• Study Resource
  • Explore
    • Arts & Humanities
    • Business
    • Engineering & Technology
    • Foreign Language
    • History
    • Math
    • Science
    • Social Science

    Top subcategories

    • Advanced Math
    • Algebra
    • Basic Math
    • Calculus
    • Geometry
    • Linear Algebra
    • Pre-Algebra
    • Pre-Calculus
    • Statistics And Probability
    • Trigonometry
    • other →

    Top subcategories

    • Astronomy
    • Astrophysics
    • Biology
    • Chemistry
    • Earth Science
    • Environmental Science
    • Health Science
    • Physics
    • other →

    Top subcategories

    • Anthropology
    • Law
    • Political Science
    • Psychology
    • Sociology
    • other →

    Top subcategories

    • Accounting
    • Economics
    • Finance
    • Management
    • other →

    Top subcategories

    • Aerospace Engineering
    • Bioengineering
    • Chemical Engineering
    • Civil Engineering
    • Computer Science
    • Electrical Engineering
    • Industrial Engineering
    • Mechanical Engineering
    • Web Design
    • other →

    Top subcategories

    • Architecture
    • Communications
    • English
    • Gender Studies
    • Music
    • Performing Arts
    • Philosophy
    • Religious Studies
    • Writing
    • other →

    Top subcategories

    • Ancient History
    • European History
    • US History
    • World History
    • other →

    Top subcategories

    • Croatian
    • Czech
    • Finnish
    • Greek
    • Hindi
    • Japanese
    • Korean
    • Persian
    • Swedish
    • Turkish
    • other →
 
Profile Documents Logout
Upload
How to Cheat at Securing Windows 2000 TCP/IP
How to Cheat at Securing Windows 2000 TCP/IP

... functionality for IP networks. Hypertext Transfer Protocol (HTTP) was created to transmit Hypertext Markup Language (HTML) documents over TCP/IP, and was introduced in 1991. It was swiftly absorbed into the TCP/IP protocol suite, in no small part due to its rapid proliferation throughout the Interne ...
An Introduction to TCP/IP
An Introduction to TCP/IP

... 3.1.1 Repeaters and Bridges LANs typically connect computers located in close physical proximity, i.e., all the computers in a building. Repeaters are used to join network segments when the distance spanned causes electrical signals to weaken. Repeaters are basically amplifiers that work at the bit ...
Arch Rock
Arch Rock

... renders some protocols inoperable (e.g. DHCP). Broadcast media can also allow efficient operation of multicast, a core mechanism of IPv6 • Link-layer error recovery often increases end-to-end performance. However, it should be lightweight and need not be perfect, only good enough • Sub-network desig ...
Document
Document

... Other hosts and routers on the WAN do not know T’s existence The LAN does not have its own netid; the hosts in the LAN are assigned unused addresses in the WAN T sends packets from the WAN to the appropriate host in the LAN T accepts packets from the LAN and routes them across WAN to the destination ...
Linux Sockets with TCP/IP communications
Linux Sockets with TCP/IP communications

... // sd is a file descriptor for an open socket // p points to a sockaddr_in structure -- on return will contain info about the source making a connection. // addr_lenp -- on return will contain the length of the source sockaddr_in structure // returns an open file descriptor for a connected socket co ...
ppt - Carnegie Mellon School of Computer Science
ppt - Carnegie Mellon School of Computer Science

... Currently mostly used for traffic engineering and network management. » LSPs can be thought of as “programmable links” that can be set up under software control » on top of a simple, static hardware infrastructure ...
ARP Spoofing Prevention ................................44
ARP Spoofing Prevention ................................44

... The D-Link AirPremier® N wireless access point lets you access your network using a wireless connection from virtually anywhere within the operating range of your wireless network. Keep in mind, however, that the number, thickness and location of walls, ceilings, or other objects that the wireless s ...
User Manual - Axis Communications
User Manual - Axis Communications

... AXIS Q1755/-E offer intelligent capabilities such as the new Gatekeeper functionality, enhanced video motion detection, two-way audio including audio detection and detection of camera tampering attempts like blocking or spray-painting. The camera also provides capacity for third party analytics modu ...
slides
slides

... – A few large data centers with more peering points – Lower cost due to economy of scale More centralized ...
Avaya Data Ports List for Products
Avaya Data Ports List for Products

... device to the correct upper layer application. These ports are logical descriptors (numbers) that help devices multiplex and demultiplex information streams. Consider your desktop PC. Multiple applications may be simultaneously receiving information. In this example, email may use destination TCP po ...
Class Power Points for Chapter #6
Class Power Points for Chapter #6

... 12. Source IP Address - This 32-bit field holds the IP address of the sending computer. It is used to verify correct delivery, and will also be the return address in case an error occurs. 13. IP Options - This field can hold a fair number of optional settings. These settings are primarily used for t ...
Reviewing Traffic Classification - Sites personnels de TELECOM
Reviewing Traffic Classification - Sites personnels de TELECOM

... packets was not an issue whatsoever: protocols were assigned to well-known transportlayer ports by IANA [2]. Therefore, Port-based classification [49, 50, 53] simply extracted such value from the packet header and then look it up in the table containing the port-application associations. Unfortunate ...
Document
Document

... Set up manually, do not change; requires administration Works when traffic predictable & network is simple Used to override some routes set by dynamic algorithm Used to provide default router ...
Optical Networks
Optical Networks

... onto the same optical fiber. Each wavelength is a different channel. At the transmitting end, there are W independent transmitters. Each transmitter Tx is a light source, such as a laser, and is independently modulated with a data stream. The output of each transmitter is an optical signal on a uniq ...
Week_Seven_Network_ppt
Week_Seven_Network_ppt

... A default route of a computer that is participating in computer networking is the packet forwarding rule (route) taking effect when no other route can be determined for a given Internet Protocol (IP) destination address. All packets for destinations not established in the routing table are sent via ...
Network-Layer Protocol Operations
Network-Layer Protocol Operations

... routing path based on distance vectors Balanced Hybrid Routing ...
A Traffic-aware Power Management Protocol for
A Traffic-aware Power Management Protocol for

... sleep mode. Our observation is that in a well connected ad hoc network there are usually many paths existing between a source and a destination, so a percentage (p) of the nodes may be in an energy conserving sleep mode without losing network connectivity. However, putting nodes into a sleep mode ma ...
Do SKU and Network Complexity Drive Inventory Levels?
Do SKU and Network Complexity Drive Inventory Levels?

... Limitations Several factors limit the ability to extend the results of this research: ...
ATM
ATM

...  VCI: VC Identifier, used for routing/switching  Has local significance (unlike IP addresses)  Identifies a segment of a path for a flow (or bundle of flows, called virtual path VP), to simplify switching  May change from one link to another 5: DataLink Layer ...
Managing Data Transfers in Computer Clusters with Orchestra
Managing Data Transfers in Computer Clusters with Orchestra

... we propose a TC that implements an optimized BitTorrent-like protocol called Cornet, augmented by an adaptive clustering algorithm to take advantage of the hierarchical network topology in many datacenters. For shuffle transfers, we propose an optimal algorithm called Weighted Shuffle Scheduling (WS ...
Security and DoS
Security and DoS

... be found to break into a large number of systems, and install a new program on these hosts. After installing the software it has to be able to contact some central location in order to receive commands and maybe even software updates. This control channel would enable the attacker to initiate DDoS a ...
Ex No:1 - Weebly
Ex No:1 - Weebly

... [cse5062@linuxserver ~]$cc dns.c –o c [cse5062@linuxserver ~]$./c www.yahoo.com Host name is www.yahoo-ht3.akadns.net IP address is 87.248.113.14 RESULT: ...
chap05
chap05

... … physical-layer (“dumb”) repeaters:  bits coming in one link go out all other links at same rate  all nodes connected to hub can collide with one another  no frame buffering  no CSMA/CD at hub: host NICs detect collisions twisted pair ...
ch_01_Network_Overview - Faculty Web Hosting
ch_01_Network_Overview - Faculty Web Hosting

... (a) Bluetooth configuration (master-slave paradigm, master determines how long, when and frequency slaves can use) (b) Wireless LAN Computers and printers can connect to the network with a radio communication link. There is usually a (or some) central access point or base station where the radio con ...
Integrate Services Digital Network (ISDN) and SS7
Integrate Services Digital Network (ISDN) and SS7

... Before 1970, only channel-associated signalling (CAS) was used. In CAS systems, signalling always occurs in-band (i.e. over voice channels). ...
< 1 ... 68 69 70 71 72 73 74 75 76 ... 569 >

Network tap

A network tap is a hardware device which provides a way to access the data flowing across a computer network. In many cases, it is desirable for a third party to monitor the traffic between two points in the network. If the network between points A and B consists of a physical cable, a ""network tap"" may be the best way to accomplish this monitoring. The network tap has (at least) three ports: an A port, a B port, and a monitor port. A tap inserted between A and B passes all traffic through unimpeded, but also copies that same data to its monitor port, enabling a third party to listen.Network taps are commonly used for network intrusion detection systems, VoIP recording, network probes, RMON probes, packet sniffers, and other monitoring and collection devices and software that require access to a network segment. Taps are used in security applications because they are non-obtrusive, are not detectable on the network (having no physical or logical address), can deal with full-duplex and non-shared networks, and will usually pass through traffic even if the tap stops working or loses power.
  • studyres.com © 2025
  • DMCA
  • Privacy
  • Terms
  • Report