• Study Resource
  • Explore
    • Arts & Humanities
    • Business
    • Engineering & Technology
    • Foreign Language
    • History
    • Math
    • Science
    • Social Science

    Top subcategories

    • Advanced Math
    • Algebra
    • Basic Math
    • Calculus
    • Geometry
    • Linear Algebra
    • Pre-Algebra
    • Pre-Calculus
    • Statistics And Probability
    • Trigonometry
    • other →

    Top subcategories

    • Astronomy
    • Astrophysics
    • Biology
    • Chemistry
    • Earth Science
    • Environmental Science
    • Health Science
    • Physics
    • other →

    Top subcategories

    • Anthropology
    • Law
    • Political Science
    • Psychology
    • Sociology
    • other →

    Top subcategories

    • Accounting
    • Economics
    • Finance
    • Management
    • other →

    Top subcategories

    • Aerospace Engineering
    • Bioengineering
    • Chemical Engineering
    • Civil Engineering
    • Computer Science
    • Electrical Engineering
    • Industrial Engineering
    • Mechanical Engineering
    • Web Design
    • other →

    Top subcategories

    • Architecture
    • Communications
    • English
    • Gender Studies
    • Music
    • Performing Arts
    • Philosophy
    • Religious Studies
    • Writing
    • other →

    Top subcategories

    • Ancient History
    • European History
    • US History
    • World History
    • other →

    Top subcategories

    • Croatian
    • Czech
    • Finnish
    • Greek
    • Hindi
    • Japanese
    • Korean
    • Persian
    • Swedish
    • Turkish
    • other →
 
Profile Documents Logout
Upload
Pulse Load Handling for Fixed Linear Resistors
Pulse Load Handling for Fixed Linear Resistors

FE3110411050
FE3110411050

... control, a sinusoidal reference signal is compared with the high frequency triangular signal to generate the gate pulses and a controlled A.C. output voltage is obtained by adjusting the pulse width by varying the modulation index. As Cyclo converter is a power frequency changer, the most desirable ...
Chapter 1 Getting Start - Technica-M
Chapter 1 Getting Start - Technica-M

... shipment have been checked for completeness and the instrument has been checked mechanically and electrically. Check the accessories: Accessories supplied with the instrument are listed in "Accessories" in this guide. If the contents are incomplete or damaged, please notify the franchiser. Check the ...
1958-02
1958-02

LTC1065 - DC Accurate, Clock-Tunable Linear Phase 5th Order
LTC1065 - DC Accurate, Clock-Tunable Linear Phase 5th Order

Rotary Phase Converter Data Sheet
Rotary Phase Converter Data Sheet

an investigation of the boost inductor volume applied to pfc converters
an investigation of the boost inductor volume applied to pfc converters

... to attain the compliance with EMI standards, such as the CISPR 22, which recommends maximum levels of conducted and irradiated noise for information’s technology equipments. The earliest studies to achieve the compliance with EMI standards were based in a trial-and-error experimental approach made a ...
MO8009
MO8009

Bat Echolocation: Triangulation Using Ultrasonic
Bat Echolocation: Triangulation Using Ultrasonic

Frequency input signal conditioner
Frequency input signal conditioner

... electronic medium or machine-readable form, in whole or in part, without prior written consent of OMEGA ENGINEERING, INC. It is the policy of OMEGA to comply with all worldwide safety and EMC/EMI regulations that apply. OMEGA is constantly pursuing certification of its products to the European New A ...
1st semester
1st semester

Limiting instabilities in multibunch : review and cures
Limiting instabilities in multibunch : review and cures

39904620
39904620

Document
Document

6 - UoW
6 - UoW

... response capability of the DFIGs. In particular, when rotor speed control is applied to ‘deload’ [7] the WECS and reserve part of the wind power, rotor speed increases above or decreases below the rotor speed at the maximum power point (MPP) and requires a wider speed range. Permanent magnetic synch ...
Application Note AN-1162 Compensator Design Procedure for Buck Converter with Voltage-Mode Error-Amplifier
Application Note AN-1162 Compensator Design Procedure for Buck Converter with Voltage-Mode Error-Amplifier

... frequency can be programmed from 250kHz to above 1.5MHz to provide the capability of optimizing the design in terms of size and performance. In this application note stabilizing the buck converter with voltage-mode error amplifier is discussed. The goal is to highlight the advantage of this control ...
Comparative Measurements on Loudspeaker Distortion: Current vs
Comparative Measurements on Loudspeaker Distortion: Current vs

A new Circuit for Low-Cost Electronic Ballast Passive Valley Fill with
A new Circuit for Low-Cost Electronic Ballast Passive Valley Fill with

SP720, SP721 and SP723 Turn-On and Turn-Off
SP720, SP721 and SP723 Turn-On and Turn-Off

Coded Signals
Coded Signals

... •PCB layout www.helsinki.fi/yliopisto ...
Pdf
Pdf

... electrical domain to magnetic domain to electrical domain; in the induction motor you can have electrical domain to magnetic domain to electrical domain and also to mechanical domain. So we have a system a central call drum or the drum which can which we say is the magnetic domain. So, to this magne ...
ELAB-080 DLL library description
ELAB-080 DLL library description

art%3A10.1007%2Fs10035-015-0599-4
art%3A10.1007%2Fs10035-015-0599-4

A 0.1-to-1.2GHz Tunable 6th-Order N-Path Channel
A 0.1-to-1.2GHz Tunable 6th-Order N-Path Channel

Modulator structures for radio-on
Modulator structures for radio-on

< 1 ... 25 26 27 28 29 30 31 32 33 ... 114 >

Chirp spectrum



The spectrum of a chirp pulse describes its characteristics in terms of its frequency components. This frequency-domain representation is an alternative to the more familiar time-domain waveform, and the two versions are mathematically related by the Fourier transform. The spectrum is of particular interest when pulses are subject to signal processing. For example, when a chirp pulse is compressed by its matched filter, the resulting waveform contains not only a main narrow pulse but, also, a variety of unwanted artifacts many of which are directly attributable to features in the chirp's spectral characteristics. The simplest way to derive the spectrum of a chirp, now computers are widely available, is to sample the time-domain waveform at a frequency well above the Nyquist limit and call up an FFT algorithm to obtain the desired result. As this approach was not an option for the early designers, they resorted to analytic analysis, where possible, or to graphical or approximation methods, otherwise. These early methods still remain helpful, however, as they give additional insight into the behavior and properties of chirps.
  • studyres.com © 2025
  • DMCA
  • Privacy
  • Terms
  • Report