• Study Resource
  • Explore Categories
    • Arts & Humanities
    • Business
    • Engineering & Technology
    • Foreign Language
    • History
    • Math
    • Science
    • Social Science

    Top subcategories

    • Advanced Math
    • Algebra
    • Basic Math
    • Calculus
    • Geometry
    • Linear Algebra
    • Pre-Algebra
    • Pre-Calculus
    • Statistics And Probability
    • Trigonometry
    • other →

    Top subcategories

    • Astronomy
    • Astrophysics
    • Biology
    • Chemistry
    • Earth Science
    • Environmental Science
    • Health Science
    • Physics
    • other →

    Top subcategories

    • Anthropology
    • Law
    • Political Science
    • Psychology
    • Sociology
    • other →

    Top subcategories

    • Accounting
    • Economics
    • Finance
    • Management
    • other →

    Top subcategories

    • Aerospace Engineering
    • Bioengineering
    • Chemical Engineering
    • Civil Engineering
    • Computer Science
    • Electrical Engineering
    • Industrial Engineering
    • Mechanical Engineering
    • Web Design
    • other →

    Top subcategories

    • Architecture
    • Communications
    • English
    • Gender Studies
    • Music
    • Performing Arts
    • Philosophy
    • Religious Studies
    • Writing
    • other →

    Top subcategories

    • Ancient History
    • European History
    • US History
    • World History
    • other →

    Top subcategories

    • Croatian
    • Czech
    • Finnish
    • Greek
    • Hindi
    • Japanese
    • Korean
    • Persian
    • Swedish
    • Turkish
    • other →
 
Profile Documents Logout
Upload
96KB - NZQA
96KB - NZQA

Volume 7, Issue 2, March-April, 2016, pp.59–68, Article ID: IJEET_07_02_007 http://
Volume 7, Issue 2, March-April, 2016, pp.59–68, Article ID: IJEET_07_02_007 http://

... fault bear or endure characteristics. Also there have been some proposals into the application of Neural Networks to ac drives, power electronics including speed estimation etc. This technique provides us a fairly good calculation of speed and is very strong to parameter variations. However, the spe ...
Ohm`s Law - STLCC.edu :: Users` Server
Ohm`s Law - STLCC.edu :: Users` Server

... Connect the voltmeter across the parallel combination of resistors. Turn on both digital meters. Turn on the power supply and take readings as before for applied voltages of 2, 4, 6, 8 and 10 volts. Record these values on the given data table. Turn off the digital meters turn the voltage to zero, an ...
SFP Series EOLS-BI1603-29X 34X 36X Series
SFP Series EOLS-BI1603-29X 34X 36X Series

NS RF2192
NS RF2192

ppt
ppt

... S1: All system context is maintained by hardware upon entry and thus provides the lowest waking latency S2: Operating system is responsible for storing and restoring CPU and cache hierarchy context. Upon entry to S2, CPU and cache state are lost S3: Powers down more internal units than S2, but other ...
A Review on Facts Devices in Power System for Stability Analysis
A Review on Facts Devices in Power System for Stability Analysis

... operate and becomes insecure because of increase of power losses in the power system. Optimization is a technique which is used to optimally allocate the FACTS devices like Static Var Compensator (SVC) and Inter Line Power Flow Controller (IPFC) in power system to minimize the power losses, improve ...
Fuji Electric UPS7000HX-T3U (300, 400, and 500kVA) 480V 3
Fuji Electric UPS7000HX-T3U (300, 400, and 500kVA) 480V 3

... Fuji Electric UPS7000HX-T3U (300, 400, and 500kVA) 480V 3-phase 3-wire Uninterruptible Power System (UPS) Engineered Like No Other. For nearly 90 years, Fuji Electric has been manufacturing products for mission critical applications including data centers, power plants, and hospitals. Our breakthrou ...
english - KEK Concept GmbH
english - KEK Concept GmbH

Model 482C05 Four-channel, ICP® Sensor Signal Conditioner
Model 482C05 Four-channel, ICP® Sensor Signal Conditioner

Microwave Integrated Circuits (MIC)
Microwave Integrated Circuits (MIC)

... Dissipate half of the supplied power and the two output ports may not be isolated ...
1 to 8 Channel Precision Power Meter LMG500
1 to 8 Channel Precision Power Meter LMG500

... System to measure current harmonics and flicker emitted by the appliance and their effects onto mains: • harmonics for currents up to 16A in compliance with EN61000-3-2 • harmonics for currents from 16A to 75A in compliance with EN61000-3-12 • flicker (voltage fluctuation) for currents up to 16A i ...
IOSR Journal of Applied Physics (IOSR-JAP)
IOSR Journal of Applied Physics (IOSR-JAP)

... This unit compares two voltage signals and determines which one is greater. The result of the comparison is indicated by the output voltage. If the output op-amp voltage is saturated in the positive direction; the non-inverting input (+) is greater or more positive than the inverting input. If the o ...
Low Voltage Power Distribution LVPD at Balloon-EUSO
Low Voltage Power Distribution LVPD at Balloon-EUSO

Voltage - Electromotive Force
Voltage - Electromotive Force

... between the two ends. In the same way, For electrical current to flow in a wire, it is necessary to have a difference in electrical potential (measured in volts) between the two ends of the wire. A battery is an energy source that provides an electrical difference of potential that is capable of for ...
International System of Units (SI)
International System of Units (SI)

... accuracy, an average of a series of measurements will be taken. The uncertainty of measuring instruments is usually given by two values: uncertainty of reading and uncertainty over the full scale. These two specifications together determine the total measurement uncertainty. These values for the mea ...
Exar 电源Blox 元器件订购手册
Exar 电源Blox 元器件订购手册

... © 2005 Sipex Corporation. All rights reserved. The information presented in this document is believed to be accurate and reliable and may change without notice therefore should not form part of any contract. Sipex, the Sipex logo and PowerBlox are trademarks of Sipex Corporation. All other trademark ...
a grid-connected dual voltage source inverter with
a grid-connected dual voltage source inverter with

HMC392LC4 - Hittite Microwave Corporation
HMC392LC4 - Hittite Microwave Corporation

Wheatstone`s Bridge
Wheatstone`s Bridge

STV 100K Manual - Emerson Industrial Automation
STV 100K Manual - Emerson Industrial Automation

Differences between a voltage balun and a current balun
Differences between a voltage balun and a current balun

... line without experiencing large losses, therefore a BALUN is required to provide an unbalanced to a balanced match. Voltage BALUNS: A voltage BALUN forces voltage potentials equal in amplitude but opposite in sign with reference to ground that is present at its output terminals. A voltage BALUN may ...
Phantom Power Testing
Phantom Power Testing

Investigating Electromagnetic and Acoustic Properties of
Investigating Electromagnetic and Acoustic Properties of

(12AX7) Microphone Preamplifier
(12AX7) Microphone Preamplifier

... it is less sensitive to hum and it is significantly less microphonic. Its noise characteristics roughly match those of the ECC83S. In addition, it has a screen between the two triodes, which is of secondary importance in this application. The base arrangement is also different, with the control grid ...
< 1 ... 200 201 202 203 204 205 206 207 208 ... 316 >

Decibel

The decibel (dB) is a logarithmic unit that expresses the ratio of two values of a physical quantity, often power or intensity. One of these quantities is often a reference value and in this case the decibel expresses the absolute level of the physical quantity. The number of decibels is ten times the logarithm to base 10 of the ratio of two power quantities, or of the ratio of the squares of two field amplitude quantities. One decibel is one tenth of one bel, named in honor of Alexander Graham Bell; however, the bel is seldom used.The definition of the decibel is based on the measurement of power in telephony of the early 20th century in the Bell System in the United States. Today, the unit is used for a wide variety of measurements in science and engineering, most prominently in acoustics, electronics, and control theory. In electronics, the gains of amplifiers, attenuation of signals, and signal-to-noise ratios are often expressed in decibels. The decibel confers a number of advantages, such as the ability to conveniently represent very large or small numbers, and the ability to carry out multiplication of ratios by simple addition and subtraction. By contrast, use of the decibel complicates operations of addition and subtraction.A change in power by a factor of 10 is a 10 dB change. At the half power point an audio circuit or an antenna exhibits an attenuation of 3dB. A change in voltage by a factor of 10 results in a change in power by a factor of 100, which is a 20 dB change. A change in voltage ratio by a factor of two approximately corresponds to a 6 dB change.The decibel symbol is often qualified with a suffix that indicates the reference quantity that has been used or some other property of the quantity being measured. For example, dBm indicates a reference power of one milliwatt, while dBu is referenced to approximately 0.775 volts RMS.In the International System of Quantities, the decibel is defined as a unit of measurement for quantities of type level or level difference, which are defined as the logarithm of the ratio of power- or field-type quantities.
  • studyres.com © 2026
  • DMCA
  • Privacy
  • Terms
  • Report