.3 V and TA = 25°C. While −7 V < V ...
The Comparison of the Input Impedance
... The input impedance of the switched mode power supplies (SMPS) is essential in its power line electromagnetic interference (EMI) filter design, and when ignored, the system may be not meet EMI regulation. To meet EMI regulation, the EMI filters are one of the most popular applied by industries to su ...
... The input impedance of the switched mode power supplies (SMPS) is essential in its power line electromagnetic interference (EMI) filter design, and when ignored, the system may be not meet EMI regulation. To meet EMI regulation, the EMI filters are one of the most popular applied by industries to su ...
MAX1480A/B/C/MAX1490A/B Complete, Isolated RS-485/RS-422 Data Interface _________________General Description
... error-free data transmission at data rates up to 250kbps. The MAX1480A/MAX1490A driver slew rate is not limited, allowing transmission rates up to 2.5Mbps. The MAX1480A/B/C are designed for half-duplex communication, while the MAX1490A/B feature full-duplex communication. Drivers are short-circuit c ...
... error-free data transmission at data rates up to 250kbps. The MAX1480A/MAX1490A driver slew rate is not limited, allowing transmission rates up to 2.5Mbps. The MAX1480A/B/C are designed for half-duplex communication, while the MAX1490A/B feature full-duplex communication. Drivers are short-circuit c ...
1. Resistors - Wikimedia Commons
... A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. Resistors act to reduce current flow, and, at the same time, act to lower voltage levels within circuits. In electronic circuits resistors are used to limit current flow, to adjust sig ...
... A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. Resistors act to reduce current flow, and, at the same time, act to lower voltage levels within circuits. In electronic circuits resistors are used to limit current flow, to adjust sig ...
74HCT9046A 1. General description PLL with band gap controlled VCO
... When the frequency of SIG_IN is higher than that of COMP_IN, the source output driver is held ‘ON’ for most of the input signal cycle time and for the remainder of the cycle time both drivers are ‘OFF’ (3-state). If the SIG_IN frequency is lower than the COMP_IN frequency, then it is the sink driver ...
... When the frequency of SIG_IN is higher than that of COMP_IN, the source output driver is held ‘ON’ for most of the input signal cycle time and for the remainder of the cycle time both drivers are ‘OFF’ (3-state). If the SIG_IN frequency is lower than the COMP_IN frequency, then it is the sink driver ...
ADCMP361 数据手册DataSheet 下载
... The comparator input is limited to the maximum VDD voltage range. The voltage on these inputs can be above VDD but never above the maximum allowed VDD voltage. When adding a resistor string to the input, care must be taken when choosing resistor values. This is due to the fact that the input bias cu ...
... The comparator input is limited to the maximum VDD voltage range. The voltage on these inputs can be above VDD but never above the maximum allowed VDD voltage. When adding a resistor string to the input, care must be taken when choosing resistor values. This is due to the fact that the input bias cu ...
DS1832 3.3-Volt MicroMonitor Chip FEATURES PIN ASSIGNMENT
... on the ST input pin prior to timeout, the watchdog timer is reset and begins to timeout again. If the watchdog timer is allowed to timeout, then the RST and RST signals are driven active for a minimum of 250 ms. The ST input can be derived from many microprocessor outputs. The most typical signals u ...
... on the ST input pin prior to timeout, the watchdog timer is reset and begins to timeout again. If the watchdog timer is allowed to timeout, then the RST and RST signals are driven active for a minimum of 250 ms. The ST input can be derived from many microprocessor outputs. The most typical signals u ...
14-Bit, 80 MSPS, A/D Converter AD9444 FEATURES
... The AD9444 is a 14-bit monolithic, sampling analog-to-digital converter (ADC) with an on-chip, track-and-hold circuit and is optimized for power, small size, and ease of use. The product operates at up to an 80 MSPS conversion rate and is optimized for multicarrier, multimode receivers, such as thos ...
... The AD9444 is a 14-bit monolithic, sampling analog-to-digital converter (ADC) with an on-chip, track-and-hold circuit and is optimized for power, small size, and ease of use. The product operates at up to an 80 MSPS conversion rate and is optimized for multicarrier, multimode receivers, such as thos ...
Sample Assessment Materials
... There is a line of reasoning which is partially coherent, supported by some evidence and with some structure. Mainly relevant information is included in the response but there may be some minor errors or the inclusion of some information not relevant to the argument. ...
... There is a line of reasoning which is partially coherent, supported by some evidence and with some structure. Mainly relevant information is included in the response but there may be some minor errors or the inclusion of some information not relevant to the argument. ...