Lab1 - Ece.umd.edu
... The time base is used to adjust the average time at which the samples are taken. It can be adjusted from 5 ns/div to 50 s/div via the large knob in the horizontal control section. The small knob in that section can be used to adjust the “zero (delay) time”, which corresponds to the time the pulse is ...
... The time base is used to adjust the average time at which the samples are taken. It can be adjusted from 5 ns/div to 50 s/div via the large knob in the horizontal control section. The small knob in that section can be used to adjust the “zero (delay) time”, which corresponds to the time the pulse is ...
Stresa, Italy, 25-27 April 2007
... Fig. 11 shows a relation of the clock’s pulse width with the value of the output voltage and CSTORE. The optimum value of the pulse width is around 2 µsec with a value of CSTORE around 2.2 nF. If the pulse width becomes too large, the differential voltage in the inductance becomes negative and with ...
... Fig. 11 shows a relation of the clock’s pulse width with the value of the output voltage and CSTORE. The optimum value of the pulse width is around 2 µsec with a value of CSTORE around 2.2 nF. If the pulse width becomes too large, the differential voltage in the inductance becomes negative and with ...
Optical Theremin Design Review - Sites@PSU
... to acquire the raw analog values. The second DAQ assistant then produces a simulated sine wave based on the input frequency and amplitude signals. Finally, the simulated sine wave is sent to a third DAQ assistant which controls sends the sine wave to the 3.5mm TRS connector on the MyDAQ in the form ...
... to acquire the raw analog values. The second DAQ assistant then produces a simulated sine wave based on the input frequency and amplitude signals. Finally, the simulated sine wave is sent to a third DAQ assistant which controls sends the sine wave to the 3.5mm TRS connector on the MyDAQ in the form ...
Tunable, high-power, solid-state sources for the blue and
... nonlinear crystal is MgO:sPPLT (deff~10 pm/V). It is 30-mm long, contains a single grating (Λ=7.97 µm), and is housed in an oven with a temperature stability of ± 0.1 oC. The crystal faces have antireflection (AR) coating (R<0.5%) for the signal (840-1000 nm), with high transmission (T>98%) for the ...
... nonlinear crystal is MgO:sPPLT (deff~10 pm/V). It is 30-mm long, contains a single grating (Λ=7.97 µm), and is housed in an oven with a temperature stability of ± 0.1 oC. The crystal faces have antireflection (AR) coating (R<0.5%) for the signal (840-1000 nm), with high transmission (T>98%) for the ...
Word - University of California, Berkeley
... How does the resistor affect the timing characteristics (tp, tr, tf)? iv. How would the VTC and timing be affected if another 10.0k resistor was added between the gate output and Gnd? ...
... How does the resistor affect the timing characteristics (tp, tr, tf)? iv. How would the VTC and timing be affected if another 10.0k resistor was added between the gate output and Gnd? ...
... TLP250 is a Toshiba made photo coupler made of GaAiAs Ired LED and two photo transistors with a simple 8 pin DIP package is used as the gate driver. The supply amplitude of the SPWM pulse (Va) should be in the range of -15V to +15V to ensure that the MOSFET work in enhanced mode. This method is empl ...
